SOURCE: Hyundai Tucson
The transmission filter is inside the transmission. You have to drain out the oil and remove the transmission pan and gasket. The filter is made of metal guaze and is screwed/bolted to the underneath of the valve body.
SOURCE: Hard to get my tucson in gear
Check you have no air in the clutch fluid.Bleed the system.If that does not cure the problem then if you have good pressure at the pedal you pressure plate is faulty.Then the only solution is to replace the clutch.
SOURCE: hyundai tucson 2 liter crdi gear box sound its a
Hi there, the Common Rail Diesel Inyection (CRDI) 2000 cc 112 Hp M/T have a big trouble on cluth plate, and sounds very loud between 1500 and 2000 rpm on 2,3,4 shift.That motor has too much torque and cause excesive wear in the cluth roll and plate so starts roominess in the cluth system. You could change those parts but quickly the sounds come again. Hyundai is the resposable of that damage. I hope in the near future recall the CRDI model 112 Hp and replace the cluth.
SOURCE: need to know what these codes mean for hyundai
P1529- TCM MIL request signal failure
P1404- DTML Heater circuit failure
P0722- ATM Output speed sensor no signal
All these together indicate a possibly cut wiring harness failure, or other major circuit issue.
SOURCE: I Have A 2000 Hyundai
P1529 - MIL light request
P0722 - Transmission Pulse Generator B. The Pulse Generator detects the revolution of the idler gear parking
pawl lock gear and emits a pulse signal. The pulse signal is sent to the
Transmission Control Module (TCM) which converts it into vehicle speed. The code is detected when the Pulse Generator B failed to provide a signal to the TCM upon initial movement of vehicle.
Symptoms:
- Engine Light On (or Service Engine Soon Warning Light)
- Speedometer improper reading
- Possible shifting problems
Possible Causes:
- Pulse Generator B harness or connectors
- Pulse Generator B circuit is open or shorted
- Pulse Generator B
Trouble Code: P0722
A/T Pulse Generator 'B' Sensor Circuit Malfunction
Possible Causes:
Pulse generator 'B' (+) or (-) circuit is open or shorted to ground .
Pulse generator 'B' is damaged or has failed.
TCM has failed .
TSB 01-40-006-1 (12/01) contains information about this code.
Trouble Code: P01529
Customer Snapshot Request Error
Possible Causes:
Transmission control module error.
Check for trouble codes in the transmission control module.
TSB 1-40-005 (3/01) contains information about this code. I have info. on these 2 codes,will search more for the others.
144 views
Usually answered in minutes!
×