Question about 2001 Isuzu Rodeo

1 Answer

Are 2001 Isuzu Rodeo throttle position under the gas pedal

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 20,706 Answers

Usa car?
look at alldata.com yet
and can very by engine,no engine stated..

Posted on May 09, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: how to check transmission fluid on 2001 isuzu rodeo

There is no dipstick on your auto trans. Checking it is a real PITA The trans pan has 2 plugs in it. The one on the very bottom is the drain. The one in the corner, up higher in a recess is the check/fill plug. To check, the engine must be warm and running, tranny in P. Remove the plug and fluid should dribble out. If it doesn't it's low, fill until it dribbles out, while engine is running. Obviously the truck must be on a lift or up on jackstands.

Posted on Dec 22, 2008

  • 2 Answers

SOURCE: 2001 Rodeo rough idle in drive, and sometimes on the highway

Check the overdrive accumulator cover on the transmission for any leaks. This can cause some rough idle situations and minor slipping but if caught early enough isn't bad to fix.

Posted on Mar 27, 2009

defadad
  • 351 Answers

SOURCE: 1995 isuzu rodeo hood release broken under the hood

if the grille screws are accessable remove the grille which should give you access to the underside of the lock, you may need a screwdriver to push the lever aside to release the hood
Hope this helps

Posted on May 23, 2009

  • 14 Answers

SOURCE: 2001 Isuzu Rodeo 4 cyl 2.2L 2WD that is overheating

check the electric fan conector plug some times is rusti scratchet whit a sharp scruwdriver remove the rusti or dirt on it this happens many times and step two check the relay and thats it (this is the first step a mecanic to search)

Posted on Feb 07, 2010

  • 1 Answer

SOURCE: I have a 2000 Isuzu Rodeo, V6. The car stalls at

it's the EGR valve and can be fixed by anyone. It involves disconnecting the battery, remove electrical connection, and removing 2 screws and cleaning the surface area well and replacing it as well as the gasket. A new EGR valve runs around $120 and trust me you can fix this and save hundreds!

Posted on Feb 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Isuzu rodeo gas smell


check the cutoff soleniod on top of gas converter incoming side cos the engine starts on petrol ive got the same truck colin down under

Nov 24, 2012 | 2001 Isuzu Rodeo

1 Answer

2002 isuzu Rodeo P1220 code


Hi there:
Other than a bad connection / chaffed wire etc - which can happen - so be sure all is ok there - then the problem is going to be a faulty TPS ... throttle position sensor / switch..

This isn't unusual to happen / go wrong on these - No amount of re learn procedures will cure a faulty one Im afraid - so its a new one that is needed to cure these issues that you have with this one.

The TPS ( sensor ) is at the pedal on this one.... and its this that Im referring too. This can be checked using diagnostic equipment - using live data - it can be checked to see f its working and when its not etc.

Not all garages would be able to do this depending on what equipment they have and their level of knowledge - but I would suggest it would be a good idea to have it checked out as above to confirm the fault ..

You have the TCU - Throttle control unit - but thats inside and a part of the TPM - Throttle position motor ...on the engine.

Your fault codes though would indicate the TPS - at the pedal.


There is also a common fault on these that causes throttle / power loss... Im not so sure this fits the symptoms you describe but it might be worth a consideration... For this - a reprogram / software update has to be performed by either a Fiat dealer - or some garage that has the equipment to do that ....It might be worth you having a word with the local Fiat dealers to have that side of things done in any case - again - as its a common fault.



Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Aug 17, 2012 | 2002 Isuzu Rodeo

1 Answer

I have a 2000 Isuzu rodeo. Just bought the car used, no problems until this morning...the car will turn over but it idles rough and if you push on the gas pedal the car cuts off. The air filter is good,...


If the air filter is not too dirty maybe you should check the fuel filter. I could be the throttle position sensor if it is a problem that happened suddenly as it may be in the electronics. Also listen when you first turn the key on, you should hear a humming sound for a couple of seconds from the fuel pump. If there is no sound it is probably out or a fuse is blown.

Nov 18, 2011 | 2000 Isuzu Rodeo

2 Answers

My Isuzu Rodeo LS V6 2001 ran out of gas and now


get under the truck and hit the tank hard with your hand the pump may be stuck a couple good wacks might work

Mar 24, 2010 | 2001 Isuzu Rodeo

1 Answer

What sensor is controlled by the accelerator pedal? What sensor controls spark timing? Both on a 1997 v6 Rodeo.


Hello Wayne.
When you depress your accelerator pedal it increases the voltage output of the throttle position sensor mounted on the end of the throttle shaft.
No one sensor adjusts timing though. The inputs from several sensors are integrated inside the ECU computer. Then the ECU adjusts the timing accordingly.
Base timing is taken from the crankshaft position sensor and the camshaft position sensor.
Engine temperature, engine load, revs per minute, gear ratio, speed all have the most effect, but there are others that will have slight effect as well.
If you have any more questions leave them in "add comments" and I will return your question.

KL

Dec 17, 2009 | 1997 Isuzu Rodeo

1 Answer

I need a pedal position sesor 4 my 01 isuzu rodeo i am haveing no luck finding one can some one help me


Probably you mean a throttle position sensor commonly referred to as a TPS. They frequently go bad. Google "Isuzu TPS" for location diagrams and other info. Once installed, there are likely to be adjustments needed that require equipment. Any Isuzu dealer should have one in stock.

Jul 24, 2009 | 2002 Isuzu Rodeo Sport

1 Answer

Reduce power and check engine lights on


reduced power usally points toward a gas pedal to throttle correlation meaning the drive by wire system is where the problem is

Apr 18, 2009 | 2001 Isuzu Rodeo

1 Answer

P1220 code need the trouble tree to diagnose componate.


YOUR CODE P1220 UNDER 2001 RODEO SPORT AS A THROTTLE POSITION SENSOR 2 CIRCUIT FAILURE. THE ISUZU PART NUMER IS 8-97254-681-0

Mar 07, 2009 | 2001 Isuzu Rodeo

1 Answer

1995 Isuzu Rodeo starting problem.


Hello first thing i would start with is check your idle screw it may be set to low if the choke linkage is sticking .first take your breather off so you can see the choke linkage look to see where the plate is positioned is it fully closed have somone try starting with out touching the gas pedal if it doesnt start slightly open the choke plate if it starts you need a choke adjustment check to see if its manuel linkage, vacuum operated,or electrical. if vacuum check lines for dry cracks or splits preventing choke operation if electrical you need to test the power wire at the choke also test for good ground if mechanical check adjustment screw for curb idle to see if its set to low.goodluck please rate

Sep 29, 2008 | 1999 Isuzu Rodeo

1 Answer

1999 rodeo 6 cyl


hello from what you explained i take it theres no check engine lights on what it sounds like is a basic increase on your idle screw get somone to help push pedal down underhood look to see where gas cable pulls back when gas pedals appled have them release slowly now watch where it stops against a set screw that is your adjustment rpm range should be somewhere between 750-900 rpm depending on vehicle if this doesnt solve most likely tps sensor{ throttle position sensor} goodluck

Aug 10, 2008 | 1999 Isuzu Rodeo

Not finding what you are looking for?
2001 Isuzu Rodeo Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...