Question about 2006 Chrysler 300
Check all the fuses, you never know which circuits will blow the fuse.
Other circuits are protected with diodes, and some diodes will be burned out due to exceeding the reverse voltage limit.
Try to find a schematic for your car.
Hope this helps
Posted on Apr 06, 2015
Heck fusible link , looks like a wire but is actually a fuse
Posted on Apr 06, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Oct 06, 2017 | Cars & Trucks
May 31, 2017 | GMC Cars & Trucks
Dec 10, 2016 | 2006 Hummer H3
Nov 25, 2016 | 2003 Pontiac Montana
Body control module (BCM)
Wiper 1 relay
Wiper 2 relay
Windshield wiper motor
Windshield washer pump
Windshield washer nozzles
Windshield washer solvent container
Windshield wiper arm and blade assemblies
Windshield wiper transmission
WIPER/SW 10A fuse
WIPER 25A fuse
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation. The windshield wiper motor park operation is controlled by the BCM. The BCM recieves an input from the park switch to determine wiper blade position. When the wiper blades are at the bottom of the windshield glass in park position the wiper park switch will open and the circuit will be pulled up to B+ by the BCM. The park signal will be pulled to ground by the wiper motor park switch while the wiper blades are not in the park position.
The BCM controls the windshield wiper motor through two output controls, controlling two relays which determine the desired wiper speed, high or low
Diagnostic Trouble Codes (DTCs)
The body control module (BCM) monitors the voltage on the windshield wiper switch signal 2 circuit for diagnostic purposes. If the circuit is shorted to voltage while the driver is commanded OFF, the BCM will store DTC B3715. If the circuit is shorted to ground while the driver is commanded ON, the BCM will store DTC B3715. Refer to DTC B3715.
It would be best to have a factory scan tool to diagnose this problem . it would make it easier anyway .
Dec 05, 2015 | Cars & Trucks
Sep 15, 2014 | 2008 Jeep Patriot Sport
Oct 08, 2012 | 2010 Dodge Ram Pickup 1500
Aug 02, 2010 | 2004 Chevrolet Silverado
May 27, 2009 | 1994 Ford Mustang
Mar 19, 2009 | 1991 Nissan Pickup
47 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: