Question about 1991 Jeep Wrangler
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: catalytic converter
HI, this guide will help you with this replacement.
Step1 Lift your jeep. Unfortunately, the catalytic converter sits about midway down the length of your jeep, so lifting one end or the other will not do. Ramps are your best bet to get you within reach of the parts when working from home. Luckily, this is usually the hardest part of this repair. Step2 Be patient with the bolts, as they are often hard to remove due to size and awkward placement. You may have to drill or saw bolts to remove them. With this in mind, you should pick up new bolts, nuts and seals for your replacement project. Step3 Buy a catalytic converter specific to your jeep to avoid extra work. A generic part must be welded into the jeep, while a vehicle-specific model comes pre-welded to the proper pipes for easy bolt-on installation. Step4 Remove the 02 sensor (with an O2 wrench) before unbolting the catalytic converter. Then, you should remove the pipe connecting the sensor to the converter. Depending on your exhaust system, you may have to remove more pipes before you unbolt the converter from the muffler. Step5 Replace the old catalytic converter with a new one. This should be the easy part, as you simply bolt the new part in place. Step6 Reattach the exhaust pipes and 02 sensor, and the basic job is done. Make sure you replace any cracked or rusty pipes while you have the exhaust system apart.
Posted on Apr 20, 2009
SOURCE: 1991 jeep wrangler clutch
U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.
Posted on May 13, 2009
If it has flanges on both ends, just unbolt it and replace. If it has welded pipes you will need to cut it off and use adapter sleeves and clamps. Really not rocket science...at worst, you may need to remove the hangars on the rear portion of the system to get enough room to install.
Posted on Jun 17, 2009
It sounds as the voltage regulator which is built into the back of the alternator has stuck. Occaisionally this even happens on new ones. Would suggest taking the alternator back as it shoud be under warranty.
Posted on Jul 06, 2009
Tips for a great answer:
Feb 05, 2015 | 1991 Chevrolet Camaro
Jan 04, 2014 | Jeep Wrangler Cars & Trucks
May 27, 2011 | 1991 Jeep Wrangler
Dec 20, 2010 | Audi A6 Cars & Trucks
Nov 26, 2010 | 1991 Jeep Wrangler
Sep 15, 2010 | 1991 Jeep Wrangler
Mar 11, 2010 | 1990 Jeep Wrangler
Oct 20, 2009 | 1989 Jeep Wrangler
Jul 10, 2009 | 1992 Jeep Wrangler
Mar 04, 2017 | 1991 Jeep Wrangler
44 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: