Question about 1997 Ford Crown Victoria
Remove the clips that hold the radiator support cover and remove the cover look down at the top of the light assembly and you will see two or three clips that hold it in just spread the clips or use a snap ring plier to get them out and remove all three and remove the headlight assembly the bulbs are held in by twist lock connectors push in and turn DO NOT TOUCH THE NEW HEAD LIGHT WITH YOUR HANDS THE OIL FROM YOUR SKIN FRIES ON THE GLASS AND BLOWS OUT THE BULB WASH YOUR HANDS FIRST THEN DRY THEM HOLD THE BULB IN PAPER TOWELS below are photos of your stuff the clips have little legs on them that fit into the black plastic adjusters shown in the center of the headlight I couldn't find a photo of the other side showing the legs but you'll see them when you look down at the back of the light the snap ring pliers fit into the holes on the tabs you see and then spread the clips for removal
Posted on Apr 06, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
ithere are 4 bolts that hold it in...the top 2 are obvious..the others are behind the bumper. the bumper must be removed to acces them...here are the manuals instructions..
Item Part Number Description 1 — Headlamp assembly bolts (3 required) 2 — Headlamp assembly nut 3 13008 Headlamp assembly 4 14290 Electrical connectors
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
Posted on Jun 10, 2009
SOURCE: Replace horn on 2006 crown vic
I believe once you have mounted the horn and connected the wire you will find that the horn wire was cut at (by) the steering coloum that the siren override was hooked to,you will have reconnect this,I hope this helps you
Posted on Jul 04, 2009
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
Posted on Aug 14, 2009
This is caused by the IAC valve. Over time the valve becomes gummy and inoperative. Get it replaced and the problem is solved. IAC stands for idle air control, hence the stalling concern.
Posted on Oct 18, 2009
have look at ur wires that is caming from the car in to the coil it self
Posted on Mar 27, 2010
Testimonial: "Thanks for the info. I did replace coils made in the good ol USA and the car is running much better. Better gas mileage as well. Thanks again."
Tips for a great answer:
Dec 19, 2015 | 1997 Ford Crown Victoria
Apr 07, 2013 | Ford Crown Victoria Cars & Trucks
Aug 24, 2011 | 1997 Ford Crown Victoria
Feb 20, 2011 | 1999 Ford Crown Victoria
Oct 20, 2009 | 1991 Ford LTD Crown Victoria
Oct 10, 2009 | 1999 Ford Crown Victoria
Jan 17, 2009 | 1994 Ford Crown Victoria
Aug 17, 2008 | 2002 Ford Crown Victoria
120 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: