Question about Chrysler Cars & Trucks

Open Question

Why does my 1995 Chrysler LHM have no instrument panel lights or heater?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: No instrument panel lights on 1995 Nissan King Cab

Ye, the dimmer switch still works.

I know this because, when I turn on the left direction flasher, the panel lights pulse dimly on and off with the direction light flasher.

Do I have a defective direction light flasher? if so where is it located?

Posted on Nov 25, 2008

  • 1 Answer

SOURCE: instrument panel on 2003 chrysler Grand Caravan lighting failed

Disconnect the negative battery cable for 10 minute then reconnect this will solve the dash light problem.

Posted on Feb 19, 2009

  • 1619 Answers

SOURCE: INstrument panel light out how to replace

grab both sides of cluster and just pull unit towards you. Nothing holds it in but 4 clips and 4 rubber grommets. Just dont yank too hard or youll pull wires off the back.

Posted on Jul 09, 2009

  • 1 Answer

SOURCE: 2001 chrysler voyager lost dash lights and heater

Your battery terminals are not tight enough. If the leads on top of your battery are just a little loose, then you loose your dash lights and gauges. They come right back when you tighten your battery terminals.

Posted on Aug 17, 2009

emissionwiz
  • 75117 Answers

SOURCE: Heater on 1995 Chrysler Concorde stopped heating.

there are no reset codes, did you bleed the air out of the cooling system? if not do this procedure, if that doeasn't fix it u have a failed air temperasture control blend door motor actuator.
The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling systeml ,

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to know how to access light bulbs in the center panel where the heater controls are. Initially only one control backlight was out. Now light behind the rear control switch is out. Thanks


Dodge Caravan (01-03) Instrument Panel light replacement ...

? 12:25
https://www.youtube.com/watch?v=d9qi78IAPF0
Mar 4, 2013 - Uploaded by ryanthiusjunk
A common issue with the Dodge Caravan (and Chrysler Town ... I just bought a Dodge Grand Caravan (2002) and noticed that the entire dash board didn't light up at night. Needless to say I needto replace all of those bulbs and after ... do you know how to fix the 2009 caravan instrument panel lights going ...

DIY Dashboard Light Bulb Replacement - YouTube

? 8:07
https://www.youtube.com/watch?v=_bf5w3AZR_0
Jan 7, 2013 - Uploaded by Chris Punt
How to replace dashboard lights on a Dodge grand Caravan. ...Most just want to get the bad bulb out and put new one in. it seems to me the ... pull the dash panel out far enough to turn it upside down on the column and ... Bought mine at Advance Auto, but I know it is not a hard bulb to find and can be ...

2001-2007 Dodge Grand Caravan/Chrysler Town and ...





Dec 13, 2015 | 2005 Dodge Grand Caravan

3 Answers

How to troubleshoot


Its the fuse. The dashlights are on the same circuit so that you will know there is a problem

Oct 03, 2014 | 1995 Chrysler LeBaron

1 Answer

Stuck in second gear


IF automatic transmission most likly in LHM

Nov 17, 2012 | 2000 Chrysler 300M

1 Answer

1991 lebaron check engine light won't come on


Hi Trye, If the vehicle starts and the engine check fails to come on the lamp may have blown? If so you'll need to take out the instrument panel to replace it. If it fails to come on and the vehicle fails to start, replace the EFI fuse and try again. Regards John

Jun 07, 2012 | 1995 Chrysler LeBaron

1 Answer

How do you get the heater core out of a 1995 Ford Explorer XLT? Thanks


You have to remove the instrument panel, discharge the a/c and then remove the heater/ A/C plenum from the firewall to access the heater core. BIG JOB for a do-it-yourselfer.

Feb 28, 2011 | 1995 Ford Explorer

2 Answers

How do i fix the heater core on my ford taurus 1995


Hi there,

Remove heater/evaporator case. Remove vacuum source line from heater core tube seal. Remove seal from heater core tubes.
Remove heater core access cover screws. Remove access cover and seal from heater/evaporator case. Lift heater core and case seals out of heater/evaporator case.
Installation
If installing new heater core, transfer case seals to new core. Install heater core and seals into heater/evaporator case. Install heater core access cover on case. Install seal on heater core tubes. To complete installation, reverse removal procedure. Evacuate and charge A/C system. Refill cooling system.

HEATER/EVAPORATOR CASE
Removal
  • Disconnect negative battery cable. Drain coolant from radiator. Gently pull instrument panel away from right side of dash panel.
  • Discharge A/C system using approved refrigerant recovery/recycling equipment. Disconnect heater hoses from heater core. Plug heater core tubes or drain coolant by blowing coolant from heater core using low pressure compressed air. Disconnect vacuum supply hose from inside engine compartment.
  • Disconnect A/C lines from evaporator core. Plug A/C lines and evaporator core tubes. Remove instrument panel assembly brace to evaporator case bracket screw. Remove assembly brace.
  • Remove floor register and rear floor duct from bottom of heater/evaporator case. Remove nuts securing heater/evaporator case to firewall. Remove 2 screws securing support brackets to cowl top panel. Carefully pull heater/evaporator case away from firewall. Remove heater/evaporator case.
  • To install, reverse removal procedure. Evacuate and charge A/C system. Refill cooling system.
INSTRUMENT PANEL
Removal & Installation
  • Position front wheels in straight-ahead position. Disable air bag system. See AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIPMENT section. Disconnect negative battery cable. Remove steering column trim shrouds.
  • Disconnect all electrical connections from steering column switches. Remove cover from under steering column. Remove 4 bolts and reinforcement from under steering column. Disconnect parking brake release control motor from parking brake and ignition switch connector.
  • Disengage insulator retainer. Remove insulator. Remove 4 nuts and reinforcement below steering column. Remove 4 nuts securing steering column to instrument panel and lower column to front seat. Disconnect PRNDL cable (A/T models).
  • Ensure ignition switch is locked to prevent steering column from turning. Remove 4 instrument cluster retaining screws. Disconnect speed control cable and vehicle speed sensor (if equipped). Disconnect electrical connectors and remove instrument cluster. At steering column opening, remove one bolt securing instrument panel to brace. Remove one instrument panel brace bolt (below radio area).
  • Remove sound insulator under glove box by removing 2 push nuts securing insulator to studs on climate control case. Remove glove box door and compartment. Remove air cleaner housing, battery and battery tray. Disconnect wires of main wire loom in engine compartment. Disengage rubber grommet from firewall. Feed wiring into passenger compartment through hole in firewall.
  • Remove right and left kick panels. Disconnect wires from instrument panel at right and left kick panel sides. Remove screws on left and right sides of instrument panel.
  • Pull up to unsnap right and left speaker opening covers. Remove speaker covers. Working through steering column and glove box openings, reach under instrument panel and disconnect electrical connectors, vacuum hoses, A/C-heater control panel cables, and radio antenna cable.
  • Support instrument panel. Remove 3 screws attaching top of instrument panel to cowl top. Disconnect remaining wires. Remove instrument panel. To install instrument panel, reverse removal procedure.

Hope this helps...

Jan 17, 2011 | 1995 Ford Taurus

1 Answer

Fan blows, but heater display doesn't light up. blows out cold air only. no heat


Check fuses to the A/C or Heater Control Unit in the fuse box(es). IF none are blown, then may have to replace A/C-Heater Control Unit:

A/C-Heater Control Unit Removal & Installation To Remove:
  1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
  2. Remove or disconnect the following:
    • Negative battery cable
    • Center bezel from the instrument panel A/C-Heater Control chr_pacif_ac_htr_cntrl.gif

    • Three screws that secure the A/C-heater control to the instrument panel
    • A/C-heater control from the instrument panel
    • Two wire harness connectors from the control
To Install:
  1. Install or connect the following:
    • A/C-heater control to the instrument panel
    • Two wire harness connectors to the back of the A/C-heater control
    • A/C-heater control into the instrument panel
    • Three screws that secure the A/C-heater control to the instrument panel
      1. Torque to: 17 inch lbs. (2 Nm)
    • Negative battery cable and calibrate the A/C-heater control
prev.gif next.gifprev.gif

Nov 06, 2010 | 2005 Chrysler Pacifica

1 Answer

Instrument panel on 2003 chrysler Grand Caravan lighting failed


Disconnect the negative battery cable for 10 minute then reconnect this will solve the dash light problem.

Dec 16, 2008 | 2003 Dodge Caravan

1 Answer

No instrument panel lights


Have u tested the dimmer switch for the instrument panel lites? it is near the hd lite switch, they are a common cause of the problem, very common, also have found that allot of folks don't know there dimmer is trurned off.

Dec 13, 2008 | 1995 Mercury Sable

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...