Question about Kia Cars & Trucks

1 Answer

Where is the p0501 speed sensor located on Kia rio vehicle 2008

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Kia Master
  • 2,494 Answers

Inside the transmission.

Posted on Jul 22, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mecanica03
  • 905 Answers

SOURCE: P0501 Vehicle Speed Sensor (VSS) Range/Peformance Problem

ok, replace the vss , located on the transm. case, its causes others troubleshoots likes abs,brake lights

Posted on Apr 17, 2009

ronaldo_ross
  • 1056 Answers

SOURCE: where i can find vehicle speed sensor for kia sedona 2002

It is mounted on the tail end of the transmission. It has two wires coming out of it typically.

Posted on Nov 14, 2009

Testimonial: "thank you for help full"

  • 67 Answers

SOURCE: location of vehicle speed sensor on 2002 kia rio

IT should be on the driver side pluged into the trans you should be able to see it looking from the front of the car under the hood its held in by one blot.

Posted on Feb 04, 2010

arauzvictor1
  • 466 Answers

SOURCE: knock sensor replacement

Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

Posted on Mar 19, 2010

nicole99wu
  • 1049 Answers

SOURCE: i have a p0501 vss

for the p0501,
Causes:
P0501 DTC trouble code may be caused by one or more of the following:
The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
There is a broken/frayed wire leading to the vehicle speed sensor
The vehicle's PCM is not correctly configured for the actual tire size on the vehicle

Possible Solutions:
The simplest thing to do is to reset the code and see if it comes back.
Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly.
If the wiring and connectors are OK, then check the voltage at the speed sensor. Again, the exact procedure wil depend on your make and model of vehicle.
If everything looks OK, replace the sensor.
hope help.

Posted on Jul 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of vehicle speed sensor n 2006 kia rio


Its mounted to the rear axle housing and both front half shafts.

Jan 11, 2017 | 2006 Kia Rio

1 Answer

P0501 code?


P0501 - Vehicle Speed Sensor (G22): Implausible Signal Possible Causes
  • Wiring/Connectors from/to Vehicle Speed Sensor (G22) faulty
  • Wiring/Connectors from Transmission Control Module (J217) to Engine Control Module faulty
  • Vehicle Speed Sensor (G22) faulty
  • Malfunctioning Left Front wheel speed sensor (in vehicles that don't use a physical G22 sensor)
Possible Solutions
  • Check Wiring/Connectors from/to Vehicle Speed Sensor (G22)
  • Check Wiring/Connectors from Transmission Control Module (J217) to Engine Control Module
  • Check Vehicle Speed Sensor (G22)
  • Check ABS Brakes for faults and diagnose malfunctioning Left Front wheel speed sensor if applicable

Category:

Mar 10, 2016 | 1996 Audi A4

1 Answer

Code P0501


I doubt it.
Code 501 is for a problem with the speed sensor in the transmission which affects the speedometer and shifting.

Jul 23, 2013 | 2006 Kia Sorento

1 Answer

Where is speed sensor located on 2005 kia rio


The Vehicle speed sensor is located on the outside of the transmission.

Nov 08, 2012 | 2005 Kia Rio

1 Answer

I have a p0501 vss sensor error. I've replaced the part, but the engine light will not go off. it's been reset, but it comes right back on after 5 to 10 miles. I have a 2001 kia rio.


for the p0501,
Causes:
P0501 DTC trouble code may be caused by one or more of the following:
The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
There is a broken/frayed wire leading to the vehicle speed sensor
The vehicle's PCM is not correctly configured for the actual tire size on the vehicle

Possible Solutions:
The simplest thing to do is to reset the code and see if it comes back.
Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly.
If the wiring and connectors are OK, then check the voltage at the speed sensor. Again, the exact procedure wil depend on your make and model of vehicle.
If everything looks OK, replace the sensor.
hope help.

Jun 27, 2011 | Kia Rio Cars & Trucks

1 Answer

My 05 Kia Rio's Check engine light is on and I have had the O2 sensor and the speed sensor changed. What else could it be?


if the car is automatic transmission check the speed sensor does the car hav any symptoms?

Feb 03, 2011 | 2008 Kia Rio

1 Answer

P0501 code on 2004 dodge ram, how to repiar


Causes A P0501 DTC trouble code may be caused by one or more of the following:
  • The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
  • There is a broken/frayed wire leading to the vehicle speed sensor
  • The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
Possible Solutions The simplest thing to do is to reset the code and see if it comes back.
Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly.
If the wiring and connectors are OK, then check the voltage at the speed sensor. Again, the exact procedure wil depend on your make and model of vehicle.
If everything looks OK, replace the sensor.
Further Reading Vehicle Speed Sensor (VSS) Description and Operati

Nov 27, 2010 | 2004 Dodge Ram 1500

2 Answers

How do I get to the diagnostic codes for my 2003 Rio. The check engine light has beem on for months but it runs fine so I'm thinking it may be a O2 sensor or something.


take to an auto store most such as auto zone / advanced auto offer the scan for free the code will narrow down where the problem is so u can repair the car

Jun 07, 2010 | 2003 Kia Rio

2 Answers

What is code PO501 mean on kia


i have a po501 code is tis an easy repair?

Dec 21, 2009 | 2001 Kia Spectra

1 Answer

Location of vehicle speed sensor on 2002 kia rio cinco


IT should be on the driver side pluged into the trans you should be able to see it looking from the front of the car under the hood its held in by one blot.

Nov 24, 2009 | 2002 Kia Rio

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

340 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...