Question about 1992 Pontiac Grand Am
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
behind glove box look under hood on pasnger side for two hoses going in to fire wall this is where your heater core will be located if you need more help call me at 850-791-4498
Posted on Dec 05, 2008
It's less than foot from the heater core. I would guess that either the damper doors are not on correctly or the vent hoses are not hooked up. Can you hear the blower motor running? Maybe they didn't hook the motor back up when they replaced the heater core. It takes a ground and a hot wire.I can't remember where it's at but it may be part of the same unit. Did you check the fuse?
Posted on Jan 04, 2009
the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.
Posted on Feb 01, 2009
If you are looking for the fan blower resistor, it is located behind the glove box. No tools need to get to it and a nut driver to remove the 2 screws to replace it. A 20$ part.
Posted on Feb 05, 2009
If the fuse is good,check to see if there is voltage to the blower motor,if there is,replace the blower motor.Sometimes,not always,if you bump the blower motor,it will start working,if this happens,then the blower motor is bad,if it does not,the fan switch could be bad,but the relay is usally near the blower motor.Testing it with a test light is the best way to test it,ground one end of the test light,the other end has a point on it.Use the piont of the test light to touch all the legs on the relay,with the key on,and the fan on high.The test light will light up,on almost all the legs,but it will also activate the relay when you touch the right leg of the relay,the relay needs to stay plugged up as you do this.If you can not access the legs of the relay,because of a skirt on the relay,push the point of the relay into the wire that you are testing,or into the plug,near the leg of the relay.The legs I am refuring to,are the prongs on the relay.If the relay clicks and turns the fan on,when you touch the right one,then the fan,and the relay are good,it will be the blower fan switch.Now if you already have high,blower fan,and the lower speeds are the problem,replace the blower resister,It is mounted right next to the blower motor,and has about 7 wires plugged into it.
Posted on Jan 09, 2010
Tips for a great answer:
Feb 23, 2015 | 2004 Pontiac Grand Prix
Jun 15, 2014 | 2001 Jeep Grand Cherokee
Feb 24, 2013 | 1992 Pontiac Grand Am
Dec 16, 2010 | 1996 Jeep Grand Cherokee
May 27, 2017 | 1992 GMC Jimmy
Feb 08, 2010 | 2001 Pontiac Grand Am SE
Nov 20, 2009 | 1992 Oldsmobile Custom Cruiser
Nov 18, 2009 | 1996 Pontiac Grand Am
23 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: