Question about Dodge Cars & Trucks

1 Answer

What will fix the spark to plug wires on a 1997 dodge average 2.5 v6 24 value have already replaced crankshaft position sensor still not starting?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 2,355 Answers

Could be a bad coil

Posted on Apr 05, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
blueextc3221
  • 15935 Answers

SOURCE: Crankshaft Position Sensor location 04 PT Cruiser

It is located behind the **** of the starter on the front of the engine starting in '03 the 2.4 lt was changes the repair manual failed to update this..you may sneak it out with small fingers with out pulling out the starter.

7e1821a.jpg

Posted on Feb 08, 2009

  • 9 Answers

SOURCE: 1997 dodge dakota v6 engine wont start replaced

turn the key to the on position a see if you can here a buzzing sound around the fuel tank,if you don't hear a sound then. (be very careful while doing this) with the key off take a fuel line coming from the tank loose,make sure its pointed away from you and turn the key to the on position,see if any gas comes out,if not then your fuel pump is probably bad.

Posted on Mar 05, 2009

c17hydro
  • 2984 Answers

SOURCE: need to find and replace crankshaft position

If you have a 2.0 or a 2.4L engine, it is located on the bottom backside of the motor that faces the cab area. You need to jack the car to get to it because of the low ground clearance of the car. I have a 1997 Stratus and replaced mine already.

Ask if you have more questions.

c17hydro

Posted on Mar 08, 2009

c17hydro
  • 2984 Answers

SOURCE: broke crankshaft position sensor

If you can get a magnet....use it to pull it out...has to be a stong one....like on the back of a audio speaker. That's the part that's stuck right? Is there any part of it sticking out?

Posted on Mar 14, 2009

  • 14036 Answers

SOURCE: 1997 Mazda Millenia, Changed Almost Everything, Still No Spark..

check the pcm .get it scan make sure your pcm is working.also check ignition coils.

Posted on Apr 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 dodge stratus wont start has no spark and no trouble codes.


The automatic shutdown (ASD) relay will turn off power to the coil(s) and fuel injectors if the PCM is not receiving a signal from the crankshaft position sensor. You can check the ASD relay, but the problem is almost always a crankshaft position sensor or the wiring/connectors between the PCM and that sensor.

Mar 29, 2017 | 1997 Dodge Stratus

1 Answer

01 dodge dakota 3.9. no power to coil replaced engine control relay still no power can jump across relay get power but no start and get code for no rpm


If you're getting a code for no RPM, the PCM is not receiving a signal from the crankshaft position sensor. The PCM uses the signal from the crankshaft position sensor to fire the coil/spark plugs. Check the wiring to the crankshaft position sensor and check the sensor itself.

Oct 29, 2016 | 2001 Dodge Dakota

5 Answers

I have no plug wire spark 1997 dodge average 2.5 v6 24 value.have already replaced crankshaft positioning sensor on it and still no spark to the wires


Sounds like a bad distributor. Had you pulled a spark plug out you may have found them wet with gas after cranking. If they are wet the crank sensor is working since both injector pulse and coil pulse rely on crank signal.

The distributors are known week points in the ignition system and used to be common when theses cars where still on the road. A reman will run you $250 U.S.

Apr 05, 2015 | 1997 Dodge Avenger

2 Answers

I have a 1997 dodge average 2.5 v6 24 value its not getting spark to plug wires have replaced crankshaft positioning sensor and still no spark please help.


You need to check wiring first. After that would be the ECM. You need wiring diagrams/pinouts and a volt/ohm meter.

Apr 05, 2015 | 1997 Dodge Avenger

2 Answers

My 1995 dodge caravan trys to start but wont im getting no spark to my spark plugs


Hi mate start at the easiest point which will be to check your EARTH to make sure everything is earthed.

Feb 06, 2015 | Dodge Cars & Trucks

2 Answers

1997 DODGE DAKOTA WILL SOMETIMES START OR STALL


To much difference between 04 and 97. To use an 04 ECM, you need the trucks complete wiring harness. Then you would have to change the transmission also. You better get in line to sue him also..

Jan 31, 2015 | 1997 Dodge Dakota

1 Answer

I have replace the spark plugs, wires, coil, crank...


You replaced all kinds of parts for no reason. Do you really think, at this time,that even one item was your problem.
I would suggest going to a repair shop,as you already spent more than, that would have cost,in the first place.

May 09, 2010 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...