Question about 2000 Volvo S40

Open Question

Wiper relay for 2000 s40

Intermittent speed does not work

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
keemo68
  • 1263 Answers

SOURCE: VOLVO S40 2001 HEADLIGHT WIPER MOTORS

you can disconnect the wiper motor from the harness by just removing the plugs don't have to worry about a fuse.

Posted on Sep 05, 2008

Ad
Dan z
  • 3 Answers

SOURCE: VOLVO S40 2001 HEADLIGHT WIPER MOTORS

Behind Headlamp remove wiring clip and tape it off. At the same time tie off the water pipe. That'll do the job quickly. Otherwise removing the whole wiper system isn't a big job.

Posted on Mar 31, 2009

duane_wong
  • 6826 Answers

SOURCE: 2000 S40 Volvo - main

Usually, if the windshield wipers do not park at the right spot, then it's the motor itself, and not the switch. The switch just supplies power to the motor, and the switch also sends a position resistance to the motor.

So, if the problem is that the main wipers are working intermittently, it's not a fuse, it's not the switch, it's the motor assembly, which will have to be replaced to fix this problem.

Good luck on this repair.

Posted on Oct 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiper control module location on a 2000 f250


Did you check the wiper relay's in the under hood fuse box ? There are two ,wiper run/park relay & wiper high low relay ! Also ,did you check fuse's ? fuse # 11 - 30amp location cental juction box . The wiper switch is a input to the GEM module . Generic electronic module . The module in most cases isn't the problem ! Learning how to test these electronic systems is , people do not know how to test so they just replace parts . What they should do is take the vehicle to ford certified Technician who has the knowledge and testing equipment to find an fix it .

The generic electronic module (GEM) receives inputs from the following:
  • multifunction switch
  • anti-lock brake control module (vehicle speed signal [VSS])
  • ignition switch
The GEM uses these inputs to control the outputs to the following:
  • windshield wiper high/low relay
  • windshield wiper run/park relay
  • windshield washer relay
  • rear wiper motor relay
  • rear window washer relay

  • GEM Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1240 Wiper Washer Rear Pump Relay Circuit Failure GEM GO to Pinpoint Test K . B1241 Wiper Washer Rear Pump Relay Circuit Short to Battery + GEM GO to Pinpoint Test K . B1342 ECU is Defective GEM CLEAR the DTCs. REPEAT the GEM self-test. If DTC B1342 is retrieved, INSTALL a new GEM. REFER to Section 419-10 . B1431 Wiper Brake/Run Relay Circuit Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
    If the windshield wipers stay on continuously, GO to Pinpoint Test C . B1432 Wiper Brake/Run Relay Circuit Short to Battery GEM GO to Pinpoint Test B . B1434 Wiper Hi/Low Speed Relay Coil Circuit Failure GEM GO to Pinpoint Test D . B1436 Wiper Hi/Low Speed Relay Coil Circuit Short to Battery GEM GO to Pinpoint Test D . B1438 Wiper Mode Select Switch Circuit Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
    If both the windshield and rear window wipers are inoperative, GO to Pinpoint Test L . B1441 Wiper Mode Select Switch Circuit Short to Ground GEM GO to Pinpoint Test C . B1446 Wiper Park Sense Circuit Failure GEM If the intermittent windshield wiper speed does not operate correctly, GO to Pinpoint Test E .
    If the speed dependent interval mode does not operate correctly, GO to Pinpoint Test G .
    If both windshield and rear wipers are inoperative, GO to Pinpoint Test L . B1450 Wiper Wash/Delay Switch Circuit Failure GEM If the intermittent windshield wiper speed does not operate correctly, GO to Pinpoint Test E .
    If the wash and wipe function does not operate correctly, GO to Pinpoint Test F .
    If both the windshield and rear wipers are inoperative, GO to Pinpoint Test L . B1453 Wiper Wash/Delay Switch Circuit Short to Ground GEM If the windshield wipers stay on continuously, GO to Pinpoint Test C .
    If the wash and wipe function does not operate correctly, GO to Pinpoint Test F . B1458 Wiper Washer Pump Motor Relay Circuit Failure GEM GO to Pinpoint Test F . B1460 Wiper Washer Pump Motor Relay Coil Circuit Short to Battery GEM GO to Pinpoint Test F . B1473 Wiper Low Speed Circuit Motor Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
    If the windshield wipers do not operate at high or low speed correctly, GO to Pinpoint Test D .
    If the intermittent windshield wiper speed does not operate correctly, GO to Pinpoint Test E . B1475 Accessory Delay Relay Contact Short to Battery GEM REFER to Section 501-11 . B1476 Wiper High Speed Circuit Motor Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
    If the windshield wipers do not operate at high or low speed correctly, GO to Pinpoint Test D .
    If the intermittent windshield wiper does not operate correctly, GO to Pinpoint Test E . B1611 Rear Wiper Mode Switch Circuit Failure GEM GO to Pinpoint Test H . B1614 Rear Wiper Mode Switch Circuit Short to Ground GEM GO to Pinpoint Test I . B1820 Rear Wiper Motor Up Relay Circuit Short to Battery + GEM GO to Pinpoint Test H . B1839 Rear Wiper Motor Circuit Failure GEM GO to Pinpoint Test H . - All other DTCs. GEM REFER to Section 419-10

Jun 06, 2017 | Ford F-250 Cars & Trucks

2 Answers

What is the relay location in the relay box


The problem would be in the stalk controller. The wiper Relay is what provides power to the motor for all settings, the delayed wipers, low speed, and high speed. There are not 3 relays, but 1 for all functions. If you have power to the high setting, the relay is working.

Jul 27, 2014 | 1998 Ford Ranger

1 Answer

How to find and check wiper relay on 2000 intrigue


03 Ascender but what is and Intrigue? (apples and oranges, diffr)
built at:
GM Fairfax plant in Kansas City, Kansas,
2000 Oldsmobile Intrigue in wrong forum, my guess.
why not post the symptoms first. dead on all speeds, and does
it have the intermittent option?
why assume there is a relay?
would not the fuse be first.? if dead?

wiper not washer is FUSE WPR 25amps.
does the wiper work on WASH mode, 1 swipe. (trick 1)
does the wiper run on any speed? (sop)
no and no.the fuse is blown
to test fuse, use a voltmeter.
Keyon
12vdc on both sides of WPR fuse, is a good fuse. no lies, no guessing. fuses that look blow are blown but some that look ok
are in fact blown (due to hairline cracks only mini mouse can see)

there IS NO RELAY. soRRY, i can add one if you like (LOL)

here it is.



24050665-5afre3fjdbg1gkzo1rpx5eib-5-0.jpg

Apr 09, 2014 | Oldsmobile Cars & Trucks

1 Answer

Loss of Intermittent Wiper speed on a Geo Metro


could be either but i would go for the relay first

Oct 23, 2009 | 1994 Geo Metro

1 Answer

Windshield wiper does not work on INTERMITTENT or


replace the motor.it will stop being goofy after that i promise

Aug 14, 2009 | 2000 Honda CR-V

2 Answers

Wipers do not work in intermittent position. They do work in low and high speeds but do not automatically return to the park position. They stop wherever you turn the switch off.


i belive that your wiper switch has gone out on the intermittent side. this is a very common problem.
I hope this helps you
Thanks
Please leave rating

Apr 21, 2009 | 2000 Isuzu Amigo

1 Answer

Intermittanwipers t inop on renault cleo


try replacing the wiper relay

or could be a faulty wiper intermittent part of the switch

Apr 11, 2017 | 2003 Renault 181

1 Answer

VOLVO S40 2001 HEADLIGHT WIPER MOTORS


Behind Headlamp remove wiring clip and tape it off. At the same time tie off the water pipe. That'll do the job quickly. Otherwise removing the whole wiper system isn't a big job.

Aug 01, 2008 | 2000 Volvo S40

1 Answer

Porsche Boxster Intermittent wiper does not work


possibly a relay the one for intermittent wipers is #16 front under dash relay panel

Jun 13, 2008 | 2003 Porsche Boxster

Not finding what you are looking for?
2000 Volvo S40 Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...