Question about Chrysler Cars & Trucks
You first have to remove the ignition coils or plug wires and then remove the bolts holding the cover to the cylinder head. Discard old gasket. Clean gasket channel of any oil and install new gasket to cover taking care during assembly not to disturb gasket when placing cover back on cylinder head. The rear gasket is much harder to change as the upper plenum must be removed to access this cover. You should have some knowledge of engines if you are going to atempt this repair on your own
Posted on Apr 05, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Removal of the plenum is pretty straight forward. You will need to replace the plenum gasket after you remove it; the gasket is not reusable. Personally, if I was going to take the trouble to remove the plenum, I would replace the plugs and wires back there, also.
I know, I have a 93 Camry V6, and it is a real pain to do the plugs and wires with the plenum on. There are no secrets or great tips on the plenum removal, just take your time. Remember that there are different size bolts, and where they go. Please get back to me if you need any more info...Hope this helps, and thanks for choosing FixYa to resolve your issue.
The graciousness of a FixYa rating for my assistance would be greatly appreciated.
Posted on Dec 15, 2008
did u test for intake manifold leaks? did you disconnect the battery after the cleaning to reset idle speed control system? if u can find no leaks and system was reset then IAC may be sticking.
Posted on Apr 15, 2009
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
Posted on Apr 28, 2009
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
Posted on Jan 03, 2010
just look at the valve covers some are held in place with 6 bolts some only 3 do one at a time and keep working area clean and free of dirt n grease. clean valve cover good and have clean hands when handling gasket, and there your done just replace and bolt down , check bolts again for tightness in a couple weeks.
Posted on Apr 25, 2010
Testimonial: "Thanks for the quick reply...This info is priceless!"
Tips for a great answer:
Jan 18, 2016 | Cars & Trucks
Dec 10, 2015 | Chrysler Cars & Trucks
Sep 06, 2015 | Chrysler Cars & Trucks
Jul 20, 2014 | 2004 Chrysler Sebring Convertible
Feb 21, 2013 | 2004 Chrysler Sebring
Sep 10, 2012 | 1997 Chrysler Sebring
Dec 12, 2011 | 1996 Chrysler Sebring
Apr 16, 2011 | 2003 Chrysler Sebring
Dec 01, 2009 | 2004 Chrysler Sebring
Apr 15, 2009 | 2004 Chrysler Sebring
117 people viewed this question
Usually answered in minutes!