Question about 2000 Chrysler Cirrus

Open Question

2000 cirrus on the dash where it shows you what gear you are in they all have squares around them it goes in drive and reverse but it want shife out of first and the speedometer doesn't work

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 42 Answers

SOURCE: 2000 toyota camry check engine

wires are pinched and shorting together near the left (drivers side) trunk hinge. brake light power is feeding back through the reverse light wiring. this will also turn on the check engine light with a neutral safety switch malfunction code as the computer also sees this voltage in the reverse light circuit. Find and repair the wiring, pull the EFI fuse in the panel under the hood to clear the code. Hope this helps

Posted on Dec 28, 2008

Ad
  • 16 Answers

SOURCE: 2000 ford windstar speedometer and odometer problem

Could be a ciggerette lighter fuse, usually cause this when it blows.

Posted on Aug 21, 2009

  • 10 Answers

SOURCE: Transmission shifter is "frozen" it won't move

It's a fuse issue. Part of the shift interlock system.

If the radio is also not working, it's the cigarette lighter fuse. This one fuse controls the cigarette lighter, the radio, and the shift interlock system. It's in the kick panel fuse box on the driver's side.

If it's not that fuse, it's the "Stop" fuse in the same panel. Both blown fuses create the same behavior.

Easy fix! Don't bother with a mechanic. If the fuse continues to blow, take it to be checked.

Good luck.

Posted on Nov 02, 2009

CPU solution
  • 164 Answers

SOURCE: 2000 Toyota Camry instrument panel gauges not working

check the fuses in your manual it will tell you which fuses are for the dash and replace them it sounds to me like they are blown! good luck

Posted on Jan 09, 2010

  • 1 Answer

SOURCE: 99 chrysler cirrus lxi won't shift out of 2nd, no speedometer

Had the same problem on my 1999 cirrus lxi. Replaced the output speed sensor on the tranny and topped off the tranny fluid... cleared the check engine light and the cirrus ran great. Caution...the output speed sensor reqires removal of the front left tie and plastic weatherproofing to replace. once you find it's locvation, the replacement is relatively easy.

Posted on Jan 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 cirrus want change gears goes in drive and reverse inside on the dash where it tells you what gear you in all has squares around them speedometer doesn't work


Sounds like a speed sensor, I will look into that, but if the speedometer isn't working, its either cable, or electronic. Being a 2000, I'm guessing electronic. Chrysler have a lot of electronics on the transmission, as they are electronic themselves. I had an alternator go bad and my battery died, and the car wouldn't shift, it actually down shifted while driving. Have your battery and alternator checked first, then sensors. Like shift silinoid, speed sensor etc.

Apr 04, 2015 | 2000 Chrysler Cirrus

1 Answer

Landcruiser amazon 2000 diesel 4.2 was driving today and all of a sudden the vehicle was in D for drive and was showing first gear on the dash, and wouldnt drive over 20mph and wouldn't change


the tcm. (trans control module) has detected a fault in the transmission. it won't change because its in limp home mode.
the vss sensor may have failed. let the dealer or transmission shop run a scan tool on it.

Oct 19, 2014 | 2000 Toyota Land Cruiser

1 Answer

Why won't my 1998 chrysler cirrus shift into gear?


I'm not familiar with YOUR Chrysler, BUT... my brother' father-in-law had a Buick [about 1998 model] that would NOT shift into any gear UNLESS the brake pedal was FULLY DEPRESSED!!!!!

I could move the shift lever into any of the indicator positions, but the transmission would not engage if my foot was not firmly on the brake pedal while selecting a gear position!

Sep 03, 2014 | 1998 Chrysler Cirrus

1 Answer

My 2008 colt automatic has intermittent problem not going into reverse gear what is it ?


Keeping brake pedal down, move gear lever into drive, back to neutral and into reverse, give it a couple of seconds between movements. Last resort is to switch engine off and restart.

Jan 25, 2013 | 2006 Mitsubishi Colt

1 Answer

Doesnt want to go into gear (drive or reverse) when it is cold outside - after perserverence and a few attempts it will go into gear


a trans service will take care of this problem. condensation in the fluid can crystalize and plug the filter causing the pump to starve

Feb 18, 2011 | 2000 Chrysler Cirrus

1 Answer

I have a 1999 silverado z71 4wd, everything was working fine, until i was fooling around and i was in drive rolling to a stop, then shifed into reverse to backup and hit the gas to hard- but it just rev'd...


If you check again, you are likely missing 2nd and 4th gears, as well as reverse. This is because you have either stripped the spline out of the reaction shell or broke the spline off of it. This failure is very common, and when you put it in reverse as you did, you just helped it fail sooner.

Jan 19, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

2000 Chrysler Cirrus: I was just informed by my


I'm reading the instructions at autozone.com, and I don't see anything about removing the dash. You do have to pull out the trim around the control unit and unscrew the unit to get to the back of it, but I don't see why you can't get to all the cables and doors by sticking your head under the dash. If I were you, I would do it myself. This would be about a 1 hr job for me. Maybe a little longer if I was new at it...let me know if you want me to copy the instructions and send them on.

Sep 10, 2010 | 2000 Chrysler Cirrus

1 Answer

How long do i run my 2000 chrysler cirrus 2.4 liter till the evap sensor is ready for emissions


most cars u can drive around 100 miles park the car then drive it to the shop the next day and be ok

Mar 14, 2010 | 2000 Chrysler Cirrus

2 Answers

2000 toyota camry check engine light. trac light on. when i step on breaks reverse square indicator on dash board goes on. No reverse lights and rear light indicator on.


wires are pinched and shorting together near the left (drivers side) trunk hinge. brake light power is feeding back through the reverse light wiring. this will also turn on the check engine light with a neutral safety switch malfunction code as the computer also sees this voltage in the reverse light circuit. Find and repair the wiring, pull the EFI fuse in the panel under the hood to clear the code. Hope this helps

Dec 27, 2008 | 1999 Toyota Camry

1 Answer

2000 Chrysler Cirrus engine jerking while in reverse, drive and also while sitting in driveway. Seems like while in drive/reverse car wants to shut down. Check Engine light on, was flashing for a minute...


the valve cover gaskets were leaking oil around the spark plug boots making the boot swell and causing a voltage leak. the engine misfired and stop lights. i did a tune up with new cover gaskets,plugs, wires, cap and rotor and she runs like a top. vrooom, vrooom!!

Dec 12, 2008 | 1996 Chrysler Cirrus

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...