SOURCE: 2000 Cadillac Deville DTS is in anti- theft mode
you can reset the system by turning key to on position for 5-10 mins and then try starting it but its probably a short or grounding prob try the engine to chassis ground
SOURCE: 1997 cadillac deville anti theft
This might work for most:
Theft Module Re-learn Procedure without a T5O or T6O
During this procedure, the vehicle battery must maintain a minimum of 10.5 volts. If the battery is not fully charged or is weak, a battery charger may be connected.
NOTE The battery charger must NOT be set in 12 volt boost. This will prevent this procedure from working.
1.
Cycle the ignition switch to the "Run" position.
2.
Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
3.
Cycle the ignition switch to the "Run" position.
4.
Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
5.
Cycle the ignition switch to the "Run" position.
6.
Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
7.
Verify the repair.
and if not try this:
STARTING DISABLED/DUE TO THEFT SYSTEM/REMOVE IGNITION KEY"
If the Powertrain Control Module (PCM) does not receive the Fuel Enable message it will use the class 2 serial data line (CKT 1807) to tell the Instrument Panel Cluster (IPC) to display the "STARTING DISABLED/DUE TO THEFT SYSTEM/REMOVE IGNITION KEY" message on the Driver Information Center (DIC) . This will inform the driver of why the engine is not starting. When the ignition is turned "OFF", the IPC will start a timer and display messages to inform the driver to wait for the PASS-Key II timer to run out. The messages will read "WAIT 3 MINUTES", "WAIT 2 MINUTES" (after 1 minutes has passed), "WAIT 1 MINUTE", and "START CAR".
If the timer was not run out, the IPC will not send the Fuel Enable message. When the PCM does not receive the Fuel Enable message, it will command the IPC to re-start the message process.
This message is most likely caused by an improper key resistor value or the IPC did not properly sense the ignition key resistance.
good luck!
SOURCE: 1996 cadillac deville anti theft
TAKE ONE CADILLAC KEY PLACE IN IGNITION TAKE YOUR SPARE CADILLAC KEY GO UNDER NEATH YOUR DASH BOARD FIND THE ORANGE RUBBERY WIRE PEEL THE TWO WHITE WIRES AND PLACE ONE WIRE TO THE ONE SIDE OF THE KEY AND THE OTHER TO THE OTHERSIDE CRANK YOUR ENGINE AND IT WILL START YOUR CAR
SOURCE: 1994 cadillac deville concours
On my car, which is the same as yours, it is located on the manifold top back left. Pictures in the book just show it on top.
SOURCE: how do u disable a
U can bypass it (called the VATS system) but not fully disable it, what is done mimics the key code to fool the VATS module into sending a OK to start signal to the fuel injection computer (called the ECM). go to the web link below for instructions on the bypass.
http://vats.likeabigdog.com/
194 views
Usually answered in minutes!
×