Question about 2011 Hyundai Sonata
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The 4L30E transmission is a "sealed" unit and as such does not have a
dipstick. The only way to check your fluid level is to use the "higher"
of the two drain holes on the bottom of the pan. You *must* do this
while the engine is hot and running, otherwise all the fluid will have
drained to the pan and will come out of the top hole all over you.When
hot, the fluid should come up to the top hole. Stick a finger in, if
you can't feel fluid, use a syphon or hand pump to shoot some up into
it. I would strongly suggest dropping the pan and
replacing the filter if you have over 100k miles. DO NOT have
this trans flushed at a shop as the small galleries are prone to
jamming with the gunk the flush will free up, and will cause the trans
Posted on Apr 26, 2009
Your transmission is sealed and has no dip stick, checking the fluid level properly involves using a factory scan tool.
Posted on Apr 26, 2009
THE DIPSTICK WAS ELIMINATED AND TUBE WAS CAPPED OFF..DEALER HAS SERVICE DIPSTICK TO CHECK FLUID LEVEL..A TRANS SERVICE SHOP MAY ALSO HAVE THIS TOOL
Posted on Jul 19, 2009
Disconnect the battery.remove the front tires.disconnect the lower control arms from the hubs.Remove the axle nuts.Swing away the hub until it clears the end of the drive axle spline.Keep it to the side.Remove the drive axles. remove the starter.remove the torque converter bolts on the flywheel.disconnect the gear linkage and all electrical connectors.disconnect the transmission cooler lines. undo the transmission mounts. use a transmission jack to lower the transmission.Installation is the reverse of the above.Be sure to torque all bolts and nuts to spec,pre load the mounts and replace the cotter pins with new ones.it should take about 5 hours to re and re the transmission.
Posted on Apr 13, 2010
IF YOU ARE NOT FAMILLIOR WITH IT TAKE IT TO A SHOP.There is one and it is a very messy job you have to take trans pan off to drain fluid (tricky) and the filter is under the pan.
Posted on Apr 14, 2010
Tips for a great answer:
Sep 27, 2016 | 2011 Ford Taurus
Mar 21, 2016 | Hyundai Cars & Trucks
Jan 01, 2016 | 2009 Hyundai Sonata
Jul 19, 2014 | 2012 Hyundai Accent GS 4dr Hatchback 1.6L...
Jul 01, 2012 | 2011 Hyundai Sonata
Jun 06, 2011 | Hyundai Sonata Cars & Trucks
Dec 29, 2010 | 2009 Hyundai Sonata
Nov 14, 2010 | Hyundai Motor 2002 Sonata
Nov 07, 2008 | 2006 Hyundai Sonata
26 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: