Question about 1985 Dodge Caravan
Could be one of the following no power coming into the coil or no signal from crank sensor. The vehicle I just got done working on is a 97 caravan with no spark because of no signal from crank sensor
Posted on Apr 05, 2015
Check for power at coil no crank sensor on 85
Posted on Apr 06, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There are tow ways to get to the plugs, You can get to them from the top or from the bottom. There's quite a bit a bit of room in the transmission tunnel, and you can reach up and actually touch the plugs. There is trouble with the "alternator plug" (#1) , Hard to reach it from below, and you may ended up removing the alternator bracket and shoving the alternator back.
From the top end, removed the windshield wipers/cowl assembly, the intake plenum, remove the bracket from the alternator, easy, and the hardest part is just removing the bracket holding a wire harness from the back of the plenum, the bolts are a little hard to get to due to the a/c lines, but after they were out the plenum removed with ease and I replaced the back plugs(with champion double platinum RN14PMP5 OEM's) and replace the spark plug wires with BWD Selects. They are very good wires. Used anti-seize of course. Mounted the wire harness bracket back, put the plenum(with new gasket), vacuum lines, sensors, and alt.bracket back on then changed out the front ones. Replaced Wipers and your good to go.
Note: if from the bottom rotate the alternator to get the pass side and from below to get the middle and drivers side. You can use a jack stands and a creeper. Takes about an hour. Yes it's a PITA but, going from below greatly reduces the chance of spinning a bolt head off or breaking something else in the process of getting to the plugs. No special tools needed. Good luck and if your lazy like i am just change the front ones and have a local shop replace the rear, they have the lift and will only cost an hour shop rate in your area. $65.00/hour average.
Posted on Jul 01, 2009
3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .
Posted on Jul 04, 2009
Tips for a great answer:
Apr 05, 2015 | 1986 Dodge Caravan
May 07, 2011 | 1996 Dodge Caravan
Dec 17, 2010 | 2003 Dodge Grand Caravan AWD
May 15, 2010 | 2002 Dodge Grand Caravan
May 05, 2010 | 2002 Dodge Grand Caravan
Dec 23, 2009 | 2000 Dodge Caravan
May 30, 2009 | 1984 Dodge Caravan
May 11, 2009 | 2005 Dodge Caravan
119 people viewed this question
Usually answered in minutes!