Question about Cars & Trucks

1 Answer

There is no coil wire to distributor cap.only 6 wires.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Cars & Trucks Expert
  • 294 Answers

Don't know which vehicle you have but the coil is probably part of the distributor.

Posted on Apr 05, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Richie_asg1
  • 1036 Answers

SOURCE: 1992 Isuzu Rodeo Distributor wires

Hi,

On the 3.2L distriburorless ignition, the firing order is a straight 1-2-3-4-5-6.

Cylinder numbering .

88c39f7.jpg-

Hope this works for you

Posted on Jul 05, 2008

fastboyz
  • 674 Answers

SOURCE: distributor cap wiring diagram

here is the firing order if the cam is stock.b9c7936.gif

Posted on Sep 17, 2008

  • 1861 Answers

SOURCE: diagram for replacing distributor, cap, rotor...

Replace the coil. It is shorted out. I have changed quite a few coils for the exact same symptom.

The graciousness of a FixYa rating for my assistance would be appreciated.

Thanks for choosing FixYa for assistance.

Posted on Jan 21, 2009

  • 79 Answers

SOURCE: Need spark plug wire to distributor diagram for 2000 dodge ram

Hi
Here is a diagram.93009452.gif

Posted on Apr 09, 2009

  • 65 Answers

SOURCE: No spark?

Hi, common thing with the mazda was the coil or the ignition amplifier going faulty, both of which are located within the distributor, the coil ususally gives the symptoms you describe, a weak spark. The coil is the most common failure aswell for your vehicle i would recommend a new one, also make sure distributor is spinning as it could just be a case of a broken timing belt.

Good luck Davelee

Posted on Apr 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 1500V 6 get gas a spark but don't. Strart new cap wire. Coil I don't what to do now some body help me


Is this a GM vehicle? Which one, what is engine litre size?
How long since a tune-up? If no spark check plugs and plug wires--check cap and rotor. If it has a coil wire to distributor take it loose from distributor, hold close to engine ground, have helper crank while you watch for spark, if no spark, could coil wire or coil, Check primary voltage coil, usually goes hot with key on. The coil also needs a ground usually controlled by ignition module.

Mar 11, 2016 | Cars & Trucks

2 Answers

What are the to coil packs on a set of spark plug wires on a 2001 4.3 chev blazer for and what plugs do they go on


Your Coil Pack Is Separate And Plugs Into The Middle Of Distributor Cap.Follow The Middle Wire To Coil Should Be On Passenger Side
Easy Quick Change Out. Cost Is Around $40

Mar 11, 2013 | 2000 Chevrolet Blazer

3 Answers

I have a 1993 chev pick-up v6 4.3, i just installed new spark plugs,new plug wires, distributor cap and rotor button.All plug wires are back in the right position,and i used the firing order 1-6-5-4-3-2...


This diagram is for 1998-1995 Chevy 6 cylinder 4.3L engines.
Your got the firing order exactly correct, at 1-6-5-4-3-2, but here's the thing to double-check:
The distributor rotation is clockwise (note badly rendered arrow in picture).



archaeology_96.jpg

Since you probably got everything right, then you're left with really unusual/rare causes of
failure of the ignition system:
(a) rotor button misaligned/failing to make contact?
(b) rotor button not pressed onto distributor shaft far enough therefore failing to provide correct
proximity to distributor cap contacts when coil fires
(c) coil wire or contact loose/disconnected - press coil wire firmly down into distributor cap.
(d) distributor shaft of other damage caused during installation of rotor.
(e) spark plug wires defective from factory
(f) spark plugs defective from factory
(g) battery low - may need a charge to start
(h) ICM (ignition control module) failure - hook up your HEI (high energy ignition) tester, and
watch the quality of the spark on each cylinder.
(i) fuel problem? If spark is being properly delivered, its gotta be a fuel problem...
(j) distributor cap not screwed down flush to top of distributor? maybe just on one side?

Inspect the inside of the distributor cap - if there are lots of little metal bits all over the inside
of the distributor cap, then you know you have a misalignment of some type in there, and the
rotor and cap are destroying each other. normal operation will throw a quota of spark-ed off
metal bits inside the distributor cap, but since your cap is brand new, your attempts to start
the engine should have rotated the distributor so few times, you should see no metal debris.

Inspect the distributor cap contacts to see if any spark marks are more of less in the middle
of the cap's proper "contact zone". If not, you've diagnosed an internal misalignment, which
you know how to correct.

Sep 14, 2011 | Chevrolet 1500 Cars & Trucks

2 Answers

Change my spark plugs and distrubutor cap and the 85 ranger want start


You may have got the spark plug wires out of sequence.
Reseat the coil wire going to the center of the distributor cap Check the spark plug wires at the distributor against the firing order as follows:
The spark plug firing order is 1 - 4 - 2 - 5 - 3 - 6 The distributor rotor turns CLOCKWISE The engine cylinders / spark plugs are numbered :
firewall 3 - 6 2 - 5 1 - 4 front
Best wishes,
TF

Jun 03, 2011 | 1985 Ford Ranger

2 Answers

We have a 2005 ford explorer that has the spark plug wires connected to the distributor cap incorrectly. we just need the correct order to connect the plugs to the distributor cap


Okay, lets start with the wires they are connected to the coilpack theres no distributor on the year ford, heres the sparkplug wire location, hope this helps, heres a diagram,acefab9.gif8b4f223.gif

Oct 24, 2010 | 2005 Ford Explorer

2 Answers

I have a miss fire


Recheck the firing order; 1-6-5-4-3-2

On the distributor passenger side radiator to fire wall. 2-4-6-coil
On the distributor drivers side radiator to fire wall. 3-1-5

Cylinder passenger side radiator to fire wall. 2-4-6
Cylinder drivers side radiator to fire wall. 1-3-5

Good luck and also check the distributor cap again for proper seating.

Nov 13, 2009 | 1998 Chevrolet Blazer

3 Answers

Where is the rotore /cap located in a 1999 silverado 4.8


I believe those motors have a distributorless ignition system. Each cylinder has a coil mounted on top of the valve cover.

Oct 23, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

Where is the coil located on a 99 chevy astro van? Distributor cap?


You have to remove the interior dog box and the distributor and coil assemblies are in the back of the engine behind the upper plenum.

Sep 28, 2009 | 1999 Chevrolet Astro

2 Answers

How do you change the distributor cap and coil on a 1991 corvette


there are four screws that u push down on and turn counter clockwise as you push down, they hook under the distributor, then disconnect the wiring harness and pull the cap off

Sep 17, 2009 | 1991 Chevrolet Corvette

2 Answers

No spark, just put in a new coil, distrbutor isnt dirty or wet, sombody told to check out the littl box's on the fender well, what are these to box's and what is there purpose? Mike 77 cj-5 304 3spd I...


I had the same problem with my 85 cj7 this week, I relpaced the ignition control module, plugs, wires, cap, rotor and the the coil; still had no fire to plugs. the problem turned out to be my distributor, replaced it today and she fired right up. Most likely it was the pick up module in the distributor that went bad.

Nov 30, 2008 | 1983 Jeep CJ7

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...