Question about 1990 Chrysler New Yorker

1 Answer

I had the car in over drive but when i took off at the light it was getting gas but didnt want to go.

I coast into gas station turned it off and let it set waited 15 mins turned it back on and it was fine.

Posted by on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Had this problem with 3.0L -was distributor reference sensor inside distributor.

Posted on Jul 03, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Just shuts off...problem continues

my mom has a 99 durango that did the same thing it would just stop running and would turn over but wouldnt start let it sit for a while then it would start right up it turned out to be the brain of the car the ecu dont know if this will help but its worth a shot

Posted on Sep 03, 2008

  • 32 Answers

SOURCE: car will be running just fine i ll stop to get gas

Sounds like the problem is with the battery, probably bad connections with the cables. Clean the cables and posts. If this does not do it, you probably need a new battery. Other possibilities are bad starter brushes or a bad starter solenoid.

Posted on Apr 22, 2009

  • 1 Answer

SOURCE: 2000 sebring dies while driving

check the tire pressure maybe low causing the car to drag and stall

Posted on May 23, 2009

  • 6 Answers

SOURCE: Transmission works fine in N & R, but not in Drive.

old transimstion fluid and you have sludge and probably all kinds of junk it it i suggest a complete cleanout fair shop will ask around 1000 for the job

Posted on Aug 01, 2009

  • 4044 Answers

SOURCE: I was driving my 2005PT

Sounds like a stretched timing belt issue or a cam sensor going out. You should replace the timing belt if you have over 50k miles on the vehicle and have the cam sensor tested. it is better to replace the timing belt before it breaks than to wait. Even though the engine is supposed to be a no contact engine meaning the valves can't contact the pistons I can tell you from experience, if that timing belt breaks while the engine is running you will have to have the head rebuilt and it will cost a lot more to get the belt replaced.

Posted on Nov 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2000 Oldsmobile Alero, and yoday I stopped at a Cheap gas station for gas, and I didnt even drive it a block, when it started running REAL ROUGH, chugging, and stalling. And it even died. I got it...


Check or replace all your fuel filters. Check for water in your fuel. Drain your tank and replace with 93 octane fuel. Also check your spark plugs.

Aug 07, 2013 | Cars & Trucks

1 Answer

2001 jeep wrangler hesitating and stalling out...feels like it is not getting any gas and is running very rich


take it to an accredited service center and have the fault codes read
guessing just costs money and seldom fixes the fault

Apr 29, 2017 | 2001 Jeep Wrangler

1 Answer

Was headed to gas station ran out before gettin there so i let it coast to the gas station put gas and car didnt want to turn on,2004 dodge neon thanks 4 ur help


turn the key on and off 3 times, wait a few seconds between doing this, it will give the fuel time to pump to the front of the vehicle and also build up the pressure it needs to start ( when turning the key on, Just turn it to the On position, Not all the way to the Start position

Jul 28, 2011 | 2004 Dodge Neon

1 Answer

I had my car running at the gas station and it just shut off i tried nto jump it but that didnt work i checked my oil and it is black how do i know if the engine is locked


To check if the engine is locked up you will have to remove the drive belt and try to turn the crankshaft pulley. Did you notice if the battery light came on at all before the car died?

Jan 21, 2011 | 2002 Ford E250

2 Answers

Hi, I have an 1989 Isuzu longbox with an automatic transmission. The truck has been running perfectly. Driving down the highway it lost sputter as if running out of gas (I was very low). I coasted into a...


The gas in the tank actually provides cooling to your fuel pump.My best guess is that you ran low on fuel and the pump (which could have been marginal) has had it due to overheating.You will have to get the fuel system pressure checked to be sure or remove the main fuel line and see if fuel comes out.Have a bucket ready just in case.Good luck

Oct 25, 2010 | 1989 Isuzu Pickup 2WD

1 Answer

Check engine light/stalled


you need to get the code checked first . If it is on when the engine is running . it does come on for a bulb check when first started then goes out . any parts store can check the code for free recommend auto zone

Apr 22, 2009 | 2003 Hyundai Santa Fe

Not finding what you are looking for?
1990 Chrysler New Yorker Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...