Question about 2001 Ford Explorer
Code reads po453 high
Posted by Anonymous on
There are a lot of evap sensors. Most are located on the charcoal cannister and on top of the fuel tank uder the vehicle. Do you know what sensor?
Posted on Apr 12, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
May 15, 2017 | Cars & Trucks
Nov 02, 2015 | 2005 Buick Rendezvous
May 01, 2015 | Cars & Trucks
Apr 12, 2015 | 2001 Ford Explorer
Aug 30, 2014 | 2005 Cadillac CTS
Sep 22, 2013 | Cars & Trucks
Sep 05, 2012 | 2007 Ford Explorer Eddie Bauer
Aug 26, 2011 | Pontiac Grand Am Cars & Trucks
Jun 14, 2011 | 1998 Kia Sephia
Evaporative Emissions Control System Pressure Sensor High Input
What does that mean?
The EVAP (Evaporative Emissions) System allows fuel tank vapors to be purged into the engine and burnt rather than expelled into the atmosphere as harmful emissions. The EVAP system contains a pressure sensor to check the integrity of the system. Periodically, the EVAP system performs a pressure test to check that there are no leaks in the system. It uses this sensor, also known as a fuel tank pressure (FTP) sensor to check for leaks. Basically P0453 means the PCM (Powertrain Control Module) noticed the EVAP Pressure sensor or FTP is indicating a higher than normal pressure (above 4.5 Volts) in the EVAP system. NOTE: On some vehicles the FTP is a part of the fuel pump assembly in the tank.
FB.init("dd7d9e9681341cde77587bc6a2029f6f"); OBD-Codes.com on Facebook Potential Symptoms
There will likely be no noticeable symptoms along with this code other than the MIL (Malfunction Indicator Lamp), commonly known as Check Engine Light illumination. However, there may be noticeable fuel odors in some cases.
A P0453 DTC trouble code may be caused by one or more of the following:
Using an scan tool access FTP sensor value with Key on Engine off (KOEO). Normal value is usually somewhere near 2.5 Volts at atmospheric pressure (may fluctuate some due to altitude). It shouldn't ever be above 4.5 Volts.
1) If it is close to 2.7V with the gas cap off, the problem is likely intermittent. Using a Digital Volt Ohm Meter, measure the voltage on the signal wire while trying to induce the problem by wiggle testing all the wiring at the FTP sensor. If the voltage fluctuates when wiggle testing, check for connector problems; i.e. water in the connector, broken or chafed wiring.
2) If the value shown on the scan tool is above 4.5V, unplug the sensor (if possible) and check for voltage again. If the high voltage is still present when unplugged, inspect wiring harness for a short to voltage on the signal wire. If the high voltage disappears when unplugging the sensor, check for a good ground to the sensor and proper reference voltage. If you have a good ground and 5 Volts reference voltage, replace the FTP sensor since it's likely shorted out.
Mar 02, 2011 | Ford Taurus Cars & Trucks
83 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: