Question about 2005 Dodge Grand Caravan

1 Answer

2005 dodge grand caravan hazard lights cam - 2005 Dodge Grand Caravan

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 1,326 Answers

Bad switch

Posted on Apr 19, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
bunnydawg
  • 5158 Answers

SOURCE: 2005 dodge grand caravan 3.3

read this page

http://en.allexperts.com/q/Chrysler-Repair-807/2008/5/EGR-code-po406.htm

Posted on Jan 24, 2009

SOURCE: Dodge 2005 Grand Caravan water Pump replacement

JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.

GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.

Posted on Apr 29, 2009

  • 14036 Answers

SOURCE: 2005 dodge grand caravan getting code p0406

3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .

Posted on Jul 04, 2009

  • 7 Answers

SOURCE: 2005 dodge caravan engine light code p 441

If you mean code P0441 - This Relates to Incorrect Purge Flow for Evaporative Emission System

Posted on Aug 16, 2009

  • 262 Answers

SOURCE: 2005 Dodge Grand Caravan. Code check

Cycle the key on, off, on, off. on. Then count the flashes 12 is normal 55 is end of sequence

Posted on Feb 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 grand caravan hazard lights wont flash. All bulbs are good. Blinkers work


It's controlled electroniclly by the BCM - body control module ! Your best bet , take it to a qualified repair shop .

Nov 21, 2016 | 2005 Dodge Grand Caravan

1 Answer

1998 dodge grand caravan emergency flashers & turn signals do not work


Sounds like the turn signal flasher (lighting control module). It is used for both the turn signals and the hazard flashers. There is one type for cars with DRL and one for cars without DRL.

a284d9fb-a87d-4547-bdc3-951fd78e5e08.jpg

Jan 17, 2015 | 1998 Dodge Grand Caravan

1 Answer

2005 dodge grand caravan wont start it cranka over


Hate to tell you but most likely your timing chain either broke or slipped, it could be cam or crank or both sensor

Oct 20, 2014 | 2005 Dodge Grand Caravan

1 Answer

2005 Dodge Grand Caravan. Code check


Cycle the key on, off, on, off. on. Then count the flashes 12 is normal 55 is end of sequence

Feb 06, 2010 | 2006 Dodge Grand Caravan

1 Answer

Reset ''Service Vehicle'' message in 2005 Dodge Caravan


WHEN SERVICE VECHICLE LIGHT COME ON.THE DEALERSHIP HAS TO CHECK OUT EMISSION CONTROL SYSTEM.MAKE SURE ALL EMISSION COMPONENTS IS WORKING PROPERLY.THEN THEY HAVE TO RESET SERVICE VECHICLE LIGHT WITH A SPECIAL SCANNER.

Oct 16, 2009 | 2005 Dodge Grand Caravan

2 Answers

2005 Dodge Grand Caravan SXT Malfunction


I have Dodge caravan 2010 and my falfunction light is on,what do i do?

Oct 13, 2009 | 2005 Dodge Grand Caravan

Not finding what you are looking for?
2005 Dodge Grand Caravan Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...