Question about 2001 Ford Focus
Where on engine is it
The Positive Crankcase Ventilation (PCV) valve is located below the two small hoses near radiator...On the right side by exhaust manifold...It can be removed from beneath the car by pushing up on the hose which is connected to the valve...Then twist to remove...It is not easy and best done with front of vehicle on jack stands
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
Posted on Apr 15, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Focus timing belt replacement.
This is a very very easy timing belt setup. first off you have to remove the valve cover. Then you have to remove the serp belt. Then remove anything thats in your way of the front cover. after you remove the crank pulley re-install the crank bolt. DO NOT LOSEN THE BOLT FOR THE TENSIONER!!!! now spin the crankshaft until the sproket aligns with the timing mark. now at this point the two camshafts should be aligned. now there is a special tool from ford that holds the cam shafts in place. all it is is a 1/4" peice of metal that goes on the left side of the cam shafts to hold them into place. if you mark the cams you wont need the tool. or if you can find something to fit in the left side of the cams that will work too. anyways after that its just the same steps in reverse. very easy to do.
Posted on Aug 31, 2009
First disconnect your negative battery cable, then remove the air cleaner outlet tube.
Remove three starter mounting bolts, then raise and support the vehicle. Disconnect starter solenoid wires and remove starter motor, reverse procedure to reinstall.
Posted on Oct 01, 2009
yes there is if you drop down the glove box lid and remove the bolts holding the fuse box. unclip the fues box and pull it down. turn the fuse box around and there is a fuse on the back (i thing its a 15amp)
this is the other fuse for the central locking.
please let me know if this helps
big mike :)
Posted on Jan 04, 2010
i hope this is what your looking for.heres a diagram of the waterpump and pulleys, waterpump is driven by the timing belt, hope this helps.
Posted on Jan 28, 2010
SOURCE: 2001 ford focus se
DO not retighten the cylinder head bolts
Tighten the cylinder head bolts in three stages in the sequence indicated
STAGES 1 ------------20 Nm 14.75 lb
STAGES 2--------------40 Nm 29.51 lb
STAGES 3--------------90 degrees.
Posted on Apr 18, 2010
Tips for a great answer:
Nov 24, 2015 | Ford Cars & Trucks
Dec 30, 2012 | Cars & Trucks
Apr 03, 2011 | Ford Freestar Cars & Trucks
It is on the valve cover. on the firewall side to the right. (with you facing windshield) it is plastic, threaded in to the hole.
Please remember to rate this solution. Thanks!
Feb 18, 2011 | 2001 Ford Focus
Jan 28, 2010 | 2001 Ford Focus
Jul 18, 2009 | 2001 Ford Focus
Jul 10, 2009 | 2001 Ford Focus
Dec 29, 2008 | 2001 Ford Focus
Jun 05, 2008 | 2001 Ford Focus
150 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: