Question about 2004 Toyota 4Runner

3 Answers

How to fix a back left turn signal?

Back tail light was out and replaced light which is now working. signal is not working.. how do I fix Left back turn signal?

Posted by on

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 2,963 Answers

Wild guess, in the process of fixing the tail light, you disturbed the signal connections. Go back through your work carefully, see if something is loose or bad connection.

Posted on Apr 10, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,326 Answers

Bad ground or bulb

Posted on Apr 11, 2015

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 4 Answers

Check the connection to make sure it is tight or replace the bulb

Posted on Apr 11, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace left rear brake light bulb


1) Open trunk
2) Remove small round plastic access panel with a flat tip screw driver by prying open
3) Remove flat tip screw holding tail light assembly
4) Remove tail light assembly by pulling outward, careful not to break plastic guide/nub
5) Disconnect wiring connectors
6) Remove plastic housing access plate on back of tail light assembly by twisting/turning tabs until they click and then lift access plate from tail light assembly
7) When viewing the the bulbs, the turn signal bulb is the bottom left bulb
8) Install in reverse order, ensuring tail light seal seats properly during installation

Oct 13, 2014 | 1999 Audi A4

2 Answers

2007 chevy impala brake light and left turn signal not working


Fast flashing dash signals mean there is a bulb issue-DEFINATELY!

Aug 07, 2012 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

1988 jeep comanche wiring


drove mine to the ends of the earth,
there are 4 books,
big main , engine,and one for trans, no PDFs back then so, none sold. just paper books.
its and old car, very old, not too many left run 1988
with that nasty French REniX EFI system/.end rant
I had the 1988 XJ too, a pair of jeeps. then....


i can see your wiring is all messed up
and grounds.

got a voltmeter,
if not only guessing and wire inspections may work
ever consider get a sparks guy to fix it? He can and easy.
I promise.
for me to teach you electrics in this box, is over the top hard.

id have inspected all those wires, every inch
and #1 is trailer wiring hacks at the rear.
the tails are not tails
if you its Parking lamp after the front parking lamps or side markers can not be called TAIL,but yes, some fuses are still using the old 1884 now TRAIL name
check fuses yet, means test them ones that look good test.
using a METER.

.
.i see there are shorts on the KEY switch IGN out pin
for sure.!! radio is off key OUT and off.
or that wires IS SHORTED
harness messed up near steering/cluster,big time.

Feb 28, 2017 | Jeep Comanche Cars & Trucks

2 Answers

Left rear turn signal light on my 1999 chev. s10 is not working


any increase in bink speed is direcly related to a bulb being burt out.

Jun 12, 2009 | 1999 Chevrolet S-10 Pickup

1 Answer

Rear brake lights don't work


you prob got a trailer plug prob bad wires if not tail lights run through turn signal switch tell fix ya bout me ok

May 23, 2009 | 2005 Chevrolet Silverado 2500HD 2WD

1 Answer

2006 Chevy Trailblazer Tail Lights


There was a recall on this, take to the dealer and they will replace the whole socket on this.

Nov 06, 2008 | 2006 Chevrolet Trailblazer

3 Answers

Trailer wiring for 06 GMC Canyon 4x4


exactly what does it do? please explain what happens when you press the brake turn on the light than brake signals ect.....

Aug 13, 2008 | 2006 GMC Canyon

Not finding what you are looking for?
2004 Toyota 4Runner Logo

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...