Question about Nissan Cars & Trucks
If the starter is not engaging it could be a defective starter motor,starter relay,wiring,theft deterent etc. You must determine if there is power to the starter solenoid during cranking to eliminate a wiring problem and determine if the starter is the issue
Posted on Apr 11, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1999 Continental will not start
Does anti-theft light come on for a sec then turn off when you turn on the key or does it flash with key on?
You said that CEL turns off while cranking,does it come back on if you continue to crank after about 8-10 seconds of cranking?
If it does not then your PCM is not seeing a signal from the crankshaft postion sensor.You can try wiggling the harness at the crankshaft postion sensor and see if it will start.
Posted on Jan 31, 2009
SOURCE: 2000 cadillac catera cranks but
it's the cps (crankshaft position sensor)
it cuts off the power to the fuel pump as a preventive mesure, it's a very common problems with the catera
i had the same problem with my 2000 model
Posted on Jan 21, 2011
Are you sure it's running when cranking? It should have come on when key turned on.
This is for camrys up to year '91. It may apply in your '95, also. Check the 7.5 amp ignition fuse and the 15 amp EFI fuse and the EFI main relay, all located in the fuse box next to your battery. There is also the circuit opening relay tied in to fuel pump operation. It is usually found under center of dash. It is usually not the problem, but it is part of the checks for fuel pump operation.
If your car has a " check connector" or "service connector" (also called a fuel pump check connector) under hood on driver's side near the firewall (a little 1 inch cube with a cap on it), then bridge terminals +B and Fp with a jumper wire. Turn key to on (don't start car). The pump should come on. Listen for fuel return noise from the fuel pressure regulator, and verify pressure in hose from the fuel filter. If nothing, check those fuses above. Here is how power runs to pump: Battery to 40 amp main fusible link-to 15 amp EFI fuse-to EFI main relay-to circuit opening relay-to fuel pump-to ground. Ignition switch and the computer (ECU) work the relays to pass power to pump. Hope this helps some, Randy. Good luck.
Posted on Nov 11, 2011
thew timing marks for vanette cargo are on the timing belt u carnt go wrong
Posted on Dec 28, 2011
When you turn the key to start & the motor turns
or turns over that is the same thing as the crankshaft
turning you call won't crank
So you need to say my engine turns over but it will
You need to check for fuel pressure & spark
Most likely you will need the help of a repair shop
Posted on Sep 15, 2012
Tips for a great answer:
Feb 06, 2015 | 2010 Nissan Versa 1.8
Mar 03, 2013 | 1998 Mercedes-Benz S-Class
Sep 30, 2012 | Cars & Trucks
Sep 14, 2012 | 2007 Nissan Versa 1.8 Sl Hatchback
Jul 05, 2012 | Nissan Cars & Trucks
Nov 23, 2011 | 1996 Nissan 200SX
Sep 08, 2011 | 1995 Lincoln Town Car
Jun 24, 2011 | 2003 Nissan Altima
Jan 29, 2011 | 2008 Nissan Versa
Jun 24, 2009 | 2008 Nissan Versa
Sep 24, 2017 | Nissan Cars & Trucks
98 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: