Question about 2010 GMC Terrain

Open Question

How to remove panel on hatch door of gmc 2010 terrain

Need to access rear wiper motor

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

6ya.com

Download 6ya

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

  • 1986 Answers

SOURCE: 1986 gmc suburban door panel removal

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: how do you remove the rear side door panel to

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Oct 19, 2009

  • 82 Answers

SOURCE: 2004 GMC Envoy rear hatch complete door wont

door lock actuator solenoid ( inside of door) needs to be replaced

Posted on Mar 25, 2010

  • 1 Answer

SOURCE: 2004 GMC Envoy rear hatch complete door wont

I have this same problem currently...did you find anything out about it?

Posted on Nov 17, 2010

emissionwiz
  • 75005 Answers

SOURCE: 2005 GMC YUKON REAR HATCH ACTUATOR BUZZING

Check the ground to the actuator, if that is ok replace the actuator.

Posted on Aug 28, 2012

Testimonial: "QUICK RESPONSE"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i access the rear wiper motor of a 2011 equinox?
Remove the interior panel from the rear hatch door. check for voltage at the wiper motor, avoid overlooking a blown fuse or bad switch.

May 29, 2017 | Cars & Trucks

1 Answer

Location of wiper motor for 2010 gmc terrain
under hood on firer wall

Feb 27, 2015 | 2010 GMC Terrain

1 Answer

How do I change rear wiper 2010 gmc terrain?
take your finger or small screw driver pry small flat shiny piece that has a small bend on it prey that back a little. What that piece does is it sits against the shaft keeps the wiper from coming off your just prying it out enough so you can pull the wiper off. Some times these wipers have been on a long time you have to tap the lightly to free them up not to hard easy. also look at your new wiper that you bought you will understand it better. Hope this helps

Sep 23, 2014 | 2010 GMC Terrain

1 Answer

Panel remove
this link might help you: http://www.suzuki-forums.com/suzuki-forenza-reno-forum/29364-windshield-wiper-motor.html
Windshield Wiper Motor Suzuki Forums Suzuki Forum Site

Apr 28, 2013 | 2008 Suzuki SX4

1 Answer

2010 gmc terrain replace rear wiper
Wiper blade or arm? If you just need to replace the wiper blade it should just unclip from the arm. There is a small clip inside the blade if you look inside the arm as it loops around. Pry it inward to get it to snap out. Then just reinsert it the same way to reinstall

Jun 03, 2011 | 2010 GMC Terrain

1 Answer

I need to know how to remove the pannel cover on the rear hatch door I can get to the rear wipper motor
449b69b.jpg

Exploded view of the Explorer/Mountaineer rear liftgate trim panel (click for zoom)



Rear Window Wiper Motor

b5927f1.jpg

Fig. : Rear wiper motor assembly and related components

  1. Disconnect the negative battery cable.
  2. Remove the wiper arm and blade.
  3. Remove the liftgate interior trim.
  4. Remove the motor attaching bolts (3). Disconnect the electrical leads.
  5. Remove the wiper motor from the vehicle.
To install:
  1. Install the wiper motor in position and connect the electrical leads.
  2. Install the liftgate trim. Connect the negative battery cable.

I hope helps (remember to rate this).

Oct 11, 2010 | 1996 Ford Explorer

1 Answer

Rear windshield wiper connection
You need to open the rear glass from the rear hatch. Look inside where the glass latches to the rear hatch. There is a Phillips head screw that connects the rear inner plastic panel to the rear hatch, remove this screw. Now, in the strap that you use to pull the rear hatch down, there is a torques head screw, that holds this strap to the rear hatch, you need to remove this screw.
Start at one of the outer corners of the inner plastic panel and pull the panel away from the hatch. You will see the upper wiper motor in the right hand corner of the hatch. ther is one connector that is easy to see, you have to pull up on a plastic clip to remove this connector. Look for the rubber hose for the windshield washer fluid, it may be cracked or fallen off the plastic nozzle to the outside of the rear door.
Please the hose back on or replace the hose if it's cracked or damaged by the wiper motor. To install just follow the procedure in revers.
Good luck and hope i made some sense. Keep me posted, be glad to help out.

May 29, 2009 | 1999 Chevrolet Blazer

2 Answers

How do you gain access to rear wiper motor on a 1997 Jimmy As of now when motor is turned on, it makes a clicling sound and shaft does not move.
the wiper motor is connected to a actuating then to the wiper and one of the them has come undone. To remove pop back hatch look at outside edge for small screws if none are seen place large screwdriver between kick planel and metal and gentle pull and remove from vehicle exposing motor. If clip break you can get most from local parts stores later

Apr 01, 2009 | 1997 GMC Jimmy

1 Answer

2000 Honda Odyssey rear wiper motor replacement
You are probably correct in thinking its the wiper motor. You can do this but you will need to remove all the interior trim from the rear hatch first. Get a trim clip removal tool at a parts store...it will work much better than just a flat blade screwdriver. You'll have to remove the trim panels starting in order from the top of the door, then the left rear window side trim, then right rear window side trim, then the grab handle, and finally the main rear hatch trim panel. Once inside, removing and replacing the rear wiper motor is easy. You'll start by lifting the cover on the wiper arm retention nut. Remove this nut to get the wiper arm off, then remove the nut under neath which is the motor shaft mounting nut. Now, back inside to remove the other 3 motor mounting bolts. Don't forget to disconnect the connector for the motor wires. Reverse steps to replace.

Mar 29, 2009 | 2000 Honda Odyssey

1 Answer

Rear Wiper Quit Working
It is the Motor. This is a VERY Common GM Problem that they have not Fixed since 1990. You will need to remove the Rear Door Panel to Access the Motor.

Jan 20, 2009 | 2005 GMC Yukon

Not finding what you are looking for?

View Most Popular

2010 Terrain

  • Cars & Trucks

Related Question

How do i access the rear wiper motor of a 2011 equinox?

  • Cars & Trucks

Open Questions:

0 Answers

Where is the crank sensor located on a 2010 terrain 2.4!

Mar 29, 2015 | 2010 GMC Terrain

0 Answers

how to install on a 2010 GMC terrain

Mar 10, 2015 | 2010 GMC Terrain

0 Answers

Why does ac only blow hot air? Refrigerant level is correct

Mar 07, 2015 | 2010 GMC Terrain

0 Answers

Take apart the shift lever for repair on a 2010 GMC Terrain. Seems to be a bad wire conn. In there for the manual shift. Thanks Just want to no how to take apart the no-serum clips or whatever so I don,t break any clips.

Mar 06, 2015 | 2010 GMC Terrain

See all 2010 GMC Terrain Questions

2010 GMC Terrain Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

GMC Terrain Cars & Trucks

GMC Terrain Cars & Trucks

2010 GMC Terrain

2010 GMC Terrain

2011 GMC Terrain

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...