Question about 2009 Hyundai Accent

Open Question

Breaks getting stuck - 2009 Hyundai Accent

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to get2004 chrysler300 out of park

usually it is a stuck or broken shifter cable it is connected at the underside of the engine near the transmission

when it breaks this is the condition you get stuck in park

Jan 30, 2018 | Cars & Trucks

3 Answers

My 1995 Toyota tercel brake lights stay on even when the car is off

There is a switch/sensor located at you break pedal, when you hit the breaks this has a small pin that make positive contact telling your break lights to come on. It may be broken or stuck, check it.

Also check all the bulbs on your car, breaks and blinkers etc...

Oct 03, 2016 | 1995 Toyota Tercel

1 Answer

Stuck bolt on 1999 thermostat

You might want to get advice from a mechanic to unsure that you don't worsen anything

Jan 01, 2014 | 1999 Chevrolet Tahoe

1 Answer

How do i remove the boot of a CV axle/joint and its stuck in the motor or transmission..... I'm a girl give me a break LOL

ok girl i guess its out of the knuckle and stuck in trans dont worry the retaining ring is stuck . use a large screwdriver or pry bar and big hammer. place in crack at axle trans and hit or get at a angle and hit till pops out . had one in jag took hours to pop out ring was broken on shaft and holding in. just stay at it and it will come out.

Aug 05, 2012 | 1997 Mazda Millenia

1 Answer

Brake lights stay on when engine is off. Pulled fuse out and replaced. Lights still stay on

I would say your break switch is stuck. It is a round chrome cylinder above your break pedal. The break stem hits it when you push down the break. Try to loosen the button. It is stuck.

Feb 17, 2011 | 2000 Nissan Frontier

1 Answer

Can not replace oxygen sensor, old one is stuck what to do

you say stuck. Don't break it off. It's rusted in.

You need to heat it up and tighten then loosen slowly. keep trying to move it each direction until it breaks loose.

you might need to get the socket for the sensor. it is a special socket that will help also.

put anti-seize lube on it before installing



Dec 26, 2010 | 2004 Lexus ES 330

2 Answers

Any helpful hints on how to remove a spark plug that is stuck and we don't want to break it off because that would be a mess.

I would imagine you have sprayed it with soime type of penetrating oil. If you can get it to turn a little bit at all, do that, and then tighten it again, and then loosen it again as much as you can. And then tighten again, and repeat. You won't break it off, but you certainly could strip the threads if it is really stuck. Just keep working it back and forth slowly, and keep spraying it. It should come. If you break the glass part, that won't affect you.

Sep 23, 2010 | 1995 Chevrolet Cavalier

1 Answer

Brake light flashing on dashboard

Could be low on break fluid,emergency break could be stuck.

Its a warning.Get your breaks checked.

Apr 21, 2010 | 2000 Chrysler Grand Voyager

1 Answer

Car is stuck in Reverse

It sounds like a bad shift indicator switch on the shifter. Kind of a pain in the *SS to get to those console's get real brittle.

Hope you get it in gear!!!

Oct 23, 2009 | 2004 Jaguar XJR-Series

1 Answer

2000 blazer break lights stuck on

check the gruond in the black wire in the blinker switch if its ok, sometime the after market parts have ashort life time try to replace the flasher switch ( blinker switch)

Mar 07, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2009 Hyundai Accent Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides