Question about Cars & Trucks

1 Answer

Does not run battery is okay.no forward or reverse.motor runs when I put 12 volts to plug.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,218 Answers

12 volts to plug? Need more info. Year MAke Model Engine size

Posted on Apr 11, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i reconnect the wires on the high/low and forward/reverse on a 12 volt quadbike


I don't have the diagram. But green wires are always ground. The two yellow wires, if it goes into a plug, plug it in. Most plugs are what I call, iddiot proof. Not meaning you are one. But the plugs will not go to another plug. If you have to put a lot of force to get them to go together. They don't belong together. Just remember that some plugs don't go to anything. They make these harnesses to fit multiple vehicles..

Dec 28, 2014 | Cars & Trucks

1 Answer

Window will not roll up


It is usually a broken wire in the hinge from bending back and forth for years. Sometimes it is the switch but rarely. You can put the window up using a 12 volt battery or even a 9 volt battery with alligator clips. To reverse the direction reverse the polarity. This will also confirm that the motor is fine.

Nov 26, 2013 | Pontiac G6 Cars & Trucks

1 Answer

How can i know if my voltage regulator is working, Im not getting any of my lights to work


quick check is to remove a battery cable while the motor's running. If the motor stays running when you pull off the battery cable, the charging system is functioning properly, if it dies then there is a problem with the charging system. Don't leave it off long, as this test is stressful to the circuit. You can test the voltage regulator by putting a volt meter across the battery posts to verify voltage. A fully charged 12 Volt battery should show slightly above 12 volts DC. With the engine running and the volt meter hooked to the battery, the charging system should be showing around 13.8 volts DC.

Dec 02, 2012 | Cars & Trucks

1 Answer

I installed the parking sensors yeaterday and now they continue to beep after I put them in reverse. I did the test where you turn on the ignition but not start the car and then put the lever in reverse....


hello i would like to help but can you give me information on the sensor kit you installed. some systems to beep and some only beep when the sensors detect something. also if they work fine with out the engine running but then don't work properly when the engine is run this could be there is to muck voltage for the sensors, some sensor kits are saying they are 12v, this is correct 12 volts, but the charging system on most vehicles are 14 volts, so you may have to fit a regulator to the feed wires to the sensor. you would need a 12 volt regulator board. this will stop any power going over the 12 volts to the device.

Jun 30, 2017 | 2005 Nissan Pathfinder

2 Answers

EZGO golf cart won't go forward


Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.

Apr 09, 2010 | 1993 Acura Vigor

2 Answers

87 toyota camry new battery wont keep charge, alternator checks okay, in dash bulb for charge and brake and lights stays illuminated?


Generally if charge light is on, alternator has a bad diode in it. This lets the charged battery lose its power by flowing in the reverse direction. It sounds as the alt., is either not connected right or is swtill bad

Jan 18, 2010 | 1995 Toyota Camry

1 Answer

Replaced ignition switch, now car won't start I own a 1980 Camaro(Had to put 83 in product category cuz it wont go any lower but it's an 80), The Ign. Switch went out a few months ago, I replaced it back...


Dont panic, you can do this. First you must get a multimeter. Their cheap at harbor frieght 5 bucks. Then check the battery, car off, should be 12 volts. car on 13,14 volts. Possibly the ignition switch wires are touching. That of course would be a short. Also try to jump start the car, if it turns over you found your problem. If not you must start check the connections from the battery. follow the wires, negative to frame, make sure its tight, positive to starter make sure its tight to starter post. Use meter to check for power on the wires. Okay buddy good luck.

May 13, 2009 | 1983 Chevrolet Camaro

1 Answer

Front drivers side window will not go up or down?


Your window is powered by a reverse polarity electric 12 volt motor. To raise, the polarity travels in one direction. To lower, it is reversed. Gain access to the motor by removing the door panel and locate two wire connection to the motor. Connect two leads to the motor that you know are one each, positive current and negative current Motor should run in one connected way and also run in the other connected way. If motor doesn't run, motor is bad..

Feb 20, 2009 | 2004 Saturn VUE

2 Answers

1999 cadillac deville blower dont operate. What should the voltage be at the red wire and the gray wire or the black wire ? Iam assuming the red wire should be 12 volts, the gray wire should be variable...


red black and gray are just half the connections. Red is positive 12 volts coming from fuse of circuit breaker. The black wire is either the ground or the main hot wire going to the blower motor (3 pin connection only), and the gray wire (if is is small in size) is a variable voltage coming from the body control module requesting speed for the blower motor.The blower control module varies voltage on the main wire going to the blower motor, supposedly in accordance with the requested voltage from the body control module. Usually if all fuses are okay and present on the apprpriate wire of the blower control module, the a blower motor that will not run or stays running after the key is turned off is the fault of the blower control module. If the blower control module has failed the the cause must be determined (over amping blower motor) or else new blower control module may fail when powered up.Usually blower control modules have more than three wires. Usual connections are: B+ (battery voltage) GND (chassis or engine ground), two large wires going directly to blower motor (can be any color, but are usually 10 guage in size), and an optional wire that reports voltage level back to the body control module.

Jan 11, 2009 | 1999 Cadillac DeVille

1 Answer

24 volt charging problems .2 12 volt batteries 1 battery 16volts and the other about 9-10 volts


A 12 volt battery is actually 13.2 volts fully charged. If you are reading 16 volts, you are probably getting extranious voltage from the system somewhere, especially if the vehicle is running when you check the voltage. The alternator will put out about 15-18 volts to charge the battery normally, and yours may put out 28-32 volts to charge them in series, but the batteries, when disconnected, should never read more than about 13.2 volts each. Typically, it will read about 12 1/2 volts when disconnected. COMPLETELY DISCONNECT BOTH OF THE BATTERIES. If you still read 16 volts when it is disconnected, you must have a bad meter because the battery can't produce that much voltage, no matter what. (Six 2.2 volt cells connected in series inside the case.) Put the meter on a known good battery on another car that is not running and see if you get the same reading. It sounds like the other battery is almost dead, regardless, and it sounds like your series/parallel switch may be malfunctioning. (That is the switch that puts the battery in series to run the 24 volt starter, then puts the batteries in parallel to run the remainder of the vehicle on 12 volts. This is all assuming that you have a diesel vehicle with a 24 volt starter and that is why you have two batteries.

Aug 19, 2008 | Toyota Land Cruiser Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...