Question about Cars & Trucks

1 Answer

How can I get my cd player to stop running?

My cd player is acting up it clicks continually, lights flash and it will not turn off when the car in off. I have disconnected the battery and it worked once but now it won't stop.

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 10,875 Answers

If it works with the battery disconnected,take it to church and have an exorcism

Posted on Apr 07, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: all dash warning lights came

Hatterasnc,

You're alternator has gone bad and the vehicle was running on battery power. The "clicking" sound is your now dead battery that does not have enough power to turn over the starter. You might also want to check your power steering pump for leak. This is a know problem with early LS400s and will most likey be the cause of the alternator failure. I just dropped $1050.00 to fix the very same promblems you have.

Posted on Jul 21, 2008

  • 3 Answers

SOURCE: My running lights will not turn off unless I unhook the battery.

Subaru Outback Legacy Flashing
Q. I have a 1996 Subaru Outback Legacy AWD manual transmission. the hazards flash when I turn the car off. I tried to reset the system by pushing the little black button under the drivers' side dash but it won't reset the system. I had problems with the brakes so I did not drive it for about two months and when I tried to start the car the battery was dead.
mechanic.jpg Now the brakes are fixed but the hazards won't quit flashing and the guy who repaired the car said I needed to reset the system by pushing the little black button. And I don't know if I should have it looked at, or change the battery, or if it is something very simple I can fix by my self.
Thank you very much,
Patrick
A. Patrick, you are the third person in the last two days that has come to me with this same exact problem under the same conditions. As of now I don't have any concrete information on this, but I believe the problem to be in the alarm system.
I believe the battery being disconnected or dying does something to the Anti-theft and Alarm System module and having a Subaru dealer reset the system will correct it.
If you do this and it works, please, let me know and I will pass the information on to the others.
Added 11/7/2003
Dear Mr. Ciulla,
I read your Q&A titled "Subaru Outback Legacy Flashing". I recently had the same problem on my 1996 2.5 liter Subaru Legacy Outback and your response is correct but I can give you a little more detail on what worked for me to stop the light flashing (which occurs sometimes if the battery had been dead):
There is a black reset button under the I/P near the anti-theft module.

  1. Turn ignition on
  2. Hold button 20+ seconds (door locks will lock/unlock 3 times)
  3. Turn ignition off
This also resets the key FOB so as step 2.5 you should also press the "lock" button on the key FOB before releasing the black reset button (door locks will lock/unlock one more time--do this with each key FOB you own). That's all!
The questioner in your Q&A said he tried the reset button; I suspect he either didn't turn the ignition on/off or didn't hold it in for over 20 seconds.
PS... pulling the door lock fuse will stop it temporarily if you can't get the above to work and have to take it to the dealer
Regards,
John
subaru.jpg
Photo Courtesy John Spieth ©2003
Additional Information provided courtesy of ALLDATA

Posted on Nov 26, 2008

  • 140 Answers

SOURCE: After dead battery, radio won't work. lights...

you need to call your local dealership and they will give you the code to reset you radio.. good luck keith..p.s. remeber to write down the codes, that way if it happens again you will have the code for the radio..

Posted on Mar 21, 2009

BPALepine
  • 61 Answers

SOURCE: After dead battery, radio won't work. lights flashing

First I would try to disconnect the negative cable and then reconnect the cable. See if it resets.

Posted on Apr 08, 2009

  • 1 Answer

SOURCE: Cd's are stuck in cd player and will not eject,

i have a 2005 kia Amanti. i believe a cd is stuck and the cd palyer will not rptate or eject. does anybody have a solution?

Posted on Oct 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

Check engine light began flashing, engine runs rough


How long since a tune-up?
Are there any applicable trouble codes?
What is year--make--model?

May 01, 2016 | Cars & Trucks

1 Answer

Will a bad battery make the cd player act weird and keep making noise when car is turned off


Not likely... If it was the battery then it wouldn't hold a charge as well and possible burn out your alternator.

Most common problem with the stereo in your car is the CD player/changer.
The load/unload mechanism gets jammed or the gears wear out and it continuously tries ejecting.

Jul 06, 2014 | 2006 Pontiac Vibe

1 Answer

Cd player doesn t work


go to maintenance shop for checking it properly

Feb 27, 2014 | Chevrolet Cars & Trucks

1 Answer

Cd stuck player


Take it to a store that installs radios and CD players in cars, like Best Buy. Go into the installation shop area. Explain what happened and sweetly ask one of the guys to help you remove the CD. He will probably do it for you for free. Give him some money anyway (and a big smile).

Jan 05, 2014 | 2005 Kia Amanti

1 Answer

O/D off light keeps flashing.


Try turning the O/D on and the flashing should stop

Oct 14, 2012 | 2004 Ford E-350 Super

1 Answer

After half an hour of driving cd lock start's flashing


CD HAS A GREASE FINGER PRINT SPOT ON IT CAUSE CD PLAYER TO LOCK START FLASHING.TURN OFF CD PLAYER FOR A LITTLE WHILE.THEN EJECT CD.SOME TIMES CD PLAYER WILL GET HOT CAUSE IT TO SKIP AND LOCK UP.IF IT DOES IT ALL THE TIME CD LENS NEED CLEANING OR PLAYER IS FAILING.IF ONE CD ACT UP ALL THE TIME.CD IS FAULTY.HAS FACTORY DEFECT OR DEEP SCRATCH IN IT.

May 12, 2011 | Mitsubishi Outlander Cars & Trucks

1 Answer

After dead battery, radio won't work. lights flashing


First I would try to disconnect the negative cable and then reconnect the cable. See if it resets.

Mar 21, 2009 | 2004 Dodge Intrepid

1 Answer

2004 Jetta


I am having some issues with the fuel pump we suspect. The fuel pump is located in the fuel tank and occationally I can hear a motor running secondary to starting the diesel. As things have progessed i initial thought perhaps I had a hole in my muffler, but my mechanic has assured me that is not the case. The fuel pump may be a good place to start.

Aug 03, 2008 | 2004 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...