Question about Dodge Cars & Trucks

Open Question

How do I remove the right motor mount on a 2005 Dodge Stratus?

How to remove front right motor mount

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 151 Answers

SOURCE: Thermostat needs replace on 2005 Dodge Stratus 2.4 liter motor

If it's a chrysler engine the thermostat is located just below radiator cap. If mitsubishi diamond star engine it's located on the cylinder head , beside the air cleaner housing

Posted on May 10, 2009

richardrb123
  • 26 Answers

SOURCE: Replacing front brake pads on 2005 Dodge Stratus

jack up the car take the wheels off the caliper which holds the pads need to come off usally 2 bolts if you are replacing the rotors you may have to hit them with a hammer to break the free if they have little clips on the rotors you can grabb the clips with pliers and take them off you do not need to replace them make sure you push the pistons on the calipers back in clean and lube the pins and the any where the rest on the knuckle do get lube on the rotors put it all back together do the same on the otherside before you start the car pump the brakes until a good pedal then you are good to go i hope this helps you

Posted on Apr 13, 2010

  • 1 Answer

SOURCE: how do i get the right motor mount out of the way

First remove the coolant over flow reservoir, remove the heater core pipes that ran across the mount by taking two 10mm bolt that hold the pipe, one bolt by a/c compressor and the other behind power steering pump for easy access to remove mount,Above the wheel by the fire wall two bolts (15mm) hold the mount from the bottom remove them,support engine with floor jack at oil pan, use piece of board between jack and oil pan so no damge acured to oil pan, then remove upper three bolts(15mm) that hold mount, this should help you get that mount out, its a very tight spot hopw this helps.

Posted on Apr 21, 2011

emissionwiz
  • 75822 Answers

SOURCE: how to change front motor mount on a 2005 dodge neon

The mount is located under the engine, to replace it you must raise the car up as high as poss and support it with safety stands (a must!) and then unbolt the two engine mounts located about midway along the oil pan and bolted to the engine block, then you must carefully raise the engine off the mounts (do not damage the oil pan) and slide out the old mount and the new one in. You will need allot of tools to get this done, so unless you have all the needed tools don't attempt it.

Posted on Feb 23, 2012

SOURCE: Replace front struts on Dodge Stratus

You Tube Video has the movie on yours or
a similar job

You only have 3 nuts on top of strut tower
& 2 bolts on steering knuckle, on any vehicle
made for the last 30 years

Posted on Mar 10, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loose front end front end not closing completely


not sure what you mean need more details. if there is a shake in the front end when car is running check to see if the motor is moving at all wile running. i have the same car and the shake turned out to be a broken motor mount on the front of the motor

Oct 27, 2013 | 2005 Dodge Stratus

1 Answer

Is a 2005 dodge stratus 2.7l engine mount in a 2002 dodge intrepid that had a 2.7l.


Hey Eric,here are both motor mounts,they are different,here's the 2002 Interpid,Here's the 2005 Stratus.

Jan 20, 2013 | 2002 Dodge Intrepid

1 Answer

2005 dodge stratus radio wire diagram


2005 Dodge Stratus with Infinity Radio Wire Harness Colors
Car Radio Constant 12V+ Wire: Pink
Car Radio Switched 12V+ Wire: Red/White
Car Radio Ground Wire: Black
Car Radio Illumination Dimmer Wire: Orange/Brown
Car Radio Power Antenna Trigger Wire: N/A
Car Radio Amplifier Turn On Trigger Wire: Dark Green/Red
Car Radio Amplifier Location: Amplifier is Mounted Under the Front Passenger Seat
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Wire (+): Dark Green
Left Front Speaker Wire (-): Brown/Red
Right Front Speaker Wire (+): Violet
Right Front Speaker Wire (-): Dark Blue/Red
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Wire (+): Brown/Yellow
Left Rear Speaker Wire (-): Brown/Light Blue
Right Rear Speaker Wire (+): Dark Blue/White
Right Rear Speaker Wire (-): Dark Blue/Orange

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 08, 2012 | 2005 Dodge Stratus

1 Answer

How do i get the right motor mount out of the way when changing a timing belt on an '06 dodge stratus 2.4L 4 cylinder motor?


First remove the coolant over flow reservoir, remove the heater core pipes that ran across the mount by taking two 10mm bolt that hold the pipe, one bolt by a/c compressor and the other behind power steering pump for easy access to remove mount,Above the wheel by the fire wall two bolts (15mm) hold the mount from the bottom remove them,support engine with floor jack at oil pan, use piece of board between jack and oil pan so no damge acured to oil pan, then remove upper three bolts(15mm) that hold mount, this should help you get that mount out, its a very tight spot hopw this helps.

Apr 20, 2011 | 2006 Dodge Stratus

1 Answer

Where is the cranksensor in a 2005 dodge stratus


You can find the crank shaft sensor in your car under the starter located over the motor mount..You have to remove the starter to reach to the crank shaft sensor.

Nov 06, 2010 | 2005 Dodge Stratus

1 Answer

How to change heater core on 2005 dodge stratus?


  1. Disconnect the negative battery cable.
  2. Remove the radio/HVAC control module bezel. CAUTION
    The vehicles covered by this manual are equipped with a Supplemental Restraint System (SRS), which uses air bags. Whenever working near any of the SRS components, such as the impact sensors, air bag modules, steering column and instrument panel, disable the SRS, as described earlier in this section.
  3. Remove the right instrument panel side trim.
  4. Remove the two retaining screws at the lower right side support beam.
  5. Remove the instrument panel support bolt at the A-pillar.
  6. Remove the left instrument panel side trim and upper instrument panel bezel.
  7. Remove the lower knee bolster and console screws at the instrument panel.
  8. Remove the gearshift knob and shifter bezel.
  9. Remove the mounting screws at the front and rear of the floor console. Remove the front and rear console halves.
  10. Remove the right side instrument panel support strut.
  11. Drain the cooling system into a suitable container, then disconnect the heater hoses at the cowl panel. Plug the heater core outlets to prevent coolant from spilling during unit housing removal.
  12. Remove the mounting screws and heater core cover.
  13. Remove the heater core from the vehicle. To install:
  14. Carefully position the heater core unit into the heater housing.
  15. Install the heater core cover onto the heater housing and tighten the mounting screws.
  16. Install the right side instrument panel support strut.
  17. Install the front and rear console halves.
  18. Install the shifter bezel and gearshift knob.
  19. Install the lower knee bolster and console screws at the instrument panel.
  20. Install the upper instrument panel bezel and left instrument panel side trim.
  21. Install the instrument panel support bolt at the A-pillar.
  22. Install the two retaining screws at the lower right side support beam.
  23. Install the right instrument panel side trim.
  24. Install the radio/HVAC control module bezel.
  25. Fill the cooling system to the proper level.
  26. Connect the negative battery cable.

Aug 13, 2010 | 2005 Dodge Stratus

1 Answer

How to replace a timing belt in a 2005 dodge stratus


You Just have to remove the bolt from the transmission side ***** right in front of the cooling fans. And remove the front motor mount. Then use a jack with a wooden block to support the engine and jack it a few inches and you will have all the room you need. BTW, you will need to rent the special harmonic balance puller tool from you local parts store.

Jun 19, 2010 | 2005 Dodge Stratus

1 Answer

Replace water pump on 2004 Dodge Stratus 2.4L DOHC


First, I'd recommend you buy a manual, because the water pump is internally mounted, driven by the timing belt. You will also need a puller to remove the crankshaft pulley. You can usually rent/borrow this from the same place you bought the manual. The manual will also show you how to properly install the timing belt and compress the tensioner.
You will need to drain the cooling system, raise the car (safely), remove the right tire, right inner fender, right engine mount (aka front mount), accessory drive belts, timing belt cover, timing belt and tensioner (which needs to be recompressed correctly), and now you are at the water pump. Since the timing belt has to be removed, you should also replace it.

Sep 19, 2009 | 2004 Dodge Stratus

2 Answers

I need to replace the motor mount thats on the passenger side,abd you access the main bolt thru the wheel well,it's a 2005 2.0,do you know what they call that motor mount


hello. you have 5 mounts front left side, front right side, lower strut rear of engine,upper strut right side and transaxle rear left side

Sep 14, 2009 | 2005 Dodge Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...