Question about 1995 Mitsubishi Mirage
If this is just the brake lights that are not working, it might be the adjustment of the brake light switch, or the wiring between the brake light switch and the brake lights.
Posted on Jun 26, 2016
Well the brake-turn signal and tail lights are on two different circuits, but share a common ground.
If the ground is good, and the parking and turn signals work in the front, it could be a wiring problem.
Posted on Apr 09, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check the brake light fuse. The high mounted brake light (third brake light) is on a different circuit than the brake lights. Hope this helps.
Posted on May 23, 2009
SOURCE: 97 CAMRY TAIL LIGHTS PROBLEM
You are right you do have a short,but it's easy to fix at the same time it is expensive. In your trunk area you will find a bulb out relay it can be either in the right corner or left corner panel in the trunk area,if not there if may be under the rear deck of the trunk(under the rear window inside the trunk) It might be yellow brown or green.One fron the junk yard will work just as good as a new one.If you are skillful you can open it and solder the burned circuit,but you have to know what you are doing.You also neet to find out if you had a bad bulb that shorted so you can rest knowing that what caused it to burn out in the frist place is fixed.
Posted on Jul 23, 2009
I had the same problem and found out that both light bulb sockets had corroded/burned contacts. After cleaning and applying dielectric grease, they worked perfect again.
Posted on Dec 17, 2009
Check the brake light switch should be a orange wire with 12v then a white wire with 12v when the pedal is pressed.If htat cks good then ck the hazard switch by moving it up and down and wiggeling the knob with the brake pedal pressed if they start working then your multifunction switch is bad and needs to be replaced.
Posted on Feb 20, 2010
Testimonial: "We check and you were right on the money. It's the hazard switch carrier. Thanks for you help."
Tips for a great answer:
Oct 26, 2015 | Mitsubishi Cars & Trucks
Jul 04, 2015 | Mitsubishi Cars & Trucks
Apr 09, 2014 | 2001 Mitsubishi Mirage
Aug 25, 2012 | 1995 Nissan Pathfinder
Aug 15, 2011 | 1994 Cadillac DeVille
Jan 15, 2011 | 1995 Mitsubishi Mirage
Oct 03, 2010 | 1996 Mitsubishi Mirage
Oct 12, 2009 | 1997 Mitsubishi Mirage
137 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: