Question about 2004 Jaguar X-Type
The airbag is held on by 2 plastic clips, they are shaped like a claw to release them you need a flat blade screwdriver to gently seperate the 2 parts of the claw. (there is a jaguar special tool for the job} insert the driver through the holes in the back of the steering wheel and twist 90 degrees. turn the wheel quarter turn to gain access.pull gently on the airbag at the same time, you need the driver to be the correct size its a bit of a pig to do, make sure you disconnect the battery first. the airbag electrical connectors are delicate so be careful, good luck
Posted on May 17, 2015
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Steering wheel removal
first you want to unplug the air bag. you do this buy removing the plastic surround around the steering column, where the ignition is, just below the steering wheel itself, then you have to remove the air bag by removing the bolts from the back of the steering wheel...
then get a steeering wheel removal kit, autozone has a loan a tool program.
put the steering wheel tool on and turn oit with a wrench adn the wheel will pop off...
Posted on Nov 26, 2008
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
Posted on Aug 14, 2009
As in you want a diagram? Either way, I don't have one but I have managed to remove it. I don't know if this might help but I start off by forcibly removing it by holding on to both sides of the top of the console (where the ash tray resides). Upon removal, I remove the cover of the ash tray by unscrewing two screws on both sides of the cover. These require a cross screwdriver. I then take off the connectors to both of the buttons where the gear lever is. The leather surrounding the handbrake is a bit tricky to remove. Slowly unbutton it then remove the top plastic part; you might lose the little spring that holds the button if you aren't careful. Then open the arm rest. Two Torx screws are located by the pivot point of the arm rest. I'm sorry I can't remember the size (most likely an T8). That's just about it. Hope this helps
Posted on Aug 29, 2009
If I am understanding your post, I believe you do have a levelling
system and it should be near your light switch on the dash. It is
the type of switch that you depress first, it then springs out and
you turn the small knob (just like your instrument panel lights
adjuster next to it.) What you do not have perhaps, if your car is
not fitted with HIDs (high intensity headlamps), is the automatic
levelling system which is a legal requirement when HIDs are fitted
due to the high power of the lights....
if you don't have a self-levelling system then you'll have a manual
system, operated by a knob under the light switch so that you can
adjust to compensate for a heavy load in the rear of the car.
Posted on Mar 27, 2010
Testimonial: "I did see the little knob on the dash under the headlight switch. i thought it was to dim the dash lights i will check it out and let you know. "
First phone your local jag dealer with your vin number
They should be able to locate your code
If this fails go to www.fitaudio.com
This will show how to remove
Posted on Apr 25, 2010
Tips for a great answer:
Dec 06, 2016 | 2002 Jaguar X-Type
Sep 25, 2015 | 2004 Suzuki Forenza
May 09, 2012 | 2003 Jaguar X-Type
Feb 10, 2012 | Ford Cars & Trucks
Apr 19, 2011 | 1998 Mitsubishi 3000GT
Mar 08, 2011 | 1989 Chevrolet K1500
Dec 20, 2010 | 2004 Dodge Ram
Oct 23, 2009 | 2006 Nissan Pathfinder
Jun 30, 2008 | 2001 Ford Focus
439 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: