Question about Chrysler Voyager

Open Question

Changed battery in my grand voyager crd automatic and it won't change gears

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: engine oil in cooling system

I hope it wasn't just striaght water , and it sounds like a leaking water jacket or worse a blown head gasket. Take it in to aase cert rad repair shop and have them fix it .DON"T RUN THE VAN HAVE IT TOWED COULD BLOW MOTOR

Posted on Dec 03, 2008

Ad
  • 9 Answers

SOURCE: want to change diesel fuel filter where is it located ??

i beleive the fuel filter is located on top the fuel tank or at least mine was you have to jacket up car and lower the tank sounds harder than it is

Posted on Feb 07, 2009

  • 18 Answers

SOURCE: radio gone mute

pull radio out on the back of it is a studed screw there should be a strap attached and a black wire plugged in to it also if the black wire is not there find it and plug it in its the ground for the factory amp

Posted on Feb 10, 2009

emissionwiz
  • 80531 Answers

SOURCE: when does a 2008 chrysler grand voyager 2.8 crd

120,000 MILES

Posted on May 19, 2010

  • 61 Answers

SOURCE: automatic 1997 grand voyager need to get gear box

you can change the trans only. not easy to do w/o a lift. it is tight but can be done. sometimes faster to take them out together and sep. on the ground. tought to do in the drive way both ways. i drop just the trans.

Posted on Aug 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello I have a Chrysler grand voyager 2009 2.8 CRD, engine management light coming on, the code coming up is tcm power signal too high, relay keeps clicking, changed gear box oil and filter oil was ok


Go under the vehicle and clean the ground strap that is shared between the TCM and starter. Occasionally, the brake switch can cause this issue, if it's sticky or slow to spring back. Clean the ground connection first and be safe... disconnect the battery before you do. (This will also clear the codes for you.) Have a nice day!

Aug 14, 2017 | Chrysler Cars & Trucks

1 Answer

2001 CRD Grand Voyager - clutch won't disengage.


Is there any fluid on the ground near the transmission? It's possible the clutch actuating cylinder has failed. If it was air in the line you would have noticed it the day you got it back. The master cylinder is on the firewall next to the brake master. You can add fluid if it's low. If it's empty then there may be a loose fitting or the bleeder screw on the actuating cylinder may be loose too.

Aug 09, 2017 | Chrysler Voyager Cars & Trucks

1 Answer

My rpm rev's past 3 car stalls then shifts...sometimes won't shift


Due for a transaxle rebuild,common on that veh

The fact you continued to drive it when it won't
shift correctly & has been slipping, your done

Aug 30, 2012 | 1998 Plymouth Grand Voyager

1 Answer

Gear box oil


my granddad has a voyager LX CRD, he has problems with getting the car into gear, as he says if you are lazy (cutting corners on the gearbox) it won't go into gear. we checked the gearbox oil and it was low and also it seemed that it was transmission fluid (for an automatic car) ALTHOUGH my granddads car was a manual. this is the one thing that chrysler don't come first for - Manual Cars
hope i helped you

Apr 15, 2012 | 2002 Chrysler Voyager

1 Answer

Changed water pump now 1998more plymouth grand voyager wont start


Check all your wires you removed. Obviously something is not connected. Check your ground wires first. When you have determined you have a good ground then check for power to the starter. If it cranks but won't start then you have disconnected something to the fuel or ignition system. If it ran before you changed the water pump then you have missed a connection somewhere.

Mar 24, 2012 | 1998 Plymouth Grand Voyager

3 Answers

Chrysler voyager clutch judder, have replaced clutch and flywheel but still judders mainly in reverse


You should flush the transmission out. Remember mopar uses high friction trans fluid and when this fluid gets somewhat old and looses friction then it will not operate properly.

Jun 19, 2010 | 2000 Chrysler Grand Voyager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...