Question about 2006 Chrysler Pacifica Touring

4 Answers

Speedometer not showing correct speed

When running the Pacifica, it will not show the right speed. what's is the problem, will it be expensive to fix?

Posted by on

Ad

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Chrysler Master
  • 531 Answers

After you verify that you have the correct tire size for that vehicle,

check the wiring / plug to that sensor

unbolt it and spin it by hand to make sure it does spin freely

Posted on Apr 15, 2015

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 126 Answers

How far off is the speed? or does it bounce around at times? i have seen bad rectifiers in the alternator cause spiking of AC ripple through the speedo head. but if its off + or - manufactures say no more then 7% is within in specs.. also make sure the tires are the right size.
southernelectronics.com

Posted on Apr 15, 2015

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 1,326 Answers

Speedometer might need to be adjusted

Posted on Apr 11, 2015

  • Earl DaSquirrel
    Earl DaSquirrel Apr 15, 2015

    it's an electronic VSS system... either his tires are wrong or he has a loose connection / wire exposed to that sensor

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 3,218 Answers

Most likely a transmission speed input/output sensor. You need to have the transmission codes scanned to help isolate the problem. The sensors I believe are 50-75 dollars and maybe an hours labor to change. Scan first to make sure.

Posted on Apr 11, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I found the lug wrench and jack. Where is the nut to lower the spare and where is the 4-sided adapter stored?


How To Lower Your Spare Tire - YouTube

? 1:27
https://www.youtube.com/watch?v=6rLi0I7vRIw
Mar 30, 2011 - Uploaded by Garden City Jeep Chrysler Dodge Ram SRT
The staff at Garden City Jeep Chrysler Dodge are ready to help you. ... Garden City Jeep Chrysler Dodge has The Can-Do Crew show you how to lower your spare tire. ... Pacifica, Durango, Charger and Liberty for the Hempstead, Queens, Brooklyn ...Installation of a Trailer Hitch on a 2006 Chrysler Pacifica ...Missing: nut ‎sided ‎adapter ‎stored

Fix a Flat Tire: Chrysler Pacifica - CarCareKiosk

www.carcarekiosk.com/...Chrysler_Pacifica...3.../change_a_flat_tire
Free video on how to fix a flat tire in a 2005 Chrysler Pacifica Touring 3.5L V6. Complete instructions for using the jack kit and spare tire in a 2005 Chrysler Pacifica... Most Chrysler jack kits include the jack, a jack handle and a lug nut wrench.

Jan 05, 2016 | 2006 Chrysler Pacifica

1 Answer

How do I install a vehicle speed sensor in a 2006 chrysler pacifica 3.5L


here is the link for the part you need.


http://www.partsgeek.com/gbproducts/TC/17855-06015753.html?utm_source=google&utm_medium=ff&utm_content=TC&utm_campaign=PartsGeek+Google+Base&utm_term=2004-2006+Chrysler+Pacifica+ABS+Speed+Sensor+Replacement+2970068+Front+Left+04-06+Chrysler+ABS+Speed+Sensor+2005+05&fp=pp&gbm=a&gclid=CJzn5eXokLQCFQioPAodpREAXg



Simple as pie. Once you have the part in hand, You will see where it plugs in near the intake. Just follow it to the other end, remove and replace.


Should be a 10mm bolt holding it down, and to remove the plug, just press the retainer tab and pull out. New plug snaps right in.



Dec 10, 2012 | 2006 Chrysler Pacifica

1 Answer

I have a school auto shop trying to fix the heater in my chrysler pacifica heater . The blower motor wont work on any speed they checked the power and sais everything seemed to have power going to...


You need to specify if the car has Auto Temp Control or Manual......this is Manual. .Power is great, but its not going to work unless it also has ground. The black wire at the motor is ground, then it goes to the blower speed resistor, If you ground the Black wire, and the blower runs, the motor is OK, If you ground the Dark Blue /Gray wire it should work full speed. If it does not, then replace the resistor. The a/c controller grounds the Resistor. so if you ground the DB/GR wire and it works, then the controller may be bad. These guys should have access to a wiring diagram.

Dec 06, 2010 | 2005 Chrysler Pacifica

6 Answers

I have a 2004 pacifica, fwd. I had just gotton my front brakes and rotors done, as well as all tie rods. I am still a wierd knocking noise in the front end (sounds like the right wheel well mostly) Almost...


In this order stabilizer links, stabilizer bar bushings, control arm bushings, engine cradle bushings or bad struts mine have 160,000 and don't clunk but do need replacement
9_23_2015_9_24_08_pm.jpg

Aug 11, 2010 | 2004 Chrysler Pacifica

1 Answer

I have a 2004 Pacifica and the blower motor runs on high all the time, can't get it to work on slower speeds


The high blower works off a relay in the high speed only so the fan switch is at fault on your vehicle
Replace the fan blower control speed switch which is the one you adjust the lower fan speeds

Jun 15, 2010 | 2004 Chrysler Pacifica

1 Answer

Need to replace front abs speed sensors on 2006 pacifica .how do i do it


If you look at the front hub area with the wheel off, youll see a wire running up the knuckle you need to unplug the connector, the sensor it self is bolted right behind the wheel with a small 10mm bolt, just take that bolt out and pull the sensor out, you might have to use a small flat head screw driver, then just reinstall new sensor..

youll have to have the abs light reset if its on, you can disconnect the battery and it should do the trick

Apr 06, 2010 | 2006 Chrysler Pacifica

1 Answer

Car will not start after accident. small finder binder right front side wont start after that but was running fine up till then


Fuel shut off switch usually behind the passenger (right hand kick panel may need resetting owners manual may show the information

Aug 21, 2009 | 2004 Chrysler Pacifica

1 Answer

2006 Chrysler Pacifica Auotmatic Liftgate


Yes new gas shocks on the lift gate will fix your problem. I had the same problem on my 2005 Pacifica and when it hit my head- I came up with the solution.

Good Luck,
Ray

Apr 25, 2009 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2006 Chrysler Pacifica Touring Logo

250 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...