Question about Ford Cars & Trucks

1 Answer

Can't find fuse box on my 2011 ford fusion the blower motor is not blowing want to check fuse before I go any further

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 116 Answers

Fuse#45 left side of dash, fuse #35 left side of engine compartment

Posted on Apr 07, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2006 ford fusion

were is the passenger fuse box

Posted on Dec 23, 2008

smcacf
  • 12 Answers

SOURCE: 2000 Ford Expedition front air not blowing

TRY JUMPING THE BLOWER MOTOR APPLY 12 VOLTS TO THE MOTOR IF IT STARTS THEN THE PROBLEM WOULD BE THE SWITCH IF IT DOES NOT START THEN THE MOTOR IS THE PROBLEM GOOD LUCK HOPE THIS HELPS

Posted on Jun 25, 2009

SOURCE: blower motor does not work

I had the same problem, replace, replace, replace. Check, check and recheck. What I found was the blower motor resistor, located in the blower squirrel cage area, two prongs and a curly wire, was bad. Took the new one back, (it ohmed out okay, continuity ok, all ok!) replaced it with another, and Bingo, problem solved. Frustrating to say the least. After two relays and a blower switch, and test, test and retest. It was a faulty resistor. Made in Mexico. And no guarentee, even though new, it works. Trial and error. Even the dealer parts are Honcho en Mexico. Thanks NAFTA. You gonna make us all welfare babies.

Posted on Sep 28, 2009

mrgreenz
  • 962 Answers

SOURCE: AC BLOWER NOT BLOWING

The resistor that controls the blower motor. it is a small gadget that has a 2 or 3 wire plug . Replacing the resistor should fix your problem. It is on or near the blower motor. Under the dash. Not easy to remove . But it can be. Please give thumbs up if helped.

Posted on Jan 21, 2010

  • 166 Answers

SOURCE: which fuse box has blower motor fuse on 2001 chev impala

There is a blower motor resistor located up under the passenger side dash. I believe there is actually 3 fuses that can cause problems with the blower....relays/fuses should be located in the engine compartment fuse block. They are High Blower fuse-HVAC fuse-Radio/HVAC/RFA/Cluster/etc...fuse. Hope this helps.

Posted on Feb 27, 2010

Testimonial: "again thanks much"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2011 for fusion sel.I would turn the heat on and nothing let it on and it would come on by it self or if I hit a bumb. But now I turn the heat on and nothing


https://s16.postimg.org/45t9z2551/auto_hvac.jpg

Click on the link.
Your saying the blower motor won't work? I can help with testing, but, you have to do the testing.
I looked at info for automatic hvac, see those two fuses, not only check the fuse, use a test light and check fuse circuit for voltage. As you can see, one fuse is hot all the time, the other fuse goes hot with the key on. See the relay, if you use a jumper wire on load side of relay, terminal 30 and 87, you can bypass the control side of relay.
Any hvac trouble codes? Could be loose wire, loose wiring connector or faulty blower motor brushes. There is a speed control module, also.

Apr 12, 2017 | 2011 Ford Fusion SEL

1 Answer

Where are fuses for blower motor 2011 mustang


Located in the SJB smart junction box , F4 30amp an there is a blower motor relay , an fuse F15 ,10amp an fuse F45 5amp, an a blower motor speed controller ! hope this helps

Mar 23, 2015 | 2011 Ford Mustang

2 Answers

Which fuse number is it for the power auxiliary plug ( aka lighter ) in a 2011 ford fusion


The fuses for the power points (as they are labeled in the manual) are located in the power distribution box under the hood, fuses 22 and 29 (20A each). See the attached pic (I highlighted the fuse locations).
25352598-mo4luhafzixmir02q1pzhzmw-4-0.png

Jan 03, 2015 | 2011 Ford Fusion

1 Answer

My heat doesn't work not blowing or anything defrost comes out slowly


being a 2011, most likely a blower resistor. Could be a blower also. It has to be checked for electricity and ground.

Nov 13, 2014 | 2011 Ford Fusion

1 Answer

Blowing fuses on blower motor 2006 e250 econoline


Both are possible.But it can be blower motor issue mostly.Its taking too load and that's blowing the fuse.How to Test and Replace Blower motor on car? http://repairhelpcenter.blogspot.com/2011/12/how-to-test-and-replace-blower-motor-on.html--------- How to Replace Blower Motor Wheel? http://repairhelpcenter.blogspot.com/2011/12/how-to-replace-blower-motor-wheel.html
----------

Also more help solutions recommended. Click the link below :---
Blower motor replacing for all vehicles? http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html
----------Blower motor Resistor shorting problem? http://schematicsdiagram.blogspot.com/2011/12/blower-motor-resistor-shorting-problem.html
--------This will help.Thanks.

Jan 25, 2012 | 2006 Ford E-250

2 Answers

Ford fusion 2007, blown blower fuse, replaced fuse, works at highest speed only (highest of 4) the other three setings don't work.


hte blower resistor is shot, near the blower motor, have the blower motor checked my guess is that it requiring too much power to run, hence the blown fuse

May 06, 2010 | 2006 Ford Fusion

2 Answers

I have a 1997 ford contour and the AC/Heater blower is not blowing air out. Is there a fuse for this?


fuse in fuse box there are 2 of them 1 under hood marked fuses and 1 under dash or in glove box

happy hunting and check your book

Jan 02, 2010 | 1997 Ford Contour

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...