Question about Toyota Pickup

2 Answers

How do i fix the bearings on a 1999 toyata pick up

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has answered 20 or more questions within one hour.


    An expert who has answered 20 questions.

  • Expert
  • 147 Answers

Are you referring to bearings in the engine, differential, wheels or another location? These parts aren't intended to be repaired once they fail. You have to replace them, and make sure that they aren't too tight (wheel bearings) or they will fail again. Bearings require a special grease.

Posted on Apr 09, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Toyota Master
  • 50,009 Answers

Bearings cannot be fixed --adjusted --yes but fixed --no
That means that if the bearings are faulty You neglected to say which bearings you are referring to) the fix is replacement only

Posted on Apr 09, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to fix rack and pinion on 1999 chevy silverado 1500

Since this is a truck, you have a gearbox instead of a rack and pinion.
I would expect you to find a faulty ball joint or control arm problem.
I would recommend taking it to a tire shop or someone who does alignments. And get at least two different estimates.

Jul 08, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

How to remove the inner bearing front left axle shaft

small screw driver or pick just comes right out

Nov 19, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

Toyata rav4 has a play in the rear left wheel and the tyre i took off was badly worn from both sides i want to go for 5000km drive before i replace it is it ok

No! You might have an axle bearing ready to fail! Get it checked ASAP and replace the tires before setting off. Be safe.

Mar 17, 2011 | 2002 Toyota RAV4

2 Answers

Power door locks for 1999 toyota 4runner unlock but do not lock on inside switches or remote

I have the same problem I can unlock my toyota 99 4 runner but does not lock on inside switches or remote.

just found out about it today.

Feb 16, 2010 | 1999 Toyota 4Runner

2 Answers

I have a 1999 Chevy Tahoe and my driver side wheel is locked up. Changed the brake caliber, brake pads,brake line, no air in the system, could it be the abs system and if so how can i fix it?

If you have'nt yet replaced the flex hose going to the caliper then it may need to be replaced or unfoald the clamp the hold it to the strut to release the blockage caused by rust build up,if there is no wheel speed picked up by the abs then it does'nt come into play.

Nov 16, 2009 | 1999 Chevrolet Tahoe

1 Answer

1999 Toyata Corolla will not start unless accelerator is depressed. Only continues to run in neutral/park if accelerator is depressed. If shifted to drive engine dies. What are the possible explanations?

check and clean/replace (idle air control) IAC valve. Its probably sticking or motor may be dead, replacing the unit is recommended. This unit controls your engine idle. Hopefully this helps

Aug 16, 2009 | 1999 Toyota Corolla

1 Answer

Windshield fluid coming out but very slow on 99 tercel

If the windshield fluid is coming slowly then nozzles are clogged you need to
use a safety pin and clean the nozzle on the hood and adjust the nozzle ....

Feb 23, 2009 | 1998 Toyota Tercel

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides