Question about 2005 Toyota Sienna LE

1 Answer

During running the car, it's turned off, then after 10 to 20 minutes can turned on again. Then repeated the same issue multiple times

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Toyota Master
  • 1,848 Answers

-Run until it shut down then check spark. sounds like ignition
problem.

Good Luck
Mai

Posted on May 18, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 dodge Dakota 4.7 liter multiple misfires have set the timing 2nd time runs good for 5 minutes then it starts to misfire again


A leak down test is needed. If everything else has be checked. This will verify valves didn't cause damage or head gasket is ok. Common issue with early 2000 dodge trucks.

Apr 15, 2016 | Dodge Cars & Trucks

1 Answer

2001 kia rio


It can be a fuel problem or a distribution problem.

Aug 11, 2008 | 2001 Kia Rio

1 Answer

Hyundai 2003 sante fe starting problem


Check all battery and ground connections and clean them.You may have a bad relay or starter also.

Feb 17, 2013 | 2003 Hyundai Santa Fe

1 Answer

1997 chevrolet suburban with 7.4 engine will not start after being turned off without waiting 10 minutes.


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Feb 27, 2012 | 1997 Chevrolet Suburban

1 Answer

Warning light check engine light turns on, sometimes after 10-20 minutes drive. The engine is perfectly OK. Indicator light is off after the car has "rested" during the night.


You may have a sensor malfunction. Have a mechanic run the codes and see if there are any stored in the computer. Just because the engine runs OK now does not mean it will continue to do so. The reason the light goes off after the vehicle has set over night may be due to the vehicle not sensing the issue after the long passage of time, until you begin driving again.

Nov 28, 2011 | Cars & Trucks

1 Answer

I have and oldsmobile 2000 intrigue. i changed the computer and now it wont crank when the key is turned and also the security light is flashing constantly how do i reconcile the new computer to the car?


There is a simple procedure for this.
First of all (and VERY IMPORTANT) is to connect the vehicle to a battery charger. Leave the battery charger on during this entire process.
This procedure takes approximately 30 minutes . Make sure the battery is fully charged before proceeding.
  1. Turn the ignition switch off.
  2. Turn the ignition switch all the way from the off to the start position, then leave it in the on position.
NOTE: The engine will not crank.

  1. The SECURITY will come on and stay on for at least 10 minutes . When it goes out, proceed to step 4.
  2. Turn the ignition switch off for five seconds .
  3. Repeat steps 2, 3, and 4 again for a second time.
  4. Repeat steps 2, 3, and 4 again for a third time.
  5. Turn the ignition switch off.
  6. Turn the ignition switch all the way to the start position. The engine should now start.

Oct 20, 2010 | 2000 Oldsmobile Intrigue

2 Answers

My Saturn has been sitting in my driveway for about a year and a half. We just replaced the battery and the fuel filter and when I try to start the car, the engine turns over, starts for a minute, and then...


If the gas in tank is that old you need to drain it. Once you have good new,clean fuel in tank. Turn key to run position,(do not energize starter just want red lights on dash to come on) listen for fuelpump whine. It will shut off. Turn key off.Turn key to run again, listen for fuelpump again. Turn off key again. Repeat this procedure total 5 times. On last time turn key to engage starter. It should build up enough pressure & fuel & start right up.

Jul 01, 2010 | 1999 Saturn SL

1 Answer

2003 chev suburban.battery went dead.replaced battery,now it wont crank and security light blinks


I have ran into this problem many times. Insert the key, and turn it to run. After 10 minutes the security lamp should go out. Turn the key off, and then back to run and let it sit another 10 minutes until the security lamp goes out again. Now repeat this one more time for another 10 minutes until the lamp goes out again. This should be a total of 30 minutes so make sure your battery is fully charged when you start the procedure. After the third time and the lamp going out you should be able to restart the vehicle.

Jan 17, 2010 | 2003 Chevrolet Suburban 1500

4 Answers

Can't start my 1998 3.1 Monte Carlo


You have a Pass lock problem. There are 3 wires from the Ignition switch that reads the ignition key, if you have lot's of other keys on your key chain. That puts extra stress on the ignition lock switch, which in turns wear out the wires in the lock that reads the key.
The dealer will cost over $500.00 to replace the lock and key's to match. I got a good friend at a lock smith to over ride the system by running a diode across the 3 wires, but now i have no pass lock.
Try this, it might help if the wires are ok, it's to reset the pass lock that the dealer will try and still charge you hundred of dollars since they want to change the lock and key's for you.
Good luck and hope this helps: The relearn process is pretty simple and will take 30 minutes, if it'll work for you at all since your problem doesn't sound like a computer issue.

30-Minute Learn Procedure
1. Turn ON the ignition, with the engine OFF.
2. Attempt to start the engine, then release the key to ON; the vehicle will not start.
3. Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF.
4. Turn OFF the ignition switch, and wait 5 seconds.
5. Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes.
The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch turn from OFF to Crank.

Important:
Turn the Ignition Switch OFF.
The vehicle learns the Passlock Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
6. Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password.
7. With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.
Without a scan tool you may have momentary starter interruptions while history clears itself.







May 25, 2009 | 2006 Chevrolet Equinox

2 Answers

Engine shuts down on deceleration


Well 145K is alot of miles, catera's are not that reliable especially after 100K. It sounds like you could have multiple issues but take it to a mechanic asap before it becomes unfixable.

May 23, 2009 | 1999 Cadillac Catera

Not finding what you are looking for?
2005 Toyota Sienna LE Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...