Question about 2008 Ford Ranger

1 Answer

I have 08 ranger fuel pumps to the new injector I have spark wont start cylinder is dry is there a controller for the injector

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 42,026 Answers

Yes and it is the ECM
run the fault codes to find where the fault is

Posted on Apr 09, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: no start,91 regal 3.8 w motor

sounds like an ignition module

Posted on Aug 02, 2008

  • 9 Answers

SOURCE: 1992 ford ranger

If this speratic problem seams to happen most when it's raining or damp, it is a shorting master contol that is to blame. The master control mother board is located on the firewall. Over time, the moisture seal on the cover fails and the motherboard gets damp and meny false signals are sent. This can even happen if the truck is off and key is not in the ignition (this mother board will alwas have power going to it as long as the battery is connected). A cheap way to check this is to remove the cover, put a plastic grocery bag over the mother board and use an small elastic band to close the open end, allow the wires connected to the mother board to go out the open end. If this solves the problem, replace the seals on the master control cover. Care should be taken as if there is ANY corrossion on the mother board, it will need to be replaced.

Posted on Oct 28, 2008

  • 1 Answer

SOURCE: Injectors are not opening on a 1992 buick century 3.3

One or more of your fuel injectors are defective. I have a 1991 Olds Ciera 3.3L V-6. It had the exact same problem as your car did.I had checked the pressure,which is 40 psi at the fuel rail. I also replaced the fuel filter,checked the crankshaft sensor,and throttle sensor. Still had the same problem. Cleaned the throtte body intake. What i finally found was a bad #4 fuel injector. Take a multimeter,diconnect the electrical connectors of each injector,check the resistence of each injector over the 2 electrical connectors ,they should be between 12 and 14 omes. The ones that are NOT passing the test(or the ones that don't match up),replace. The computor (EMC) ,will not let the engine start,if one or more injectors are defective.

Posted on Apr 25, 2009

SOURCE: 1988 ranger 2.9 no fuel pressure new pump

check the pulse on the injector wire with a noid lite or a meter. If no flash then you most likely need a computer. Its called a quad driver in the PCM thats fried. You may have a shorted component that caused it to fail.

Since you say it will run if you add fuel manually I don't suspect the crank sensor because you have spark.

Posted on Aug 15, 2009

Testimonial: "Thanks much ill check in am"

roniecon
  • 6826 Answers

SOURCE: ford ranger 4 cyl 94. won't start. fuel pump works

Check the timing belt,most likely has jumped time.

Posted on Jan 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What it to flooding out wont starter because to much gas


You could pull the fuel pump fuse to dry out the cylinders.
Could be a faulty fuel pressure regulator, injector(s) or wiring problem.

Apr 02, 2016 | 2000 Ford Ranger SuperCab

2 Answers

No fuel in one cylinder 1998 ford ranger


Either has a bad injector or the wiring to that particular injector has been pinched or skinned and grounded somewhere.

Feb 20, 2015 | 1998 Ford Ranger

2 Answers

I have a 1987 ford ranger the engine turns over but it wont start


Spark at plugs? Fuel filter? Pressure on injector delivery line? Pressure relief valve? You may be able to measure fuel pressure at the pressure relief valve location. and return line. If you have spark, I'd say it's a fuel supply problem

Dec 21, 2014 | Ford Cars & Trucks

2 Answers

I have a 1987 ford ranger the engine turns over but it wont start


Timing could be 180 degrees out try switching plug leads on distributor i.e. 1&3 2&4

Dec 21, 2014 | 1987 Ford Ranger

1 Answer

2001 ranger wont start new fuel pump installed what do i do?


Have you checked the relay to see if the pump is getting voltage ?
If the pump is running, did you change the filter ?
Have you checked for fuel pressure at the injectors ?
Are you getting spark to the plugs ?

Jul 23, 2012 | 2001 Ford Ranger Regular Cab

1 Answer

1991 ford ranger 3.0 is hard to start, why?


Hi there:
You will have to pinpoint what the engine is missing... Spark / Fuel / Compression

All three of these are tested when the engine is being cranked over. There are two way of checking for fuel. Fuel pressure and fuel trigger. Both are very important and must be present for the engine to start. Fuel pressure is self explanatory. You just hook up the gage and see what the reading is. Fuel trigger is check with a noid light. The injector gets unplugged and the noid light gets plugged in to the injector clip. With the engine cranking over, this light must blink. This is the signal to the injectors from the computer. You can have all the fuel pressure in the world, but it wont matter if the injector is not pulsing gas into the cylinder like it should.

Compression tester, spark tester, fuel pressure gage and noid light are all accessible at your local auto store. All three tests play a very important part in diagnosing a no start condition. Be extremely careful when doing these tests.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jul 06, 2012 | 1989 Ford Ranger

2 Answers

Cylinders filling with gas


No it cannot. Most likely ur vehcile is EFI (Electronic Fuel Injection), which means that current must be floweing for the injectors and the fuel pump to be working. The pump allows the flow of fuel.

Mar 13, 2009 | 1987 Ford Ranger

Not finding what you are looking for?
2008 Ford Ranger Logo

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...