Question about 2004 Volvo S60

Open Question

2004 have to take out steering column on s60 vovlo

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Changed steering column with another one , everything comes on but wont start.

Did you put the original anti-theft module on the new steering column ? Does yours have steering column mounted ignition switch ? Vehicles with steering column mounted ignition switches have the exciter integral with the theft deterrent control module (VTD) which is located within the steering column.

Aug 29, 2015 | 2004 Pontiac Montana

1 Answer

On a Volvo s60 2004 2.5 turbo what size with a serpentine belt if you bypass powner steering belt

call a auto parts place for the info as they should be able to tell you

Mar 13, 2015 | 2004 Volvo S60

1 Answer

Can't shift the gear in my 1999 vovlo S80

anti theft lock in the steering column or its not registering the brake pedal being depressed.

Apr 18, 2013 | 1999 Volvo S80

1 Answer

Volvo s60 rear brake lights stay on all the time any answers please.

There is a switch located above the brake pedal, this switch can be adjusted. It can be hard to see, climb under the dash, and look up towards the steering column, check the switch for proper operation.

Jul 10, 2012 | 2003 Volvo S60

1 Answer

Remove ignition switch for a 2004 kia optima

Ignition Switch Removal & Installation To Remove:
  1. Disconnect battery negative cable.
  2. Disarm air bag system.
  3. Remove driver air bag module.
  4. Loosen screw and lift horn pad to remove.
  5. Remove lock nut and washer. CAUTION
    Do not hammer on steering wheel. Damage can occur to the energy absorbing portion of the steering column.
  6. Pull dynamic damper forward and lift up to remove.
  7. Remove steering wheel.
  8. Remove steering column shrouds.
  9. Remove lower cover.
  10. Remove multifunction switch.
  11. Remove entire lower portion of dash.
  12. Remove mounting fasteners and lower steering column.
  13. Remove bolts and separate ignition switch from steering column.
To Install:
  1. Install ignition switch to steering column and install bolts.
  2. Raise steering column and install mounting fasteners.
  3. Install lower portion of dash.
  4. Install multifunction switch.
  5. Install lower cover.
  6. Install steering column shrouds.
  7. Install steering wheel.
  8. Install dynamic damper.
  9. Install washer and lock nut.
  10. Lift horn pad and install screw.
  11. Install driver air bag module.
  12. Connect battery negative cable.
prev.gif next.gif

Jul 17, 2010 | 2004 Kia Optima

1 Answer

Volvo S60 Fault code 045 What does this code mean???

Take your car, if possible to drive, to a local auto parts store. Here they should be able to perform a free (usually) diagnostics test which only takes a few minutes, and this will be able to tell you what the code means as far as which component or part needs service or replaced.

If you cannot drive the vehicle, write the code down and take it to a parts dealer and ask them if they can look up the code, or search and type in "troubleshoot codes for vovlo s60".

This should bring up a list of websites and services that will better help you resolve this issue.

Please let me know if you need further assistance.

May 08, 2010 | 2002 Volvo S60

1 Answer

Access fuse box.  I need to replace the cigarette lighter fuse on a 2004 vovlo v40 station wagon.  Do I need to remove the panel under the steering wheel? Is there more to it?  thanks!!

Open the drivers side door and there is a small plastic panel at the end of the dash. It has a little finger hole and some are a little tight. You should find the fuse box, diagram, fuse puller and extra fuses. If you have a back lighter, that fuse is in the back near the drivers side tail lights. You find it when you take the panel off to change rear bulbs. I think they have a separate fuse for everything.

John Sands
2001 S60 2.4T

Mar 25, 2009 | 2004 Volvo V40 Wagon

1 Answer


The C0474 code refers to a steering angle sensor located at or near the base of the steering column. Check where the steering column goes through the front of dash and verify the connector is fully seated and locked.
The sensor gets its voltage from the ABS module.
Let me know if it is clean, locked and seated. Make sure there are no pushed out or bent terminals on the connector.
Check this first and we can go from there.

Feb 18, 2009 | 2004 Saturn ION

Not finding what you are looking for?
2004 Volvo S60 Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides