Question about 2007 Nissan Altima

1 Answer

Altima 2007 automatic transmission have in problem it don't move out off first gear I carry the car for a scan code 1777 came up this is my email address cardobowe@gmail.com

Posted by Anonymous on

  • paulmacintyre
    paulmacintyre Apr 12, 2015

    This code is for the transmission step motor. It is a solenoid controller that controls transmission fluid pressure. This motor is either no good or there is an electrical issue to the motor. It will not shift as long as this motor has a problem

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 3,218 Answers

This code is for the transmission stepper motor/circuit. It controls fluid pressures using solenoids. It will not shift if there is a problem with this motor or its circuit

Posted on Apr 12, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 422 Answers

SOURCE: automatic transmission. after starting

hi there, no you are not going to need a new transmission. what is happening is probably one or two things. the transmission fluid is low or the transmission control solenoid is acting up. good luck and appreciate your question

Posted on Aug 28, 2008

  • 321 Answers

SOURCE: AUTOMATIC TRANSMISSION GEAR SYSTEM PROBLEM

Yes,that code is a transmission code,pressure control solenoid A.On a Honda trans,there are two solenoids that control line pressure inside the trans.The two of them are made together into one assembly that Honda calls "Linear Solenoids".Most likely they are defective and need replacing,but require testing.They are mounted on the outside of the trans case,so the problem can be repaired without removing the transmission from the car.The actual diagnostic route for that trouble code involves ohms checking the wires from the vehicle computer to the solenoids.Ohms checking the solenoids,amps chekcing the solenoids,and then installing a line pressure gauge on the transmission to test the solenoids mechanically.I rebuild Honda and Acura transmissions on a regular basis,and solenoid failure is not out of the ordinary.Good luck.

Posted on Sep 13, 2008

  • 2 Answers

SOURCE: 2003 nissan altima 2.5s transmission rough shift

Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Posted on Oct 02, 2008

  • 5 Answers

SOURCE: audi a3 1998 automatic transmission cannot shift into gear

if a standard check clutch

Posted on Oct 18, 2008

  • 14036 Answers

SOURCE: Car cannot move forward while engine running

check transmission fluid first.if its low add to get correct level.if transmission fluid look dark smells burnt replace fluid and filter.if car still dont move forward.looks like you have bad worn out forward clutch plates and seals.also bad transmission oil pump.you need a overhaul or new transmission.

Posted on Jan 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

My car is stuck in gear.


Hi.

If we are talking about automatic transmission stuck in park position, then the problem is the solenoid switch that unlocks the gear shift lever when brake pedal is pressed. The switch is located behind the brake pedal.
When the problem is the solenoid the brake lights usually do not work.
A definitive test on the switch is done by jumping the switch contacts to bypass the brake pedal switch.

If the brake pedal switch is not the problem, or if an automatic transmission is stuck in a different gear, then the first step in troubleshooting is scanning the ECU (car computer) for codes. If there is a code P0700 stored, that means that more codes are stored in the TCM (transmission control module). The TCM is the computer module controlling the transaxle, and can be tested at any authorized garage. See: I get code p0700 after an OBDII scan.
There are many possible reasons for automatic transmission malfunctions. Most common reasons (that can also cause lock in one gear) are discussed here:My car does not shift in second gear.
If you are lock in park, check the pedal switch and brake lights as a first thing.

If you have a manual transmission stuck in any gear, it is usually the gear shaft broken or detached from the hub. In that case the gear shaft must be replaced.

on May 25, 2010 | 2007 Mercedes-Benz C230 Sedan

1 Answer

My 2004 nissan altima 2.5 engine automatic transmission wont shift out of 3rd gear. From 1st to 3rd is fine just wont shift to 4


have to onboard computer scanned through the OB2 pport and see what error codes you get if any..

Oct 16, 2014 | Cars & Trucks

1 Answer

Installing shift control valve 2007 nissan altima


check for low fluid level in the gear box.

Apr 12, 2014 | 2007 Nissan Altima 2.5

1 Answer

Automatic battery discharged in Nissan Altima 2005


there is not a separate battery for the transmission, if your cars battery goes dead or is disconnected you can manually unlock the shifter.
if by chance it is stuck and the battery is good you could have a bad brake switch or a bad relay.

Oct 14, 2012 | 2005 Nissan Altima

1 Answer

The RPM of 2007 Nissan Altima stays high when drive over 65 MPH.


It sounds like the trans is not reaching Overdrive final gear, this is controlled by the computer that shifts the transmission. What needs to be done now to see what is keeping it from shifting into OD is have the Transmission control module (TCM) scanned for fault codes by the dealer or a shop that has the correct electronic scanner for reading the TCM.

Feb 12, 2012 | 2007 Nissan Altima 3.5 Sedan

1 Answer

2007 pt cruiser crankz up but wont move in neither gear i tried putting it all gears but the car wouldnt move,can u please help me with this problem thankz


CHECK TRANSMISSION FLUID LEVEL NEED TO DO TRANSMISSION FLUID CHANGE AND FILTER CHANGE,ADJUST BANDS EVERY 15000 MILES INTERVALS. CODE SCAN FOR FAULTY TRANSMISSION FLUID PRESSURE SWITCH OR FAULT IN TRANSMISSION SHIFT SOLENOID.

Jul 08, 2011 | Chrysler PT Cruiser Cars & Trucks

1 Answer

Transmission is stuck in Park... my 2007 X type Jaguar stood quietly for two months while i was away. Now it wont move into gear from Park Engine starts no problem all indicators show no problem, yet gear...


SEE IF BRAKE LIGHTS WORKING.IF NOT CHECK FUSE.BRAKE LIGHT SWITCH HAS TO HAS POWER SO THE BRAKE TRANSMISSION SHIFT INTERLOCK WILL WORK SO YOU CAN SHIFT OUT OF PARK.IF ALL IS GOOD CODE SCAN CAR FOR A ELECTRONIC TRANSMISSION CONTROL UNIT SELECTOR. FAULT CODE.

Feb 03, 2011 | 2007 Jaguar X-Type 3.0 Sedan

1 Answer

The Lanscruiser VX (automatic transmission) is


and this is a 2007?
tell the dealership. you have warranty on the vehicle. they'll fix it.

Jul 14, 2009 | 2007 Toyota Land Cruiser

Not finding what you are looking for?
2007 Nissan Altima Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...