Question about Cars & Trucks

1 Answer

2001 Monte Carlo ss 3.8 not firing - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 10,875 Answers

Bad coil packs

Posted on Apr 07, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: monte carlo 2001 ss 3.8 V6

is the battery good if it is shorted out it will do this or if the charging system is not working

Posted on Nov 23, 2008

  • 1 Answer

SOURCE: Car Radio Problem

It is your amplifier.You can buy a $12.00 ,Amp Bypass Turobowire Harness.{12 VOLT-TRAVEL,

Posted on Dec 11, 2008

ginko
  • 19396 Answers

SOURCE: 2002 monte carlo ss

The fuel filter is located in the pressure line that runs from the fuel tank to the engine, near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.

Posted on Feb 27, 2009

daves944
  • 1050 Answers

SOURCE: fix front wheel bearing 2001 monte carlo ss

Remove the wheel, remove the axle nut, remove the brake caliper and bracket, remove the brake disc, remove the three bolts that go through the back and hold the bearing assembly in the knuckle, disconnect the abs connector and slide the bearing assembly out. Reverse the procedure to install the new one.

Posted on Jan 07, 2010

c17hydro
  • 2984 Answers

SOURCE: crankshaft sensor on a Monte Carlo 2001 SS 3.8

3.8L Engine

  1. Turn OFF the ignition.
  2. Remove the serpentine belts from the crankshaft pulley.
  3. Raise the vehicle.
  4. Remove the right front wheel and tire assembly.
  5. Remove the right inner fender access cover.
  6. Hold the flywheel with a (J 37096) flywheel holding tool.
  7. Using 28 mm socket, remove the crankshaft harmonic balancer retaining bolt.
  8. Remove the crankshaft harmonic balancer, using a (J 38197-A) balancer remover.
  9. Remove the crankshaft position sensor shield (1). Do not use a pry bar.
  10. Disconnect the sensor electrical connector.
  11. Remove the attaching bolts from the crankshaft position sensor.
  12. Remove the crankshaft position sensor from the block face.
To install:
  1. Position the crankshaft position (CKP) sensor to the block.
  2. Install the bolts to hold the CKP sensor to the block face. Tighten the bolts to 14-28 ft. lbs. (20-40 Nm).
  3. Reinstall the crankshaft position sensor shield.
  4. Connect the CKP sensor electrical connector.
  5. Position the crankshaft harmonic balancer on the crankshaft.
  6. Hold the flywheel with a (J 37096) flywheel holding tool.
  7. Using a (J 36660-A) torque/angle meter, tighten the harmonic balancer bolt to 110 ft. lbs. (150 Nm), plus an additional 76 degrees.
  8. Install the right inner fender access cover.
  9. Install the right front wheel and tire assembly.
  10. Tighten the wheel nuts to 104 ft. lbs. (140 Nm.).
  11. Lower the vehicle.
  12. Reinstall the serpentine belts.

It looks like this:

fd368a5.jpg

Posted on Jan 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am looking for the firing order for 01 monte carlo 3.4


For 2001 Chevrolet Monte Carlo 3.4 liter V-6 VIN "E" check this firing order...

zjlimited_755.gif


Hope this helps (remember to rated this answer).

Oct 03, 2011 | 2001 Chevrolet Monte Carlo

1 Answer

2001 ss monte carlo will not stay running fuel filter clean fuel pump running, no codes, no warning lights


I had a 2001 Impala that would crank and run for about 3 seconds and go dead it was the passlock system had to put the key in on position and let it sit for about 30 min and do a relearn it sounds funny but it worked on mine. Good luck

May 29, 2011 | 2001 Chevrolet Monte Carlo

1 Answer

How do i reset the check engine light on my 2001 chevy monte carlo ss


you need a scanner to clear the codes. make sure you have them written down first. Many parts stores offer free scans (autozone, Advance, etc.)

Sep 23, 2010 | 2001 Chevrolet Monte Carlo

2 Answers

What brand coolant do I use for 2001 chev. monte carlo ss


Dexacool is recommended ,but I perfer prestone ,that mixes with either coolant.

Jul 12, 2010 | 2001 Chevrolet Monte Carlo

1 Answer

My rpm is going crazy


Either the gauge is defective, the sensor at the distributor, or the computer module.

Could be a loose wire any where in the chain between the sensor and the gauge.

Mar 13, 2010 | 2001 Chevrolet Monte Carlo

1 Answer

Its a 2001 monte carlo ss, the oil presure gage its show under just on 40 or less, it was god tha day before


Replace the oil filter, check the oil pan gaskets and/or take it immediately to a mechanic for pressure testing.

Oct 10, 2009 | 2001 Chevrolet Monte Carlo

1 Answer

2001 monte carlo ss coupe die's while driving.


Does it sound like it runs out of gas? Or is it more like it looses ignition? Fuel filter might be pluged up. or Ignition madual maybe going bad.

Feb 08, 2009 | 2001 Chevrolet Monte Carlo

1 Answer

2001 monte carlo


do you have spark if you have no spark the crank sensor is bad.do you have fuel presure now. if not check the fuses. nead more info

Nov 23, 2008 | 2001 Chevrolet Monte Carlo

2 Answers

Monte carlo 2001 ss 3.8 V6


is the battery good if it is shorted out it will do this or if the charging system is not working

Jun 25, 2008 | 2001 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...