Question about 1994 Dodge Intrepid

1 Answer

94 intrepid won't start. how many terminals at the pump should have power.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 147 Answers

One. Check pressure first it is easier

Posted on Apr 04, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't my 1995 dodge intrepid start? I charged battery and it gets power to lights and everything but will not turn?


if the engine is not turning over you may have a bad starter. there should be power(battery voltage) on the large wire(terminal) at the starter at all times. on the small wire(terminal) you should have battery voltage only when someone is trying to start the car. if you do you can try to tap the starter with a hammer with someone trying to start the car, if it starts then you need a starter.

Jul 29, 2014 | 1995 Dodge Intrepid

1 Answer

I have a 03 Hyundai accent I just replaced the fuel pump I have no power to the fuel pump I've checked the fuses and the fuel pump relay it won't start I'm not sure what to do next


Do you have a test light? If not, go buy a cheap $5 test light-one with a lead to clip to a ground, and with a needle type probe.
Pull the fuel pump relay out of the terminals it is plugged into-you need to check if the power feed for the pump is still available at the relay. Clip the test light lead to a ground and touch the test probe to the positive battery post-to check that your ground is good- tester should light up. Now touch the probe to all of the terminals that the relay plugs into. One terminal should have power with key off. If no terminals have power, you have lost the power feed for the pump. Double check all your maxi fuses in the power distribution box. Either a maxi fuse or a fusible link will be the power feed for the fuel pump relay.
If the power feed is there at the relay, try a new relay. If still no pump, a shop will probably have to check your fuel pump circuit.
Did you check for power at the fuel tank while the key was held in crank? When the engine is cranking, the fuel pump wire should have power. When the key is turned to on, the fuel pump should have power for about 2 seconds, to pressurize the fuel system. Then when key is turned to crank or start, the fuel pump should stay on.

Sep 07, 2013 | Cars & Trucks

2 Answers

My 94 Thunderbird won't start until like the 4th crank, then it runs like a champ. It acts like it isn't getting any fuel. Please help!


You may be right on your hunch.
The fuel pump gets power from the pump relay for 3 seconds when you turn the key on, then no power until the engine starts. If the fuel pressure is low it could take several trys to get the pressure up to normal and the engine start.
A mechanic would check the pump relay and the fuel pressure with a gauge before and after cranking the engine.

May 29, 2013 | Cars & Trucks

1 Answer

Repacing fuel filter on 1996 intrepid


1) Relieve the fuel system pressure by first removing the fuel pump relay from the Power Distribution Center. Then, start the engine and let it to run until it stalls. Try starting it again and allow it to run until it stalls. Continue restarting the engine until the car will no longer start. Turn off the ignition.
2) Disconnect one electrical connector from an injector. Use an alligator clip to connect an end of a jumper wire to either injector terminal. Connect the other end of the jumper wire to the positive side of the battery. Then, connect an end of a second jumper wire to the other injector terminal. Very briefly touch the other end of the jumper wire to a ground.
3) Locate the fuel filter, which is part of the fuel pressure regulator mounted on the fuel pump module. Disconnect the negative battery cable, then lower the fuel tank. Disconnect the fuel lines from the filter.
4) Remove the fuel line from the pressure regulator. Remove the filter/regulator by pushing in on the locking tab on the filter as you turn the regulator to unlock it. Then, pull it straight up.
5) Push the new fuel filter into the fuel pump module. Turn to lock it in place. Connect the fuel lines, and then you can reinstall the fuel tank. Check for leaks when you start the engine on your Dodge Intrepid.

Parts Of BMW.





May 30, 2012 | 1999 Dodge Intrepid

1 Answer

1992 Plymouth Grand Voyager won't start, fuel pump runs for about 1/2 second when you turn on the key


The power control module sends signal to the fuel pump relay, it gets it's signal from the pick up coil in the distributor and the crankshaft position sensor. I'm having the same issues with my 94 Jeep Wrangler

Apr 23, 2012 | 1992 Plymouth Grand Voyager

1 Answer

94 gmc sierra 4.3 v6 manual, won't turn over, can hear fuel pump start when accessories turned on..won't fire, girl who needs help


The first thing I would check is fuel pressure. This type of fuel injection requires a minimum fuel pressure in order to operate. If fuel pressure is as little as one psi below minimum the vehicle will not start. You can try squirting a couple of shots of carb spray into the air snorkel while somebody cranks the engine over. If the engine starts and then dies you now you fpdeffinetely have a fuel issue. If the engine still won't start check for spark. Let me know what you find. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 07, 2012 | GMC Sierra Cars & Trucks

1 Answer

I Have a 94 cherokee country with a 56028297 ecu,it has no power at the grey wire at the ecu,it does flash sometimes and I can hear the relay work sometimes. I can bypass the fuel pump relay circuit and...


If you hear relays clicking sometimes and the jeep won't start, at those times, is the check engine light illuminated on the dash, or not? If no check engine light is on the dash, at times when the jeep won't start, your ecu is in need of repairs. The ecu sends power to the ignition and fuel relays and when the ecu starts to malfunction, the relays usually start clicking.

May 11, 2011 | Jeep Cherokee Cars & Trucks

2 Answers

My girlfriends car is a 94 Dodge Intrepid. It


Check if catalitic converter is plugged

Jul 23, 2010 | 1994 Dodge Intrepid

1 Answer

94 dodge intrepid wont start


clicking in the fusebox? And the starter could be because you need a new one. or a rebuilt. The clicking is your starter cylinoid.

Aug 26, 2009 | 1994 Dodge Intrepid

1 Answer

How to adjust timing for 94 dodge intrepid


1st the belt must ALWAYS be replaced when the water pump is done or anytime the belt is distrubed, here are the only instructions I could find on the belt replacement.
http://www.allpar.com/fix/timingbelt35.html

Jun 18, 2009 | 1994 Dodge Intrepid

Not finding what you are looking for?
1994 Dodge Intrepid Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...