Question about 2000 Mercury Sable

1 Answer

My mercury sable 2000 Spark plugs dont have spark. What is the problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mercury Master
  • 42,218 Answers

Run the fault codes
it could be from cam/crank position sensor problems
could be an immobiliser problem
could be a broken timing belt/chain

Posted on Apr 07, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: how do i reach the rear spark plugs on the 24v 3.0L 1999 Mercury Sable

I recently did a tuneup on my 88 sable, and the back spark plugs were a pain to get to. However, it didn't require any special procedures. You may want to try getting a SMALL ratchet extension to avoid jamming your wrench into the firewall, because without one you won't be able to get far enough into the spark plug seat and a normal sized extension will prevent you from getting in at all. You could also try an appropriately sized deep socket (sorry I can't remember what size the plugs are) and use that instead of a spark plug socket. Just try to use the spark plug socket to put the new ones in, or you may damage the connectors using a normal socket.

Posted on Jun 26, 2008

  • 1 Answer

SOURCE: 2001 Mercury sable bad idle

CHECK THE PCV VALVE HOSE THAT CONNECTS AT THE BOTTOM OF THE THROTTLE BODY, THESE HOSES ARE KNOWN TO DETERIORATE AND ALLOW UNMETERED AIR TO ENTER THE COMBUSTION CHAMBER, WHEN THIS OCCURS THE OXYGEN SENSOR'S SIGNAL TELL THE PCM TO INCREASE THE PULSE WIDTH OF THE INJECTORS CAUSING THE VEHICLE TO ALMOST STALL.

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: Need spark plug gap for 94 Mercury Sable 3.0L

Listed in the owner's manual and under the hood on a placard. Also the parts store where you buy the plugs can supply this info.

Posted on Mar 18, 2009

  • 202 Answers

SOURCE: changing rear spark plugs

yes you have to take your front motor mount out and come along the motor forward you do not need to take the intake off

Posted on Apr 21, 2009

  • 27 Answers

SOURCE: i changed spark plugs and car still misfires and

i bet your spark plug wires are bad. Arching is occuring (when the spark doesnt get to the plug) Probably because of old cracked wires

Posted on Jul 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Show me where the # 5 spark plug is located on a 2000 mercury sable


tell me where is #4 & #5 spark plug located at please .

Jan 09, 2013 | 2000 Mercury Sable

1 Answer

Engine Code 301


Code # 301??? That is NOT a valid Diagnostic Test Code (DTC) for the engine control system on a 2000 Mercury Sable.

Assuming that you mean P0301, that is a cylinder misfire code that is identifying number 3 cylinder as the cylinder with the misfire problem. MANY things can cause a cylinder to misfire including spark plugs, spark plug wires or boots, burnt valves, broken valve springs, blow head gaskets, cracked cylinder heads, bad or dirty injectors, faulty injector control circuits, Failed ignition coils...the list goes on....proper diagnosis required.

May 30, 2012 | 2000 Mercury Sable

1 Answer

Trying to find out if 2000 Mercury Sable 3.0 ODHC has coil pack or individual coils ... and how to test / locate ... car sometimes hesitates and stutters


f a coil pack, you will have 6 spark plug wires coming out of a coil pack.

If individual, you will have no psark plug wire but a coil mounted above each spark plug

Aug 10, 2011 | 2000 Mercury Sable

1 Answer

2000 Mercury Sable - sounds like its skipping or missing untill a certain speed then it levels out??????????????


DO A LITTLE TUNE UP.REPLACE SPARK PLUGS AND WIRES.CLEAN FUEL INJECTORS AND REPLACE FUEL FILTER.

Feb 04, 2011 | 2000 Mercury Sable

1 Answer

Changing rear spark plugs on a 2004 mercury sable


VERY SIMPLE,JUST REACH YOUR HAND AROUND THE REAR OF THE ENGINE,GO FROM THE PASSENGER SIDE,PULL OUT THE THREE SPARK PLUG WIRES AND GET A SMALL EXTENSION WITH A SWIVEL 5/8 SPARK PLUG SOCKET AND TAKE THEM OUT.










TIM

Dec 18, 2010 | 2004 Mercury Sable

1 Answer

What is the best way to change spark pluges in a 2000 sable v-6?


The best way is to remove each plug wire and plug one at a time, so as not to mess up the firing order.The spark plugs on the firewall side are a bear to get to but the only way to get to them is thru the top of the motor and a 5/8 wobbly spark plug socket does come in very handy for this by the way.Hope I could help, Rate me accordingly, Thanks!!

Oct 11, 2010 | 2000 Mercury Sable

1 Answer

How do you rethread a sparkplug hole on a 2000 mercury sable dohc


You best bet is to buy a re tap tool that is designed to re thread spark plugs. It will go down past into the cyl then widen and you tap pulling it back out. You dont want metal shaving going down into your cyl the will damage the piston rings

Jul 02, 2010 | 2000 Mercury Sable

1 Answer

Digram of firing order for spark plugs, for 1991 mercury sable


For the 1991 Mercury Sable 3.8L V6:

Firing Order:
1-4-2-5-3-6
Cylinders:
.....(back)....
|...1...2...3...|
...................
|...4...5...6...|
......(front)
Distributor:
....(back)
......6..(+)-screw
1..........3
4..........5
(+)...2
....(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Apr 18, 2010 | 1991 Mercury Sable

2 Answers

2000 Mercury Sable 24V 3.o engine. Need to know


yes about the upper intake and the only way i know how to check the coils is with a engine anilyser or if the check engine light comes on then you can have the codes pulled and that will tell you which cylender is missfiring this engine has a indevidual coil for each spark plug so thares 6 of them and thay slide right down over the sparkplugs

May 05, 2009 | 2000 Mercury Sable

1 Answer

Need spark plug gap for 94 Mercury Sable 3.0L


Listed in the owner's manual and under the hood on a placard. Also the parts store where you buy the plugs can supply this info.

Mar 18, 2009 | 1994 Mercury Sable

Not finding what you are looking for?
2000 Mercury Sable Logo

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...