Question about Cars & Trucks

1 Answer

Passenger side turn signal doesn't work changed bulbs.still doesn't work

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Expert
  • 147 Answers

Could be defective switch or dirty contacts

Posted on Jun 30, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: turn signal does not work

I found a wire pulled loose in the connector at the turn signal switch on the steering column.I believe it was blue and yellow,not too hard to get the covers off .2001 sport trac

Posted on Dec 02, 2008

emissionwiz
  • 76164 Answers

SOURCE: Replacing rear turn signal bulb in 2003 Mustang

remove the trim panel at the very rear of trunk, remove it and place it out of the way, remove tail light Assembly retaining nuts top and bottom, I think there are 6 per side, pull the tail light assembly straight back to access the bulbs for replacement.

Posted on Dec 04, 2008

  • 36 Answers

SOURCE: How do you change the 2007 Jeep Patriot turn

You might have to remove the headlamp assy to get to it.

Posted on Jul 07, 2009

  • 1 Answer

SOURCE: Audi A4 2002 Low beams & Right front turn signal stopped working

but on 2002 A4, F20 and F21 are empty! Does anyone has an idea where the headlight fuses located?

Posted on Jun 10, 2010

  • 248 Answers

SOURCE: How do I change the rear passenger side turn

You should be able to access the defective bulb/lamp from within your trunk. Open your trunk and carefully, pull back the black cloth. Once exposed, you should see a wire harness. Follow it to the bulbs/lamps. Twist the defective bulb and it will come out.

The FixYa Team!

Posted on Feb 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Right rear turn signal does not work


check the bulb there some bulbs have two elements in them the turn signal element might be broken change the bulb

Sep 19, 2012 | Cars & Trucks

1 Answer

I have a 2000 maxima...when headlights are on, passenger side blinker stays lit on the dash and doesn't flash at all. While the headlights are off and i turn the passenger turn signal on it then b


Plain and simple...Your turn signal circuit is shorted to your headlamp circuit. What USUALLY causes this is an incorrect light bulb has been installed in the vehicle or the light bulb was installed incorrectly. There are other possible causes of these circuits being shorted together, but 99 out of 100 of the times that I have seen this it is either because somebody just replaced a bulb or a bulb socket melted somwhere on the car. Be sure to check both the front AND rear bulbs.

Jan 07, 2012 | 2000 Nissan Maxima

1 Answer

Turn signal bulb was working, now it isnt


its is not uncommon for the contacts in the sockets to become corroded or just expand to the point of where they do not contact the bulb,try to test the socket with a multimeter for voltage,if it has voltage then its most likely the contacts,which sometimes can be rebent,but replaceing the sockets is a better solution,and can be picked up at most stores or 4x4 shops and junk yards.

Dec 14, 2011 | 1998 Jeep Cherokee

1 Answer

Changing passenger side turn signal for 2005 Pontiac Grand Prix. There are a few bolts I could undo, but I'm afraid I'll break the car. The manual doesn't really give good directions, so...


There are two phillips head screws on the fog light/turn signal, unscrew them both and pull the unit out, the blinker connector is located on the back side... twist it out counter clockwise and blam! There's the bulb, slide a new one in, and make sure she works.

May 06, 2011 | 2005 Pontiac Grand Prix

1 Answer

Changed multi function switch, bulbs, and passenger side rear light assembly (reverse, blinker, brake light). Everything works except the rear passenger side turn signal but the front passenger side is...


You have a bad connection at the rear passenger side turn signal. It is either the connection is corroded or a wire is loose on the ground side of the circuit.

Nov 11, 2010 | 2006 Dodge Ram 2500

1 Answer

Driver front turn signal does not blink. front


This may have more then one bulb in the front or possibly a bad socket try wiggling the new bulb in the socket to see if it will work.Compare all turn signal lights that come on the passenger side to those drivers side.Some vehicles also incorporate sidemarker lights with the turn signals.

May 29, 2010 | 2001 Pontiac Aztek

1 Answer

Right turn signal not working on 1992 Ford Explorer Truck


turn on the hazard light so you can identify the bulb that is actually deffective. the procedure to replace can be found on youtube.

Mar 10, 2017 | 1992 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...