Question about Cars & Trucks

1 Answer

What time does screw fix open in Burnley - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 10,875 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel gauge full when not full. only one quarter a tank nearly full could only get 3 gallon in full could not get anymore in 160 miles fuel light came on and Gage showed empty. nigel from Burnley


probably stuck or damaged fuel sender in the tank.. you could try banging the bottom of the fuel tank to un stick it but if that dont work it will need to be replaced .

Jun 03, 2017 | Cars & Trucks

1 Answer

I need to fix by ail lights but cannot open rear hatch. How can I access this frm inside


You can't. You have to get the hatch open. Pull the top trim off the hatch. Remove two screws , one on each side. Pull the bottom panel out and reach down and grab the rod or arm to open the hatch. Then you can access the screws to remove the rear lens. Fix the hatch since it is open.

Mar 05, 2016 | 1997 Dodge Caravan

1 Answer

2005 dodge Durango rear door hatch won't open. how do I fix this?


Most of them I fix, the latch is bad. It's electrical. Some times it the wires. Usually the wires break at the top where the wires go from the door to the body. First climb in the back and see if there is a plug at the bottom/center of the door panel. If there is, remove it and use a screw driver, go left to right and catch the latch arm to release the door. If not, them remove the upper door panel around the window. It pops off. Start at the sides, the the top. Remove the screws on both side of the bottom piece(hidden by the top piece). Then pop the top of the bottom piece off. You wont get it out because there are screws on the bottom. Then you have to reach down and find the release arm and open the door to finish taking the panel off. Remove the bolts for the latch and replace it. Check the wires first. You will need a volt/ohm meter to check for power and ground.

Nov 04, 2014 | 2005 Dodge Durango Limited

1 Answer

How to fix trunk latch on 2003 mazda tribute


try having someone push the switch while you use something like a screw driver pulling open the latch claws. this may be all it is.

Aug 07, 2014 | 2003 Mazda Tribute

1 Answer

Toyota corolla drivers door won't close. how do i fix?


open the door and look at the latch that is across the opening . Get a round screw driver and pull the latch out at the same time as opening the door handle.. The door lock is in the first close position and will not move further to fully lock the door.

Dec 24, 2013 | 2001 Toyota Sienna

1 Answer

The driver side door on my 2002 chevy blazer wont close.how do i fix it?


Door pins are a common failure on that series of Blazer/S10's. Also, another point of contention that the door faces is a sticky latch. Basically, the door latch re-latches itself and when you shut the door into the catch, it slams into it and bounces off. An easy fix is a 3 part cocktail of brake parts cleaner. Open and shut the latch with a screw driver acting as the catch and your interior door handle a few times. P'Blaster, open and shut the door a few times with the screwdriver acting as the catch. Finally, a good shot of white lithium grease. Open and shut the door with a screwdriver as the catch several times. Once you feel it is un-stuck, actually close and open the door several times. If you notice the door rising every time it catches, you MUST replace the door pins (cheap fix). If the door still has issues, replace the door latch (and since you're in there, do some PM and replace the actuator as well).

Apr 08, 2012 | 2002 Chevrolet Blazer

2 Answers

We can not get all brakes to bleed..what should we be lookin for to fix this


lots of air in line? Try gravity bleed one at a time starting with RR--wide open 'til it drips, then LR, then RF, and LF.

Sep 05, 2010 | 1989 Dodge Daytona

1 Answer

'92 Honda Accord driver's side door won't open from interior


1. This may require removal of the interior door panel which should not be too difficult to figure out where all of the screws are.
2. Take your time and don't get too wild when forcing or pulling anything. If it fails to come off there is probably yet another clip or screw you missed. Many of the screws are hidden under little caps.
3. I would find a wrecking yard near you that has the part and know ahead of time if you must pull the donor part or if they pull it for you.

May 31, 2009 | 2000 Honda Accord

2 Answers

Clutch bleeding


Try opening bleeder screw on slave cylinder and let it GRAVITY BLEED, just open clutch mater and fill with fluid and then open slave cylinder bleeder screw and let it gravity bleed( run out by itself) When it does close bleeder screw and you should get pressure.(make sure master doesn't run out of fluid during this preocess).If pedal not good enough bleed as usual. PUMP PEDAL ABOUT 6 time then hold down to the floor using wrench open slave bleed screw and close back up with pedal still being held DOWN. Repeat until fluid comes out with out air.However if all this doesn't work, YOU WILL NEED TO REPLACE CLUTCH MATER CYLINDER. Conatct if you need more help and Good Luck. Thanks for using FIX YA

Jan 12, 2009 | 2001 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...