Check for a vacuum leak
Anything else it would be if not that?
×
Could be transmission torque convertor lock up try putting it it neutral before stopping
How would I fix the problem thou?
internal solenoid inside transmission pan should unplug and unbolt after dropping pan
×
Iac idle air control
SOURCE: 2000 Chevrolet Venture multiple codes stalling and rough idle
Look for broke/ shorted wires on Crank sensor.. thanks
SOURCE: when braking for stop 1997 venture stalls sometimes
poss. incorrect computer settings, when responding to throttle don.
SOURCE: stall upon running out of gas but won't start up again with gas
Remove the air cleaner and pour about a quarter cup of gasoline into the carburetor or throttle body. Do not stand near the engine when cranking it -- fire/small explosion hazard.
SOURCE: 2005 chevrolet venture load levelers not working
had the same problem with my ford a few years back, found that the rubber seal on the piston in the compressor had run dry and it was too hard for the compressor to push the piston up and down the bore which cut the power to the compressor and you had to stop the car turn it off for a couple of minutes and restart it and the compressor would pump air for another couple of minutes and stop again.
I solved the problem by replacing the shocks with a pair of pump up shocks that have a valve like a tyre valve and you pump them up at the service station
hope this helps
SOURCE: My keys are locked inside my 2000 chevrolet venture, Is
call onstar!!! just kidding no! the only way now is to use a slim jim(door opening tool) most auto parts sell them for 5 dollars or so unless you have AAA auto club card or know a member they will come out and do it for free sometimes police officers can also help you. hope this helps you.
68 views
Usually answered in minutes!
×