Question about Plymouth Cars & Trucks

1 Answer

2000 Plymouth Neon will drive fine then stall. Does not start again without jump start then dies when put in gear. What could be causing it?

Posted by Anonymous on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 227 Answers

Check all your cables at both the battery and Body and Engine for tightness, corrosion and correct them

Posted on Sep 27, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1995 pontiac bonneville stalls

I just went through lots of troubleshooting and expense on my 1996. Whenever I would lift my foot off the accelerator and was below about 30 mph, the rpm's would starts jumping around and sometimes it would stall. If I gave it a little gas (accelerator), I could sometimes keep it running. It also backfired once in a while. Starts right back up. Also, if I let it idle while in part, it would die after 1-2 minutes.

I ended up finding a hole in the fuel regulator. About a ~$70 part if you get an AC Delco, but very simple to change.

Posted on Dec 24, 2008

keeperoffire
  • 106 Answers

SOURCE: engine stalls when put into gear, idle fines in park

This is a comon problem with GM cars.Most likely cause is the torqe converter clutch lock up solenoid.

Posted on Mar 04, 2009

  • 1 Answer

SOURCE: 2000 dodge neon high idle

you might need a new idle air control module, dont adjust your idle

Posted on Feb 20, 2010

  • 19 Answers

SOURCE: 97 plymouth voyager dies

This sounds like a fuel problem, I would check the IAS( Idle Air Speed) motor located on the throttle body , possibly a wire problem try wiggling them first to see if it changes the idle speed or stops the surging your referring too ! has a check engine light come on at ant time ?

Posted on Apr 09, 2010

  • 373 Answers

SOURCE: 1991 Dodge Dynasty LE

Sounds like you are having a fuel problem with the fuel filter. If you have not had your car serviced in quite awhile i would do so. At least change the fuel filter and check the air filter as well. Hope thias will help you.

Posted on May 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Got 2000 dodge neon will start when cold run good but when motor warms up won't start


Nikki is the engine light on, are there any codes,have you had a tune up or any other work done lately.when you say it won't start when warm(do you mean engine will not turn over, or does engine turn and refuses to fire.
If I had to guess failing fuel pump, they tend not to build fuel pressure when ran a while(warmed up) and when left to cool build somewhat better pressure.
press the helpful button

Is Your Fuel Pump Going Bad
How do know if its fuel filter or fuel pump that is causing the problem
How To Diagnose Fuel Pump Failure EricTheCarGuy
http://www.clarks-garage.com/shop-manual/ts-01.htm#hot-start

Feb 05, 2016 | Dodge Neon Cars & Trucks

1 Answer

My 2000 Plymouth neon with a 2.o liter engine idles rough in gear and sometimes backfires though the throttle body what can be causing these problems?


Timing belt slipped a tooth, stuck valve, plug wires crossed, or a very lean condition.

I suggest not driving it until the timing belt is inspected or replaced

Feb 26, 2015 | 2000 Plymouth Neon

1 Answer

Transmission or altenator?


I would say change the alternator out. Start with the simplest and cheapest factor first. Without the alternator keeping the engine running its hard to put it any gear.

Sep 26, 2013 | 1995 Lexus LS 400

1 Answer

1996 mercedes c280 dies when put in drive


Engine stalls or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 15, 2012 | 1996 Mercedes-Benz C-Class

1 Answer

2000 plymouth breeze 2.4 jumped timing and now leaking antifreeze.


that would'nt make any difference to water pressure! may be possible that your vehicle was overheating! overheating caused excessive pressure in the system, which popped(The noise you heard) one of the hoses, or a connection!

Car stalled from over heating!

Apr 27, 2012 | 2000 Plymouth Breeze

1 Answer

1996 plymouth neon 2.0 sohc starts up fine, runs good untill it warms up about 20 min, to 1/2 hour then starts losing power, starts spiting and spudering and when giving gas wants to quit? then it...


well its a long shot but it could be your catalytic converter is going bad or is clogged, i have seen them get so hott they glow red. this sometimes can be seen at night by looking under your car after it has ran to the point of stalling and dieing,, if thats the problem the car cant exhaust creating back pressure that robbs power and can cause your car to die.. after it cools the metal shrinks back and the car will runn again untill it getts hott.. i hope this helps

Jun 01, 2011 | 1996 Plymouth Neon

2 Answers

Car stalls while driving


you have a bad crankshaft sensor. replace the crank sensor.

dodges and gm's are known for this problem.

Apr 10, 2009 | 1998 Plymouth Neon

1 Answer

Running and stalling


i would look into the EGR valve that is usally the problem.

Jan 30, 2009 | 2000 Dodge Neon

1 Answer

Plymouth neon 1996 4 cylinder


Get those new codes, sure sounds like a MAF issue, also I have run across engine movement stalls, they turned out to be a break indside the engine harness, when the engine moved it would break the connection and stall or run really bad, I found these kinds of problems by pulling and twisting the harness to the engine, then I would cut it open and do the same thing wire by wire.

Oct 18, 2008 | 1996 Plymouth Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...