Question about 2003 Dodge Durango

2 Answers

How do I remove the rear wiper assembly from a Dodge Durango 2003?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Dodge Master
  • 773 Answers

Most Chryslers from this year band require removal of the rear door's liner to access the motor. The motor is held on by two or three compression nuts with bolts that pass through the motor housing/frame. NAPA has new ones or you can use simple nuts and use both metal and rubber bushings to prevent possible rattling noise after mounting a new motor. A car or your year it is best to go to a recycle yard and get the whole assembly for cheap so you don't need to disconnect the motor from the wiper arm linkages. It's not difficult. The wiper must be removed from the back of the car and the large screw underneath the rubber gasket removed as well. The rest of the removal/install process is done from inside the rear door, once the rear door panel is removed.

Posted on Apr 14, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 752 Answers

Hi Mark, I'm AL the owner of Big As Auto Repair

The wiper blade are sometime stuck because of rust, you'll need a puller to remove it. If you need further assistance go to my website. Click here:

Posted on Apr 18, 2015

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 217 Answers

SOURCE: getting rear gears out of the difential case 1999 dodge durango

  1. Raise and support vehicle. Ensure that the transmission is in neutral.
  2. Remove wheel and tire assembly.
  3. Remove brake drum. Refer toBrakes, for proper procedure.
  4. Clean all foreign material from housing cover area.
  5. Loosen housing cover bolts. Drain lubricant from the housing and axle shaft tubes. Remove housing cover.
  6. Rotate differential case so that pinion mate gear shaft lock screw is accessible. Remove lock screw and pinion mate gear shaft from differential case
  7. Push axle shaft inward and remove axle shaft C - clip lock from the axle shaft
  8. Remove axle shaft. Use care to prevent damage to axle shaft bearing and seal, which will remain in axle shaft tube.
  9. Inspect axle shaft seal for leakage or damage.
  10. Inspect roller bearing contact surface on axle shaft for signs of brinelling, galling and pitting. If any of these conditions exist, the axle shaft and/or bearing and seal must be replaced

Posted on Feb 11, 2009

  • 1 Answer

SOURCE: remove front axle from differential on 2003 dodge ram

That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings

Posted on Feb 15, 2009

  • 1392 Answers

SOURCE: How to remove rear wiper arm

Remove the nut holding the arm. Should be able to lift up on the arm and loosen the joint at the motor.

Posted on May 30, 2009

  • 1 Answer

SOURCE: 2003 dodge durango no headlights,no wipers ,no

Outkastroost, I had the same problem last year with my '03 Durango. It happened shortly after we installed a new stereo. The solution was to disconnect the negative battery terminal for about 30 seconds to reset the computer. It's been working fine for a year now after that. I hope this works for you, too.

Posted on Nov 11, 2009

  • 151 Answers

SOURCE: Can't remove rear wiper to replace on 96 caravan

Lift wiper arm from rear window. then release latch that holds the blade to the wiper arm.( It's small tab)

Posted on Jan 27, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Rear wiper motor how to remove it

The best way to remove it is to follow clear instructions using a Haynes Workshop Manual. I have bought these manuals for all of the cars I have owned over the years, they are a great way to plan how the repair or replacement will proceed and what tools you might require. They also prepare you for possible areas to wacth for when removing items to avoid injury to yourself or further damage to your car. All procedures are marked in 'number of spanners' to show the difficulty level involved.

I have replaced rear wiper motors in the past. It is fairly straightforward but The Haynes Manual will be the best $20 you spend.

Dodge Durango 2000 thru 2003 and Dodge Dakota 2000 thru 2004 Pick ups...

Apr 03, 2015 | 2003 Dodge Durango

1 Answer

Does 2003 dodge durango have just one fuse & relay that operates both front & rear wiper motors

No there is not just one ,the rear has it's own fuse an relay . Fuse J - 20a in ( PDC ) power distribution center , relay should be in same box ! sorry don't have location number , can't find it !

Mar 16, 2015 | 2003 Dodge Durango

1 Answer

My A/c Heater for my dodge durango went out including rear wiper andrear window heater, I have changed 10 amp fuse on left of instrument panel , but keep blowing out.

You are going to have to trace each wire down to see here it is shorting out at. Its not going to be fast but that is what has to be done.

Mar 05, 2011 | 2003 Dodge Durango

1 Answer

My rear wipers on my 2000 dodge durango dont work what possible problems could it be

check fuse, check wire connection to wiper motor , check wiper motor.

Oct 27, 2010 | 2000 Dodge Durango

1 Answer

Tips on replacing back spark plugs on 2003 3.3L Dodge Grand Caravan. Thanks

remove the wiper tub.

You'll need to remove,

the wiper arms
the plastic cowl cover
5 or 6 10mm nuts
4 or 5 13mm bolts
Unplug the wiper motor

And pop the whole assembly out. There will be a lot of room once it is out.

Oct 08, 2010 | 2003 Dodge Caravan

1 Answer

How do you replace a rear brake light on a 2003 durango

Take the trim off that covers the tail light assembly and then remove the bolts that hold it in.Once the tail light assembly is in your hand then unplug the lamp,turn the bulb to the right until it unlocks then pull it out,reverse all to assemble.Merry Christmas and good luck!

Dec 24, 2009 | 2003 Dodge Durango

1 Answer

Where do I place the jack on a 2003 Dodge Durango to remove the rear wheel

place the jack under the passenger door about 6-12 inches away from the wheel and about 6 inches in from the edge of the car. You just need to make sure it's on part of the frame. Do no jack it up via the wheel assembly or the undercarriage

Sep 14, 2009 | 2003 Dodge Durango

1 Answer

2003 Dodge Durango Rear Brake Assembly

could be the shoes have come off their backing... could be loose or worn hardware

Jan 21, 2009 | 2003 Dodge Durango

1 Answer

2003 dodge durango slt/no back wiper

could be both probably fuse unless there is a whining noise coming from the back when switched on check fuse box for burnt fuse

Dec 13, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
2003 Dodge Durango Logo

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides