Question about Jeep Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
1) Remove the driver door panel 2) Remove the lock 3) Remove the switch from the back of the lock 4) Pull the switch cord assembly to the bottom of the door cavity 5) Unplug and remove the switch assembly from the car 6) Either (a) short the female end of the plug, or (b) ground the striped wire to the car door.
Normally, you would insert the key in the drivers door, turn left, then right to disarm and reset it. If yours is malfunctioning, you can disable it for good by doing the following:
The FACTORY ALARM DISARM WIRE IS purple/yellow |-| in the driver kick panel area, at the black plug.
Once Located, splice into this wire with a simular guage wire, and put it to a solid chassis ground. This terminates the alarm functions entirely.
Go to the passenger side door and lock/unlock 2 or 3 times to deactivate the alarm switch in the door latch. If battery is weak/low it wont solve problem, must replace battery.also check for broken hood pin switch($5.00) as they are likely to be broken on a 94 veh. and when failed will cause security system to activate causing security light on dash and no start condition/lights flashing etc
Posted on May 14, 2008
you need to find out which wires go to what like the ones going into the alarm and the ones coming from the car u might have to put them back together..hopefully they are color coordinated for you good luck
Posted on Oct 27, 2008
My 97 Jeep Grand Cherokee was doing the same thing. I changed the TPS ( Throttle Position Sensor) Now it is great goes into overdrive fine. It is really easy to change.
Posted on Feb 11, 2009
You may have left a door half open, or have a bad door switch. Until you find out what the problem is you can manually push your door locks with your hand to lock them without arming the alarm and still have your vehicle locked, and not have to worry bout hte alarm.
Posted on Oct 07, 2009
Testimonial: "Thanks a lot. Feel safer knowing how to lock up car without alarm going off. Will also look into whether I have a bad door switch."
Tips for a great answer:
Sep 20, 2015 | 1993 Jeep Grand Cherokee
Apr 17, 2015 | 1997 Jeep Grand Cherokee
Aug 11, 2014 | 2000 Jeep Grand Cherokee
Aug 03, 2014 | 2001 Jeep Grand Cherokee
Sep 20, 2010 | 2000 Jeep Grand Cherokee
Jan 28, 2010 | 1999 Jeep Grand Cherokee
Apr 25, 2009 | 1994 Jeep Grand Cherokee
121 people viewed this question
Usually answered in minutes!