Question about Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Is the alarm factory fitted, cheap, or a top of the range.
the factory alarm you can pull the cable of the horn untill you get the car started.
there are some alarms that go off when there is a voltage change, and some will keep going for a couple of minutes if the battery is dead flat untill there is power to equilze the power abit,
and some alarms have a key over ride in the siren.
if its a cheap alarm take the battery of and charge it,(the alarm will cut out as soon as the battery is disconnected.
~dont jump start from a dead flat battery, as it can cause a lot more problems with the electrics, leave another car running with the jump leads on for at least 5 min first.~
Posted on Dec 30, 2008
the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.
Posted on Feb 28, 2009
I had this happen today and called an alarm installer. he said to connect the battery cable (id unhooked it to stop the blaring) then open the door to set off the alarm. then torn on the key ( even tho it wont start the car , turn it on anyway) then look for a toggle switch ( AKA a valet switch) with the key in the on position flip the switch. ( when I did this a noticed a tiny red light come on to the left of the steering column) I turned the toggle back to the original position and then I tried to crank -AND IT CRANKED WITH NO SCREAMING ALARM!!! I was so happy, I had to post this in case it could help someone else.
Posted on Jul 08, 2009
Tips for a great answer:
May 22, 2015 | 2005 Kia Sorento
can be any of the car doors not got properly locked or the door is locked but
the switch is not sensing the door locked. Open and close each door again
else its problem with any of switch wiring getting in contact
with alarm wiring causing it to happen.
last thing alarm connections need to be inspected. It's getting short somewhere
are few help links with solutions, to troubleshoot these types of problems.
I suggest going through these links.
the link below: ------
details will help.
Nov 28, 2012 | 2001 Pontiac Montana
Car Factory Alarm will go off? http://repairhelpcenter.blogspot.com/2012/01/toyota-avalon-factory-alarm-will-go-off.html
---------Car will not start security lock out? http://technoanswers.blogspot.com/2011/12/car-will-not-start-security-lock-out.html
---------Alarm will not disengage? http://technoanswers.blogspot.com/2012/01/ford-pickup-alarm-will-not-disengage.html
--------This will help.For more info keep updated.Thanks.
Feb 09, 2012 | 1998 Plymouth Voyager
Jan 16, 2011 | 2000 Mercury Cougar
Apr 25, 2010 | 2000 Nissan Xterra
Feb 28, 2010 | 1995 Chrysler Cirrus
Dec 03, 2009 | 2000 Volkswagen Jetta TDI
Oct 21, 2008 | 1986 Toyota Supra
Jul 24, 2008 | 1996 Volkswagen Jetta
21 people viewed this question
Usually answered in minutes!