Question about 2005 Chevrolet TrailBlazer
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
yes you have to drop the tank. you will also need a fuel line tool to unhook the fuel lines. before you drop the tank see if tou can reach and wiggle the electrical connection on the top of the tank. these pumps have a pigtail issue. please rate
Posted on Dec 08, 2008
When the ABS light is on when driving there is a problem in the anti lock brake system and you will need to have it tested to find out what the problem is. As long as the light is on the ABS has been shut off by the computer until it is repaired. There could be problems with one of the wheel speed sensors, wiring or the ABS pump. On some vehicles the red brake light will come on too.
Posted on Jan 28, 2009
Raise vehicle up on jack stands so that the stands are under the lower controll arms and the suspension is "loaded" Remove the front tire(s) (if you break the torque on the nuts while the wheel is still on the ground it helps, but do not loosen them completely as you will be looking for new rims and wheel studs too). Place a drift or some other suitable object in one of the brake rotor vanes so that it will hit the brake caliper and stop the rotor from moving and remove the CV shaft nut (it's a big ****** make sure you have the right socket on hand before getting to this point). Next remove the brake caliper and rotor then undo the wheel bearing retaining bolts and remove the wheel bearing. This should give you enough room to move the axle shaft back and up so you can work on the ball joint. If you've had ball joints replaced before just unbolt the ones that are installed and using a pickle fork, or a block of wood and a hammer, drive the ball joint stud from the knuckle. (make sure to support the upper control arm so it doesn't drop down on you when you do this) If you are working on original ball joints then I reccomend placing a block of wood or something else that will protect the cv boots from drill bits ect and drill out the rivets holding the ball joint in place. then remove in the same manner indicated in the previous paragraph. installation is pretty much the reverse of removal and don't forget to torque your cv shaft nut I have a 1999 and the manual specs 103FTlbs... This is a critical torque as it helps preload your wheel bearing. Too high and you'll burn them up, too low and they'll be loose and wear out.
Posted on Oct 08, 2009
Testimonial: "Thank you for your directions this will help very much."
Tips for a great answer:
Dec 27, 2015 | Cars & Trucks
Jul 16, 2012 | 2005 Chevrolet TrailBlazer
Feb 21, 2012 | 2003 Chevrolet TrailBlazer
Oct 30, 2011 | 2004 Chevrolet TrailBlazer
Jul 11, 2011 | 2003 Chevrolet Trailblazer Ext
Mar 08, 2011 | 2004 Chevrolet Blazer
Jul 06, 2010 | 2007 Chevrolet Silverado 1500 2WD
Mar 05, 2010 | 2004 Chevrolet TrailBlazer
Dec 14, 2008 | 2002 Chevrolet TrailBlazer
39 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: