Question about Cars & Trucks

1 Answer

Got a new red lion shallow pump hooked it up but would only run 10 secs got another one did the same thing checked with electrican to make sure power good is there a problem in the pump itself ?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 98 Answers

Pump should be connected or wired to its own circuit with no other outlets or equipment in the circuit line. Fuses and circuit breaker should be of ample capacity in the electrical circuit. THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER. If not properly wired it will throw the breaker. Here is a link to a troubleshooting guide. http://www.redlionproducts.com/media/31140/_the-red-lion-troubleshooting-guide.pdf

Posted on Apr 02, 2015

  • HawkLore
    HawkLore Apr 02, 2015

    Pump should be connected or wired to its own circuit with no other outlets or equipment in the circuit line. Fuses and circuit breaker should be of ample capacity in the electrical circuit. THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER. If not properly wired it will throw the breaker. Here is a link to a troubleshooting guide. http://www.redlionproducts.com/media/311...

  • Jerry Seipp
    Jerry Seipp Apr 02, 2015

    The pump internal overload switch shuts the pump off

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My everbuilt shallow well pump runs for about 2-3 minutes, then shuts off. The pump extremely hot. Comes back on after cools about 10 minutes. Just need to know if the pump is on it's last leg?


probably not
I suspect that the start/run capacitor has failed and the motor is overheating and the thermal overload is kicking in until it cools down and then allows it to restart
have an electrician check it out because if it is that ( $20>$ 40 to replace plus time ) is way cheaper than new motor

Dec 05, 2016 | Cars & Trucks

1 Answer

How to change out the fuel pump on 2007 dodge caliber


Easy!! Pull back seat out,,Tap retaing ring out with dull chisel and hammer,,Unhook lines,,Lift out pump (theres gas in it so tip it so the gas pours back into he tank)
Extra tip: BEFORE putting the new pump in,hook up the terminal and turn the key on to hear the pump run for 2-3 sec AND check that the sending unit is making the fuel gauge work!
Also be sure the retaining ring is tapped all the way in ,should be some marks on it. Likley you will spill a little gas around the tank too.

Nov 05, 2012 | 2007 Dodge Caliber SRT4 Hatchback

1 Answer

My husband has a 93 chevy s-10. the fuel pump went out at least thats what everyone believes. so we got a new relay, fuel filter. wire harness, and a fuel pump. we have put it all back together and the...


PROBLEM COULD BE THE WIRING, CHECK WIRING HOOK UP.MAKE SURE WIRING CONNECTIONS IN PLACE GOOD AND TIGHT MAKE SURE FUEL PUMP GETTING GROUND.IF WIRING OKAY.EITHER CAR HAS PCM PROBLEMS.

Jun 26, 2011 | 1993 Chevrolet S-10

1 Answer

Was running rough replaced fuel pump ran about 15 sec. died has'd started sence


Vortec? Make sure the parts store didn't sell you a TBI pump,14 PSI verses 50 PSI,
need to check fuel pressure

Oct 07, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

2500hd dies then starts and dies again


CHECK AIR FILTER FOR RESTRICTION. A BAD SUPPLY PUMP. OUT OF FUEL. BLOCKED FUEL RETURN LINE. AIR LEAK IN SUCTION LINE. RESTRICTED FUEL FILTER. INOPERATIVE FAST IDLE. LOW IDLE SPEED AND DEFECTIVE INJECTION PUMP.THIS IS A LIST OF THINGS TO CHECK.

Jul 25, 2009 | 2002 Chevrolet Silverado

1 Answer

1986Blazer 2.8 Not Starting


did you check for spark? sound like a ignition problem

Dec 03, 2008 | 1986 Chevrolet S-10 Blazer

2 Answers

Fuel pump?


This is almost for sure a connection problem, check the relay for the fuel pump.

Nov 25, 2008 | 1998 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...