Question about Cars & Trucks

1 Answer

New fuel pump new regulator in tanka lot of crank with spark will not syart

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 258 Answers

Even though you replaced full pump are you getting fuel ? can you hear it priming when you cycle the key ?

Posted on Apr 11, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: 90 k1500 tbi no fuel from injectors

from the sounds of it its going to be one of 3 things 1) the injector is bad or 2) there is no power getting to the injector 3) bad relay switch.

1) to find out if the injector is good. pull the injector out and with some wire ground one side and touch the other side to your battery, every time you tap the wire to the bat you should here the injector click..

2) if injector is good get a test light and test to see if power is coming out of the wires that go to injector( on some vehicles you have to have the motor turning over befor power is sent through wire, so have someone turn the key while you check the wires with test light)

Posted on Aug 15, 2009

Testimonial: "Thanks for the quick response and advice. I am on the hunt for the problem and you helped me close some doors to narrow my search."

  • 43 Answers

SOURCE: will crank but won't turn over

Check the ignition module, coil packs, crank sensor.

Posted on Mar 14, 2010

  • 5546 Answers

SOURCE: 1989 mustang gt 5.0 fuel

Was looking at posts and other sites. I take it that some relays are even under seats. Anyway, Apparently the ECU relay and the ECC relay are linked. When properly operating the ECC brain sends a signal to the ECC relay and the ground wire is tan/green. The brain can be throwing the signal and the relay terminals are not receiving the signals, so the relays cannot switch.

Although you have replaced some relays, you need to check your plugins for these 2 relays.

Posted on Nov 28, 2010

  • 46 Answers

SOURCE: ENGINE WILL TURN OVER BUT WILL NOT START / FUEL

Fuel pump is my diagnosis, or filter. I am a Ford technician.

Posted on Nov 29, 2010

  • 1 Answer

SOURCE: Engine cranks over but no

regarding the fan speed for heather motor replace the relay under the glove compartment remove the cover and replace it easy to do.

Posted on Apr 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

1984 Mercedes Benz, 2.3l cranks, no start, not getting fuel pressure. new plugs and gets spark.


There appears to be a fuel pump, fuel regulator, and fuel filter between the fuel tank and the fuel air mixture device. Any one of these could be causing a low fuel pressure problem. Ref.
http://www.pelicanparts.com/catalog/SuperCat/W201/MBZ_W201_FULFUL_pg3.htm fuel system page 3.

Oct 06, 2017 | Cars & Trucks

1 Answer

Road with a new fuel pump installed also new filter & relay pump cranks 65 psi pressure drops and quits, maybe if you crank long enough it might start, could this be fuel pressure regulator ?


What Make vehicle ? fuel pressure regulator could be part of fuel pump module . A lot of vehicles have electronic return less fuel systems an have a fuel pump driver module ,an is controlled by the PCM .

Jun 02, 2016 | Cars & Trucks

1 Answer

The car will turn over but will not crank has new spark plugs and wires and a new serpentine belt.was running then just stopped hasn't run since also new battery


You mean the engine will crank over but won't start an run ! Does it have spark ,is it getting fuel ? You need to find out what is missing ! If no spark , it could be crankshaft position sensor ,coil pack , PCM etc.. No fuel pressure , fuel pump , electrical - fuel pump relay ,inertia fuel cut off switch ! A lot of thing's can cause this ! No Start Diagnostic Basics EricTheCarGuy

Aug 04, 2015 | 1999 Mercury Cougar

1 Answer

I have a 2006 ford with the 5.4 . It stop running. I put a new fuel filter an electronic fuel module and a new fuel pump And it still want start . I can't tell if I'm getting any fire to the flue pump . I...


To check basic spark get a spark plug tester from auto store for about $5. Remove fuelpump fuse. Remove spark plug, connect to tester. Have a buddy crank car an watch for spark. Do this for each plug. No spark is likely a bad ign. wire or coil. Be careful not to touch electrical wire/plug while cranking as they put out a lot of electricity.

Mar 24, 2015 | Ford Cars & Trucks

1 Answer

I have a 95 s10 4.3 vortec with no power to the injectors i have repalaced the pump and did a pressure test 60 psi new filter new oil sensor new fuel regulator but cant find the problem everything works ...


First, after cranking the starter, have your pulled a spark plug to verify spark and fuel to the cylinder. If the plug is dry, the injectors are not working. If the plug is wet, no spark. You can verify spark by taking the spark plug and putting the spark plug wire back on it, lay the plug down and crank the starter. If it's getting voltage, a spark can be seen ar the end of the plug. Assuming that you have done the tests and determined that the cylinders are not getting fuel, that would indicate a bad fuel injection unit. If found defective, the fuel injection unit must be replace as a whole. This consists of the pressure regulator, fuel meter body, injector, and poppet nozzles and lines, sometimes referred to as the "spider injectors" because of the configuration. All of this resides under the upper air intake plenum, which would have to be removed.

Jan 07, 2011 | 1995 Chevrolet Blazer

2 Answers

93 honda del sol will turn over but wont start. It has a new time belt, distrib, and the main relay works.


Is it not getting spark or gas? It needs both to run. Both main source. If no spark in any cylinder, then ignition module or crank sensor is likely faulty. If no gas, then fuel pressure regulator or fuel pump or fuel pump relay is bad.

Nov 11, 2009 | 1990 Honda CRX

1 Answer

Car wont start i have a new battery, new spark plugs and wires


It need to have fuel and sparks to start.
Have you check to see if there is spark after all new parts?
If there is spark, then check if it has fuel.

To check spark, hold 1 spark plug touching engine chasis while cranking, if there is no spark then problem with the coils or ignition module.
To check fuel, after cranking several times but no firing, take out a spark plug to see if it wet.
If it is dry then no fuel. For this, problem could be following in order:
-Fuel filter
-Fuel pump
-Fuel pressure regulator
- Fuel injectors
- Fuel injector module.
Need to go through troubleshooting step by step before changing the parts to correct a problem. Good luck in finding a good mechanic to test before spending money in costly partts replacement.

Sep 23, 2009 | 1995 Honda Civic

2 Answers

Cranks but no start


Sounds like the carb is dirty. I would check that before spending a lot of money of other things.

May 31, 2017 | 1990 Lincoln Town Car

1 Answer

98 chevy camaro wont start


check fuel pressure regulator

Dec 06, 2008 | 1998 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...